HVAC

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have carrier furnace built in 2000 model CD5AXWO360Z1AAAA
I have carrier furnace built in 2000 model CD5AXWO360Z1AAAA it keeps giving code 14 which is ignition lockout or proving fault I did clean the flame sensor. Can you help ? … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
I have a Amana Air Command 80, Old. I keeps cycling on off.
I have a Amana Air Command 80 , Old. I keeps cycling on off. Fan keeps running. After it turns off a single red light blinks. I recently had to turn off the gas line at the meter to extend my existing… read more
Rick
Rick
HVAC Supervisor
28,917 satisfied customers
AMERICAN STANDARD FURNACE FREEDOM 80 SOMETIMES IT LITES AND
AMERICAN STANDARD FURNACE FREEDOM 80 SOMETIMES IT LITES AND OTHER TIMES IT DOESNT AND THE FAN KEEPS BLOWING COLD AIR I SHUT IT OFF AND RESET IT THE IGNITER GLOWS AND THE GAS VLVE CLICKS BUT NO FIRE UN… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,097 satisfied customers
I have a furnance in my mobile home. Model DGAA077BDTA and
I have a coleman furnance in my mobile home. Model DGAA077BDTA and we have a steady green light and one blinking red light which indicates a ignitor issue. Can someone assist?… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
I have a American Standard furnace Freedom 80 that is having
I have a American Standard furnace Freedom 80 that is having problems. It will firs most of the time, but sometimes it just blows cold air. It will eventually fire heat again. It works again if I also… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
Furnance won't stay fired up. , Sure. But bear with me
Sure. But bear with me as I'm not a HVAC tech! We'll turn on the furnance, the inducer motor fires up, the igniter glows, the gas fires up, the larger fan kicks on. Then after about 10 seconds or so, the gas cuts out, as does the larger fan. … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,097 satisfied customers
I have a code 14 on a bryant furnace due to a dirty filter.
I have a code 14 on a bryant furnace due to a dirty filter. I have replaced the filter, but I am still in lockdown. I can't seem to get it to fire up. What can I do? It is 2:46 am and its 30 degrees o… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,429 satisfied customers
Amana Air command 80 Heater. Blower turns on, Glow plug lights
Amana Air command 80 Heater. Blower turns on, Glow plug lights bright but 3 or 4 times a week I will not hear the slight click of the gas being fired. The glow plug will keep going bright then off unt… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
i got at home central heat +A/C.TODAY WHEN I turned the heat
i got at home central heat +A/C.TODAY WHEN I turned the heat furnace on, the electronic ignitor turned on than fire came for 10 seconds and stopped,and the ignitor went off.than [without me doing noth… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
I have a payne furnace model #ZIPG9Maa048100ADKA The glow
I have a payne furnace model #ZIPG9Maa048100ADKA The glow plug is only lighting up for about 7 seconds, and the furnace never fires up fully. what would the glow plug part number be? Is that my proble… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
We have a trane system with 2 zones and a clean effects filtration
We have a trane system with 2 zones and a clean effects filtration system. the blower is working but their is no heat. the system light is not indicating that heat is being called for and the red LED … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
Hello, I have tried to clean the flame sensor with embry,
Hello, I have tried to clean the flame sensor with embry, but I cannot get a flame. I've gone through and cleaned everything, replaced the fuse, etc, but I cannot get a flame. Is the ignitor bad? Do I… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
What is the cause formy Trane furnace trying to run, then shuts off?
My Trane furnace tries to run, then shuts off....the ignitor fires up and runs for about 30 seconds then it flames out. It happens several times before the blower kicks on because of the heat built up… read more
Daniel A.
Daniel A.
Vocational, Technical or Trade Scho
3 satisfied customers
I HAVE A GOODMAN 70,000 BTU 80% FURNACE, ABOUT 4 YEARS OLD.
I HAVE A GOODMAN 70,000 BTU 80% FURNACE, ABOUT 4 YEARS OLD. INTERMITTANT PROBLEM HAS NOW BECOME CONSTANT. FURNACE GOES INTO LOCK OUT AFTER TRYING TO FIRE 3X. WHEN CALLS FOR HEAT, INDUCER FAN STARTS, I… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
I have a Weather KING 90RJ series. The burnercomes on and
I have a Weather KING 90RJ series. The burnercomes on and the fan blows, but then the burners turn off after a minute or so. The furnace repeats this over and over but never reaches the thermostate te… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
I have a 2 years old gas furnace. GDS80703AZ. With the access
I have a 2 years old gas furnace. GDS80703AZ. With the access panel on, I can hear it call for heat, vent motor runs, fans kicks in high, ignitor lights for about 3 seconds and then goes out. Blower c… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
I have a Goodman 93% efficient furnace that short cycles the
I have a Goodman 93% efficient furnace that short cycles the gas burners. It cycles the vent on, starts the igniter, fires the burners and kicks on the blower but the burners only stay on for a short … read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have an Amana air command 80 GCI Furnace. The ignitor comes
I have an Amana air command 80 GCI Furnace. The ignitor comes on but the furnace will not fire. The diagnostic light blinks continually. According to the trouble shooting tips with my furnace it tells… read more
Mario
Mario
Owner Of At Your Service Plumbing & Heat
High School or GED
677 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

HVAC Expert

10,502 satisfied customers

Certified Mechanical Engineer and HVAC Expert with 30 years of experience

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less