HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
Second Opinion] Helping an elderly neighbor with a 50-yr old
Second Opinion] Helping an elderly neighbor with a 50-yr old Dayton 3E369 garage gas heater. Changing the ICU from Johnson G60QBG-1 to Robertshaw 780-715U but the wiring was disconnected and therefore… read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
I"m Rick, too. I have an old Hydrotherm HC 125b gas burner.
I"m Rick, too. I have an old Hydrotherm HC 125b gas burner. It went out last night. I hear the circulator pump running, but not getting spark to the pilot. I replaced the Honeywell S8610U control box,… read more
Rick
Rick
Supervisor
34,161 satisfied customers
I have aRobertShaw SP780 ignition module serving my garage
I have aRobertShaw SP780 ignition module serving my garage unit heater. As the heater has not been going on, I checked out the system to see that the pilot is trying to light but gas isn't getting thr… read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
I have a 13 yr old furnace, I installed myself. at this time
I have a 13 yr old furnace, I installed myself. at this time is not ignitor doesn't spark. I was told it was the ignitor and need to upgrade to kit #(###) ###-####(pilot ignitor module). My furnace mo… read more
V12Tech
V12Tech
252 satisfied customers
Working on 1989 model Heil "NRGF48FDBO 2" gas pac. I replaced
Working on 1989 model Heil "NRGF48FDBO 2" gas pac. I replaced the ignition module and in doing so pulled the wire loose from the TH-W spot on the module where it connects on the opposite end. Now I ca… read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
I got anew ignition control for Coleman Evcon Furnace Model
I got anew ignition control for Coleman Evcon Furnace Model # XXXXX It is a robertshaw Model #HS780 34nr-306a ignition the one on the furnace is aHoneywell where do I find a wireing diagram for the ro… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
13,836 satisfied customers
When converting from a Robert Shaw 735l (18G91) ignition con
When converting from a Robert Shaw 735L (18G91) ignition control module To a Honeywell 30W33 what do you do with the two wires from the TR and TH terminals… read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
My Lennox heating unit stopped to work. I replaced already
My Lennox heating unit stopped to work. I replaced already thermostat and pilot flame sensor, neither helped. Spark ignition and pilot works (constantly stays lit ), cold air fan and AC also work exce… read more
johnincolorado
johnincolorado
8 satisfied customers
I have a rheem gas furnace, and the electronic piolet stays
I have a rheem gas furnace, and the electronic piolet stays lite, but will not ignite the flame tubes, What is the problem??… read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
where can i obtain a troubleshooting manual for a robert shaw
where can i obtain a troubleshooting manual for a robert shaw 780-715-U ? I have one that fires my propane torches and the pilot light won't come on. I need to trouble shoot to see if it's the control… read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
I am replacing a Honeywell S8600M Ignition Control on a Rheem
I am replacing a Honeywell S8600M Ignition Control on a Rheem Power Vent hot water heater with a Robertshaw HS780 17NL-304A Ignition Control and the wiring terminals are different and I cannot find a … read more
THEFIXER1966
THEFIXER1966
High School or GED
14 satisfied customers
Lennox Furnace w/ Robertshaw controller. When heat is called
Lennox Furnace w/ Robertshaw controller. When heat is called for the pilot gas starts flowing and the pilot light is burning and the spark igniter continues to spark. After a little more time the cont… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
772 satisfied customers
HVAC - I have a Lennox furnace that will not ignite the burners
HVAC - I have a Lennox furnace that will not ignite the burners even though the pilot light is lit and working fine. In December I had problems with the burners cycling on and off. I replaced the flam… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
772 satisfied customers
Hello, Im replacing a Robertshaw sp715A with the Robertshaw
Hello, I'm replacing a Robertshaw sp715A with the Robertshaw HS780 34PL-308A... Some of the termianls are different and I have no instructions with the new uint. I tested the furnace with a working sp… read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
my hvac unit has a SP735A Ignition Control Unit. Ive been
my hvac unit has a SP735A Ignition Control Unit. I've been looking for wiring diagrams for this while i try to trouble shoot my unit. Im looking for what TR, PV, MV & PV stand for. Also should this un… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
I have a G11E-200V-3 furnace. It has a Robertshaw Model SP735L
I have a G11E-200V-3 furnace. It has a Robertshaw Model SP735L Lennox Part No.(NNN) NNN-NNNNboard. There is a pigtail 6 hole female jack, with only four prongs used, but it does not plug in anywhere, … read more
BARRY
BARRY
owner
Associate Degree
56 satisfied customers
I checked a heil furnace , M# is CUGI125AF01. The problem is
I checked a heil furnace , M# XXXXX XXXXX The problem is that the pilot flame will be on , but the main burner will not ,so the furnace doesn't work . I measured the voltage between MV and MV/PV , it … read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,041 satisfied customers
Replacing a Honeywell S8600C Furnace Ignition control with
Replacing a Honeywell S8600C Furnace Ignition control with a Robertshaw SP715A. The Honewll has the following terminals,MV, MV/PV, PV, GND (BURNER), 24V (GND), 24V, TH-W (opt), Sense, Spark. The Rober… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Jerry

Jerry

Service Technician

576 satisfied customers

HVAC Technician. Hearth Products Specialty

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

Thehvacguy

Thehvacguy

LIC HVAC,Plumber

426 satisfied customers

Certified HVAC Universal Technician,Lic plumbing contractor, 28 yrs exp

Drcool

Drcool

HVAC Technician

264 satisfied customers

i have been an A/C tech for the past 30 Years. working on window types, split type, and package

N4IEA

N4IEA

NATE Certified; HVAC Technician

227 satisfied customers

Retired, HVAC / Electrical Technician / Contractor 35-years Experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x