HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a furnance in my mobile home. Model DGAA077BDTA and
I have a coleman furnance in my mobile home. Model DGAA077BDTA and we have a steady green light and one blinking red light which indicates a ignitor issue. Can someone assist?… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,289 satisfied customers
I have a Lennox wisper heat gas furnace and it only blows cold
I have a Lennox wisper heat gas furnace and it only blows cold air. It looks like the burners won't ignite.… read more
Appliance Guru
Appliance Guru
21,277 satisfied customers
I have an American Std UY120R9V5V . The zone controller is
I have an American Std UY120R9V5V . The zone controller is calling for heat, but there is no ignition or blower activity. The vent fan runs continuously which is not normal. It was running fine yester… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,289 satisfied customers
My trane xr90 furnace is in a lockout mode and is continuously
My trane xr90 furnace is in a lockout mode and is continuously blowing cold air. I took off the covers and the red led light is blinking 9 times for check ignitor. So I replaced the ignitor because it… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
FG7SC Furnace stops working after a couple of cycles even though
FG7SC Furnace stops working after a couple of cycles even though Thermostat is calling for heat. Get alternating red/green flashing of diagnostic lights (1 hour lockout). Can reset by cutting and rest… read more
Appliance Guru
Appliance Guru
21,277 satisfied customers
Old furnace. Downflow in attic in Michigan where its about
Old furnace. Downflow in attic in Michigan where its about -40 windchill tonight furnace quit working about an hour ago.. sounds as if though the blower comes on then tries to light and does not then … read more
Appliance Guru
Appliance Guru
21,277 satisfied customers
My frigidaire fg6ra 072c-12a recently would only attempt to
My frigidaire fg6ra 072c-12a recently would only attempt to start the heating flame. it would have flames for a few seconds and then shut off. I tapped on the circuit board slightly and now it runs wi… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,289 satisfied customers
I have a nordyne Gas furnace It is newer model and the flame
I have a nordyne Gas furnace It is newer model and the flame is not comming on. The red status light inside the compartment is solid red but when you turn on the heat and the little fan comes on, afte… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,289 satisfied customers
my heater does not stay on very long. Tries to restart 3 xs
my heater does not stay on very long. Tries to restart 3 x's then will not try again for another couple of hours.… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,289 satisfied customers
I have two Bryant Model 340 MAV furnaces and both are generating
I have two Bryant Model 340 MAV furnaces and both are generating #34 fault codes. I've tried the restart procedures for both to no avail. Any suggestions?… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,289 satisfied customers
Code 8 after cleaning flame rod on York Diamond 80 furnace
I've got a problem with my York Diamond 80 that is eluding me, and I don't trust any local HVAC or appliance repair companies-too many bad experiences with big city dishonest technicians. The problem:… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
Hi, Lennox Furnace Gas, Model G32Q3-75-2 Ser# 5801C42365 -
Hi, Lennox Furnace Gas, Model G32Q3-75-2 Ser# XXXXX - About 2 weeks ago during the evening the furnace would not start. We had it set at 71. We started to get cold check the thermstat and it had start… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,113 satisfied customers
I have a goodman GMT-115-5 on natural gas that is about 7 years
I have a goodman GMT-115-5 on natural gas that is about 7 years old. It sometimes has trouble starting. The venter blower starts then after about 20 sec the ignitor glows, and when it works the gas va… read more
Mr. Jeff Pearson
Mr. Jeff Pearson
Refrigeration Systems
Associate Degree
155 satisfied customers
How many Flame Sensors are there on a ruud silhouette ii plus
How many Flame Sensors are there on a ruud silhouette ii plus 2 lxe? I know the one one left side is the Flame Sensor, but is the one on the right side also a Flame Sensor.… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,113 satisfied customers
I have a coleman furnace installed in 1994 model #DGAT090BDD.
I have a coleman furnace installed in 1994 model #DGAT090BDD. The green light is steady flashing which does not match any of the fault codes. I can get the light to remain steady by turning the power … read more
ComfortZone
ComfortZone
Associate Degree
515 satisfied customers
Trane XV80 gas furnace, 9 years old.~30 second initialization
Trane XV80 gas furnace, 9 years old. ~30 second initialization with red LED flashing slowly. Then red LED flashes fast and duct fans come on. Ignitor is energized with 115V for about a half second. No… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,416 satisfied customers
my furnace isnt working right it was just blowing cold air
my furnace isnt working right it was just blowing cold air last night when i turned it off waited 5mins and turned it on it would work for a little bit but then the warm air turned cold again today th… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
i need a rheem rgra 09ezajs manual. I looked at the troubleshooting
i need a rheem rgra 09ezajs manual. I looked at the troubleshooting flowchart and everything is working correctly. But , It is continuously cycling. It seems like the burner only runs for a minute the… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,113 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x