HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a Trane XR90 that the burner will not start. The
I have a Trane XR90 that the burner will not start. The induction blower is running and seems to have air flowing. I am also getting a 4 quick light flashing, the panel says is an open limit switch. H… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,636 satisfied customers
Trane tud060c936k4 No heat ; fan goes on and blows cold; 4
trane tud060c936k4 No heat ; fan goes on and blows cold; 4 flashes; there was power faileur since 10 am yesterday to 2 am today; no heat since after the power came back … read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,636 satisfied customers
I have a Trane XR80 furnace. the error code is flashing 4
I have a Trane XR80 furnace. the error code is flashing 4 times, which the manual says, its a temperature switch is open. my blower fan goes on and blows hot air for about 2 minutes, but then the fan … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,361 satisfied customers
I have an Amana 90 furnace. I was getting a code to change
Hello I have an Amana 90 furnace. I was getting a code to change the limit sensor. I changed it and the furnace is functioning. When the burner cycles off the led flashes is that normal? … read more
Rick
Rick
Supervisor
28,366 satisfied customers
Furnace fan comes on for a minute, but then shuts down
Furnace fan comes on for a minute, but then shuts down before heat starts … read more
Rick
Rick
Supervisor
28,366 satisfied customers
I too have a York Diamond 80. The heat does not come on. The
I too have a York Diamond 80. The heat does not come on. The thermostat seems to be doing its job. The blower comes on but the heat does not. I checked the pressure switch by blowing into the tube and… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,636 satisfied customers
Modine hot dawg HD 45AH01-34. 4 flashes now, pior in day did
modine hot dawg HD 45AH01-34 . 4 flashes now, pior in day did heat garage but blower would not turn off. circuit breaker turned off then back on. now blower stays on and no more heat just the 4 flashe… read more
Rick
Rick
Supervisor
28,366 satisfied customers
Armstrong High Efficency Furnace. Furnace starts burners run
Armstrong High Efficency Furnace. Furnace starts burners run for about 2 minutes, blower does not run, furnace shuts down on high temp limit. Code flashes 4 times for hight temp limit open circut. Hig… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
my furnace keeps shutting off. I press the reset button, it
my furnace keeps shutting off. I press the reset button, it comes on then reaches the set temp goes off, then wont come back on until I hit the reset button again.… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,265 satisfied customers
MY Trane XE80 gas furnace blower continues to run after reaching
MY Trane XE80 gas furnace blower continues to run after reaching thermostat temp and the gas shuts off then it's blowing cold air unless I raise the temp on thermostat… read more
airheatman
airheatman
HVAC Technician
11,878 satisfied customers
hi i have a 80+, 90+ upflow furnace 703956A. the problem with
hi i have a 80+, 90+ upflow furnace 703956A. the problem with the unit is that when i turn on the unit and set it to a temp of 75. the unit fires up and goes up from the current room temp of 60 to abo… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
Hello; Just replaced my old 20 year old thermostat with
Hello; Just replaced my old 20 year old thermostat with a Honeywell RTH7600D Thermostat. I wired the new thermostat using the same 5 wire configuration as on my old unit. Green to G, White to W, Yello… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,265 satisfied customers
I have a PAYNE furnace, model PG9MAB (Combustion furnace),
I have a PAYNE furnace, model PG9MAB (Combustion furnace), and I am receiving error code 33. I have tested till I don't know what to test. I have replaced the limit sensor and batteries in the thermos… read more
V12Tech
V12Tech
252 satisfied customers
I have a elite model ghr26q3-75 My problem is that the furnace
I have a elite model ghr26q3-75 My problem is that the furnace will start and run for a bit then shut down it shows a error code of left led on right led slow flash I cleaned filter and then removed f… read more
servtech50
servtech50
HVAC/R service tech
296 satisfied customers
Good morning. I have an American Standard Freedom 90 furnace
Good morning. I have an American Standard Freedom 90 furnace that's no more than ~4 years old or so. I have an error code blinking (two red blinks), and the furnace blower is running constantly, but t… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,361 satisfied customers
I have a Ducane Gas heater - about 10 Years old. The model
I have a Ducane Gas heater - about 10 Years old. The model number is XXXXX We used programmable Thermostat (Honeywell). Currently, the heater is signal error code as follow : 4 flash stop for 2 second… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
i have an older model ruud 80plus that is acting up last day
i have an older model ruud 80plus that is acting up last day or so. will get up to temp first time around, but as room temp drops and furnace kicks in again, only the blower goes on. not the burners. … read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,423 satisfied customers
Trane Draft Induced furnace problem. Burners never light.
I have a TUE120A960K2 Trane Draft induced furnace and the furnace motor kicks on when I turn the thermostat for heat.. The draft inducer motor starts and is turning properly.. The heating ignitor elem… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,361 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x