HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
Diamond Star 80 furnace lights burns for a while, then will
Diamond Star 80 furnace lights burns for a while, then will start to "sputter" momentarily turning of then back on then stops. It will relight, do the same thing after a slightly shorter run tin=me be… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,634 satisfied customers
My goodman furnace ignites and shuts off after a couple of
Hi, my goodman furnace ignites and shuts off after a couple of seconds (problably 3t o 5 seconds). … read more
Brian HVAC Guy
Brian HVAC Guy
HVAC Technician
High School
1,029 satisfied customers
How much does this cost? I have a furnace flashing 34 error
I have a bryant furnace flashing 34 error code-ignition failure, I am an hvac tech myself, not sure what is going on … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
9,915 satisfied customers
Carrier weathermaker 9200 with error code 34. Ignitor glows,
Carrier weathermaker 9200 with error code 34. Ignitor glows, burners light and kick off after a few seconds. Cleaned flame sensor, no change. Replaced flame sensor, no change. After power reset to cle… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
23,689 satisfied customers
I have a 8 yr old Goodman Propain gas Furn. When it cycles
I have a 8 yr old Goodman Propain gas Furn. When it cycles the induction pump goes on , the igniter lights for 10 seconds and nothing happens, then it shuts down and starts the cycle again ??… read more
Rick
Rick
Supervisor
28,299 satisfied customers
Nordyne Model #C7BAM01824C- furnace is not producing heat.
Nordyne Model #C7BAM01824C-B furnace is not producing heat. Water heater is on, so the gas is on to the unit. Side panel is off and I have reset everything and still no ignition. Green status light is… read more
Appliance Guru
Appliance Guru
21,334 satisfied customers
After fixing my furnace on Thursday it is doing the same
After fixing my furnace on Thursday it is doing the same thing as before. ive gone through all the same steps as before. I went to the furnace and put a jumper on the R and W terminals and held down t… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
9,915 satisfied customers
This is a confusing one for me. My Amana air command 95 efficient,
This is a confusing one for me. My Amana air command 95 efficient, installed in 1997 is not starting. Earlier this week it was buzzing/humming. I opened it and the induction blower runs, the igniter g… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
TAPPAN HEATER MODEL # XXXXX 120C-16 SERIAL # XXXXX EVERYTHING
TAPPAN HEATER MODEL # XXXXX 120C-16 SERIAL # XXXXX EVERYTHING SEEMS TO BE WORKING UP TO THE POINT THAT GAS KICKS ON BRIEFLY BUT DOES NOT IGNITE. RED LIGHT ON CIRCUIT BOARD FLASHES 3 TIMES THIS INDICAT… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,265 satisfied customers
Have a Carrier Infinity Furnace 58CVA110 that is cycling
Have a Carrier Infinity Furnace 58CVA110 that is doing something strange. The t-stat is set for "heat" mode and is set for a few degrees above where the temp is now (it's a Totalline P374-1100FM t-sta… read more
Appliance Guru
Appliance Guru
21,334 satisfied customers
I have a Goodman GMNT060-3 furnace that cycles constantly and
I have a Goodman GMNT060-3 furnace that cycles constantly and will not stay lit. When I turn on the power, it will start a normal cycle, the inducer fan starts, the HSI will glow and the gas comes on.… read more
3genhvac
3genhvac
11 satisfied customers
I have a Trane XL90 TUC series from 1987 that stopped working
I have a Trane XL90 TUC series from 1987 that stopped working yesterday. The exhaust fan turns on, the igniter glows, but no flame. Today is the coldest day of the year so far, any suggestions?… read more
MRANSWER
MRANSWER
TECHNICIAN
Bachelor's Degree
6,158 satisfied customers
I have an amana hvac model chpf4860d6ca and all of a sudden
I have an amana hvac model: chpf4860d6ca and all of a sudden yesterday it quit blowing hot air. I went into the attic where it is located to see what was going on and took off both covers exposing the… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
I have a Lennox complete system. The HM30 is igniting and detecting
I have a Lennox complete heat system. The HM30 is igniting and detecting the flame but a few minutes after it is started up the combustion air blower will stop without turning off the gas. Just before… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
23,689 satisfied customers
Hello, I have tried to clean the flame sensor with embry,
Hello, I have tried to clean the flame sensor with embry, but I cannot get a flame. I've gone through and cleaned everything, replaced the fuse, etc, but I cannot get a flame. Is the ignitor bad? Do I… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
23,689 satisfied customers
Please help! I have been dealing with this issue for almost
Please help! I have been dealing with this issue for almost the entire 5 years I have been in my new home. My Lennox G40UH(X) Series randomly will not kick on. I have had so many service calls by the … read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a lennox 80MGF with a upgraded ECG-1 board that was
I have a lennox 80MGF with a upgraded ECG-1 board that was replaced 9 years ago. Never had any problems with unit. Ok now the sequence. Blower works fine, house had gas and gas line is ok as hot water… read more
DanielC
DanielC
Service manager
High School or GED
95 satisfied customers
my thermostat is set at 80 and the room temp reads 69. the
my thermostat is set at 80 and the room temp reads 69. the furnance kicks on and runs for 30 seconds to 1 min the shuts off. room temp never raises. furnance kicks on again after another minute and re… read more
JBM HVAC
JBM HVAC
HVAC/R Technician
Vocational, Technical or Trade Scho
50 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x