HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a Lennox G61. the red line on the board pluse for a
I have a Lennox G61. the red line on the board pluse for a minute than follow by a green light that flashes for about 10 secs. The furnace eventually goes off and I get 4 red than 3 red. What is the p… read more
Minke Bro
Minke Bro
Lead HVAC Technician and Trainer
HVAC Technology
49 satisfied customers
I have a Comfortmaker gas furnace, model #GUH100AO16CIN.
I have a Comfortmaker gas furnace, model #GUH100AO16CIN. Thermostat calls for heat, ignitor glows and burner lights. Then I hear a "click" and the burner shuts off. The light on the circuit board blin… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
772 satisfied customers
Got a rheem criterion 2 furnace that ignites and runs for 30
got a rheem criterion 2 furnace that ignites and runs for 30 secs then flames out and cycles… read more
Rick
Rick
Supervisor
28,333 satisfied customers
My heater was working fine untill I had to hit the breaker.
My heater was working fine untill I had to hit the breaker. Now it just blows cold because the pilot is not lit. I've tried a lighter and that doesn't work. There's a little red light blinking. I don'… read more
Chris Wagner
Chris Wagner
None
30 satisfied customers
I have a H1001 propane above ground heater. The burners will
I have a H1001 propane above ground heater. The burners will light but after about 10 seconds they shut off. The blower continues to run and after about 30- seconds the spark igniter lights the burner… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,357 satisfied customers
Inducer motor runs, HSI glows for several seconds, then no
Inducer motor runs, HSI glows for several seconds, then no gas (gas valve doesn't open). Pressure and switch checkout, roll out switches check out for continuity. Already replaced the control board. I… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,265 satisfied customers
We have a Ruud Achiever Super Quite 80 Series furnace. My husband
We have a Ruud Achiever Super Quite 80 Series furnace. My husband has cleaned the flamed sensor, check the flu for restrictions, changed the filter (which wasn't bad, we are pretty good about changing… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
9,928 satisfied customers
i have sv 9501 100% shutoff valve as soon as the pilot flame
i have sv 9501 100% shutoff valve as soon as the pilot flame hits the flame sensor pilot and ignitor shuts off… read more
Rick
Rick
Supervisor
28,333 satisfied customers
I have a Bryant gas furnace, and my burner ignites and the
I have a Bryant gas furnace, and my burner ignites and the exhaust fan runs normally but when the air handler kicks on the flame goes out. It then flashes code 34.… read more
Appliance Guru
Appliance Guru
21,335 satisfied customers
T-stat turned up, clicks, fan on the firebox starts, 20 sec
T-stat turned up, clicks, fan on the firebox starts, 20 sec later, the ignition spark starts, then the flame lights, it burns for 7 seconds, the circulation fan starts, and the flame goes out, but the… read more
Scott
Scott
Self Employed HVAC Service Technician
Associate Degree
401 satisfied customers
I have a Nordyne G6RA furnace that runs a flame cycle for about
I have a Nordyne G6RA furnace that runs a flame cycle for about 30 seconds then shuts off. At first, the board was indicating the pressure switch stuck open (two flashes of the red status light). Now,… read more
MRANSWER
MRANSWER
TECHNICIAN
Bachelor's Degree
6,158 satisfied customers
I have a Bryant 80 plus that irreglarly does not fire up. Get
I have a Bryant 80 plus that irreglarly does not fire up. Get code 34. Some days the furnace works just fine which rules out flame sensor and bad furnace. Notice it seems to not work when extremely co… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
Hi, my unit flame on and off, after that i have 8 flashes error
Hi, my unit flame on and off, after that i have 8 flashes error code but the last time flashes were 6. Also, blow motor is not turning off.… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
My Bryant furnace is not putting out warm air. I just went
My Bryant furnace is not putting out warm air. I just went and looked at the RED LED status light and it was blinking. After removing both panels and then replacing the top panel, the light remained o… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,357 satisfied customers
I have Bryant 340MAV (90+ condensing) with a recurring problem
I have Bryant 340MAV (90+ condensing) with a recurring problem that is getting worse. It would start normally - induction motor start for 20-30 seconds then glow plug start, then gas valve opens and b… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,357 satisfied customers
Have a Coleman Model 8975a676 Heater in a mobile with AC added.
Have a Coleman Model 8975a676 Heater in a mobile with AC added. This is an up flow unit. When the TS calls for heat, the flue booster fan comes on, the ignition system energizes the 120VAC silicon car… read more
Jason  Hvac
Jason Hvac
Hvac Tec
Vocational, Technical or Trade Scho
120 satisfied customers
My Carrier Gas Furnace will not stay lit. It is an induce
My Carrier Gas Furnace will not stay lit. It is an induce combustion furnace which is only a little over a year old. Model no. is 58STA . Here is what happens when you turn the furnace on: Induction f… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,357 satisfied customers
I have a bryant 350 MAV furnace that exhibits the following 1.
I have a bryant 350 MAV furnace that exhibits the following: 1. sometimes it cycles just fine 2. sometimes inducer motor starts and stops before it gets up to speed 3. sometimes the cycle goes fine un… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x