HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a York Diamond 80 furnace that will not complete the
I have a York Diamond 80 furnace that will not complete the ignition cycle. The glow plug gets bright orange and hot but the gas valve never opens and thus no flames. When I measure the voltage at the… read more
Rick
Rick
Supervisor
25,948 satisfied customers
We have a Rodgers Intellivent unit that controls our water
We have a White Rodgers Intellivent unit that controls our water heater. The water heater will light up and heat water for a couple hours then shut off. The LED code suggests it is a problem with the … read more
Appliance Guru
Appliance Guru
19,163 satisfied customers
I have an Aire-Flo unit that was working fine til this morning.
I have an Aire-Flo unit that was working fine til this morning. From what I can tell the unit starts as normal, once the ignition occurs it burns for around 5-10 seconds then shuts off. I read the led… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,012 satisfied customers
I have a York Diamond furnace turning on for the first time
I have a York Diamond furnace turning on for the first time this year, Put the thermostat on...when I look in the furnace, I see an orange light followed by blue flames that last about 3-7 seconds bef… read more
airheatman
airheatman
HVAC Technician
6 years college
10,410 satisfied customers
I have a York Diamond 80 unit. Control board failed and
I have a York Diamond 80 unit. Control board failed and was replaced two days ago. Heating worked great for 36 hours and quit again. Symptoms are: 1. Plug unit in. 2. Exhaust fan starts 3. Igniter lig… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,012 satisfied customers
Intermittent problem here. York gas furnace. P2MPD16N09601A.
Intermittent problem here. York gas furnace. P2MPD16N09601A. Has hot surface ignitor. Call for heat, blower starts whirring, ignitor glows, burners fire for five seconds or so, then turn off with out … read more
Kenton Guidry
Kenton Guidry
HVAC Technician
Vocational, Technical or Trade Scho
963 satisfied customers
I have a Carrier Weather Maker 8000 HVAC unit Model 58ZAV115-20
I have a Carrier Weather Maker 8000 HVAC unit Model 58ZAV115-20 Serial 2898A19751. The unit is about 12 years old. In Scottsdale it getts very little use as our winters are very mild. The funace will … read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
Honeywell SV9520 Gas blower controler gives six flashes on
Honeywell SV9520 Gas blower controler gives six flashes on LED and doesn't stay on. It comes on for a second then back off and repeats this four times before completely shutting down. Furnace main out… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
My furnace keeps sending out a 6-1 code for hard lockout. How
My furnace keeps sending out a 6-1 code for hard lockout. How can I correct this ? And why is happening .… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
sometimes my furnace goes through two or three attempts to
sometimes my furnace goes through two or three "attempts" to start up but doesn't get flame. Sometimes on the third cycle it will actually go ahead and run with no flame blowing cold air into the hous… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,087 satisfied customers
Hello, I have tried to clean the flame sensor with embry,
Hello, I have tried to clean the flame sensor with embry, but I cannot get a flame. I've gone through and cleaned everything, replaced the fuse, etc, but I cannot get a flame. Is the ignitor bad? Do I… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,012 satisfied customers
HI. I have a Lennox furnace that is about 5 years old (I dont
HI. I have a Lennox furnace that is about 5 years old (I don't remember the model number as I'm at work). Anyways, I changed the Hi/Low switches and cleaned the flame sensor because I had a problem wi… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
Hello, first off we live in Wisconsin and tonight is expected
Hello, first off we live in Wisconsin and tonight is expected to reach -1F. Our Carrier 58MXA furnace was working fine until sometime today. When we got home we noticed the house was cold and my husba… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
I have a York Gas Furnace model G8C07516MUC11A and has a n
I have a York Gas Furnace model G8C07516MUC11A and has a n electrical ignition. It will get hot and the furnace will ignite. It will stay that way for a minute or so and then shut off. It will do so s… read more
Robert
Robert
Associate Degree
161 satisfied customers
i have a York 80% upflow gas furnace that is about 8-9yrs old. model
i have a York 80% upflow gas furnace that is about 8-9yrs old. model no.P4HUC16NO9201A serial no.SWGKMO43669 furnace goes thru ignition cycle (3)times then stops. glow plug comes on and gas ignites fo… read more
Kenton Guidry
Kenton Guidry
HVAC Technician
Vocational, Technical or Trade Scho
963 satisfied customers
I have a 14 year old Armstrong Ultra Sx80 forced air gas furnace.
I have a 14 year old Armstrong Ultra Sx80 forced air gas furnace. It has an electric spark intermittent pilot and flame detector assembly. When I turn the furnace on the spark gets the pilot going and… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,012 satisfied customers
I believe I have a York Low-boy furnace (PR6 40 NOLS), and
I believe I have a York "Low-boy" furnace (PR6 40 NOLS), and over the last week I've been receiving an error flash code (flashes 7 times). I can hear the furnace try and start, the flame begins and th… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
hello i have a goodman GMP075 3 gas furnace bulit in 1993,the
hello i have a goodman GMP075 3 gas furnace bulit in 1993,the furnace inducer turns on ,then ignitor glows,then burners turn on for 5-7 sec. but the blower does not,then burners shut down and it cycle… read more
JBM HVAC
JBM HVAC
HVAC/R Technician
Vocational, Technical or Trade Scho
50 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x