HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
Armstrong High Efficency Furnace. Furnace starts burners run
Armstrong High Efficency Furnace. Furnace starts burners run for about 2 minutes, blower does not run, furnace shuts down on high temp limit. Code flashes 4 times for hight temp limit open circut. Hig… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
MY Trane XE80 gas furnace blower continues to run after reaching
MY Trane XE80 gas furnace blower continues to run after reaching thermostat temp and the gas shuts off then it's blowing cold air unless I raise the temp on thermostat… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,553 satisfied customers
My Heil/Tempstar furnace NUGK075DG07 keeps overheating. It
My Heil/Tempstar furnace NUGK075DG07 keeps overheating. It comes on, then heats up until the rotating fan/hi heat limit is hit, then the burners kick off. The main blower continues to run, and within … read more
Rick
Rick
Supervisor
26,025 satisfied customers
I have an old Armstrong model MG66-80D propane furnace, and
I have an old Armstrong model MG66-80D propane furnace, and I live nearly 100 miles from a dealer. When I light my furnace, it comes on normally, and after a few minutes, the fan starts circulating th… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
State Licensed Mechanical Contractor
23,357 satisfied customers
Hi. I have a Bryant 383KAV. I noticed its only blowing out
Hi. I have a Bryant 383KAV. I noticed its only blowing out cold air. I replaced the filter just a couple weeks ago. Vents are clean, no blockage and the limit switch has an auto reset. When I power cy… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
State Licensed Mechanical Contractor
23,357 satisfied customers
I have A Trane XL80 that is giving me a "open temperature limit
I have A Trane XL80 that is giving me a "open temperature limit circuit" code. It fires up for a couple of minutes then stops. I have inspected the limit switch, air filter and the evaporator coil and… read more
MRANSWER
MRANSWER
TECHNICIAN
Bachelor's Degree
6,158 satisfied customers
TraneXE80 furnace control board flashes #4 code. Furnace goes
TraneXE80 furnace control board flashes #4 code. Furnace goes through all operations, fires up, runs for 2 1/2 minutes, gas valve and burner shut off, unit continues running and eventually blowing col… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
State Licensed Mechanical Contractor
23,357 satisfied customers
My Bryant furnace is not putting out warm air. I just went
My Bryant furnace is not putting out warm air. I just went and looked at the RED LED status light and it was blinking. After removing both panels and then replacing the top panel, the light remained o… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
State Licensed Mechanical Contractor
23,357 satisfied customers
Hi there! I have a Payne furnace, Model# pg9mab060120 built
Hi there! I have a Payne furnace, Model# XXXXX built in 2007. It is set up with a Bryant heat pump system. The code (33) states a flame roll out or limit switch problem. I assumed that the cold air re… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
i have a comfortmaker model #nbf075f16a2 and i have a problem
i have a comfortmaker model #nbf075f16a2 and i have a problem with it runing for about 5 min then the gas shuts off for a few minutes and then comes back on (the fan continues to run). i have changed … read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
State Licensed Mechanical Contractor
23,357 satisfied customers
i have a amana air command 80 sse, blows cold air, cleaned
i have a amana air command 80 sse, blows cold air, cleaned flame sensor, nothing? thanks Jim… read more
Bart Jay
Bart Jay
Vocational, Technical or Trade Scho
I have a bryand MAV350 natural gas furnace. The blower motor
I have a bryand MAV350 natural gas furnace. The blower motor siezed up overnight an I replaced it with a matching motor with same ratings. Now the furnace comes on, runs for a few minutes and then shu… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
hi... Got a 58SXC furnace thats shutting off after one burn
hi... Got a 58SXC furnace that's shutting off after one burn cycle. Followed the instructions inside the cover panel to restart, and it goes through the sequence, roughly: - 1sec delay; start blower m… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
we have a lnnox furnace about 35 years old. three burner type
we have a lnnox furnace about 35 years old. three burner type with belt driven fan. when the furnace comes on we get musty burnt smell. the wire in the motor were black so i replaced it along with the… read more
BillyHvac
BillyHvac
Journeyman HVAC Tech
State Licensed Mechanical Contractor
23,357 satisfied customers
I have a Trane XB 90 Gas furnace. I have cleaned all the drainage
I have a Trane XB 90 Gas furnace. I have cleaned all the drainage hoses, replaced the filter and have installed a new thermostat. The furnace starts its cycle as the fan blows. It starts and stops sev… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
I have a Classic 90 gas furnace. The purge fan turns on prior
I have a Classic 90 gas furnace. The purge fan turns on prior to the ignitor turning on, the gas ignites and burns about 30seconds before the blower fan kicks on, the gas runs about 60 to 90 seconds t… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
My Rheem RGPH-10EAMER furnace shuts down while the thermostat
My Rheem RGPH-10EAMER furnace shuts down while the thermostat is still calling for heat. It starts again right after it shuts down and finishes heating to the called for temperature. I thought it migh… read more
Kenton Guidry
Kenton Guidry
HVAC Technician
Vocational, Technical or Trade Scho
963 satisfied customers
I have a York Furnace (PS9 High Efficiency Tubular Heat Exchanger
I have a York Furnace (PS9 High Efficiency Tubular Heat Exchanger Series), working fine until recently. If I turn the power off then on, it would start running but with 4 blinking red lights. Several … read more
Jim Eastwood
Jim Eastwood
Lead service
High School or GED
100 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x