HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a payne gas furnace with electronic igniter down
I have a payne gas furnace with electronic igniter down draft system burners wont light i have tried bypassing both limit switches still wont light but when i take the cover off of the burner box furn… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
Trans X-ray 90 heater is blinking red light 3 times then
Trans X-ray 90 heater is blinking red light 3 times then pause … read more
Rick
Rick
HVAC Supervisor
26,111 satisfied customers
Lennox Furnace Model CX34-44/48C-6F-1. Error codes A1275 and
Lennox Furnace Model CX34-44/48C-6F-1. Error codes A1275 and E200. 5 years old, never a problem. Cleaned flame sensor, continuity good. Still wont fire. … read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,126 satisfied customers
Have a Lennox G40UH furnace that won't ignite. Blower motor
blower motor turns on but no ignition Has simultaneous fast flash on on both led lights then when the blower shuts off because it doesn't ignite the left led goes off and the right led is in slow flash. We have checked the exhaust vent and it is clear.… read more
Rick
Rick
HVAC Supervisor
26,111 satisfied customers
I'm having a fault code that indicates a pressure switch
I'm having a fault code that indicates a pressure switch open when it should be closed … read more
Rick
Rick
HVAC Supervisor
26,111 satisfied customers
My Lennox furnace seems to start up fine, runs for a little
My Lennox furnace seems to start up fine, runs for a little while, then shuts down before the thermostat temp is reached. It will do this over and over again for hours until the temp is finally reache… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
G71-MPP series Lennox furnace (new 2009) shut down. Error
G71-MPP series Lennox furnace (new 2009) shut down. Error code flashing E228. I blew out the exhaust tube but now i see water coming back into the furnace from the exhaust tube. i'm letting it drip ou… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
I have a Lennox Pulse 21 (G21) gas heater that is 22 years
I have a Lennox Pulse 21 (G21) gas heater that is 22 years old. Twicw this year about two weeks apart I noticed the house was cold. The furance was running but putting out cold air. I turned off the p… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
I have a Lennox G27M3 75A it has a slow flashing LED 1 and a
Hello, I have a Lennox G27M3 75A it has a slow flashing LED 1 and a steady LED 2 no heat but the fan is on, the thermostat shows call for heat. I already checked the tubes for blockages between the pr… read more
Expert
Expert
Our hanging Lennox Model number Lf24-150 furnace is acting
Our hanging Lennox Model number Lf24-150 furnace is acting up. It will ignite and get warm for a while then quit heating, while the fan keeps blowing. Any ideas what to look at first? Thank you… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
Have A question regarding my Trane HVAC that is out. I need
Have A question regarding my Trane HVAC that is out. I need to sign up for a plan first I guess but this site is not user friendly at all.… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
I have a G43 series furnace that seems to try and run but after
I have a G43 series furnace that seems to try and run but after about 30 seconds it shuts off. It is not putting out any heat. Replaced the filter but still no luck. When it is trying to run the red a… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
Lennox mod # XXXXX The Led lights are in a slow alternating
Lennox mod # XXXXX The Led lights are in a slow alternating mode. It is loosing the flame 4 times during one heating cycle. I turned off the power and turned it back on. It restarted and during the cy… read more
MRANSWER
MRANSWER
TECHNICIAN
Bachelor's Degree
6,158 satisfied customers
I have a Lennox G40UH gas furnace. The combustion air inducer
I have a Lennox G40UH gas furnace. The combustion air inducer turns on but the ignitor won't energize. The LED #1(red) goes off and the LED #2(green) shows a slow flash. The diagnostic code chart says… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
Lennox G43UF Heat isnt turning on...Diagnostic Code LED#1
Lennox G43UF Heat isn't turning on...Diagnostic Code LED#1 Red if off and Led #2 Green is flashing...Could be Pressure prove switch open or blocked inlet/exhaust vent or pressure switth closed prior t… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
I have a Payne furnace with LED code of Pressure switch open
I have a Payne furnace with LED code of Pressure switch open when it should be closed. What do I need to do to fix and reset?… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
I have a concord furnace that wont stay running. There is
I have a concord furnace that won't stay running. There is a flashing light that flashes 6 times. The diagnostic sheet does not show this code. I can reset the furnace by turning the master switch off… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
Hi, I am having difficulty getting my furnace to reach the
Hi, I am having difficulty getting my furnace to reach the desired temperature set on the thermostat. The red buttons are flashing as such- LED#1 - slow flash LED#2 - fast flash According to the troub… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x