HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I'm getting error codes 228 and 276 and 273. Not at the same
I'm getting error codes 228 and 276 and 273. Not at the same time but the furnace won't light and run. … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
Just saw my furnace is displaying an error message Fault 13.
just saw my BRYANT furnace is displaying an error message Fault 13 … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
My furnace started ran properly for about 24 hours then went
Hello my furnace started ran properly for about 24 hours then went to blinking 4 reds. I've replaced pressure switch and gas valve twice. I was told limit switch ? … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
How much does this cost? I have a furnace flashing 34 error
I have a bryant furnace flashing 34 error code-ignition failure, I am an hvac tech myself, not sure what is going on … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
I have a question about my Ruud furnaces. It's not the
The induce fan motor runs, then the gas comes on then ignites but 1 minute later the flame goes out.… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
Furnace question... Flame ignites and runs for 4-5 seconds
Furnace question... Flame ignites and runs for 4-5 seconds and goes out and then fan runs for a couple of minutes then attempts to ignite again after a couple minutes and repeats. light blinks once wi… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
I have a Peerless Pinnacle PI-140 natural gas boiler. I'm
I have a Peerless Pinnacle PI-140 natural gas boiler. I'm getting E14 error code, and once got an F10 error code. Fan seems to be spinning, but flame is not always on. What is the best order of parts … read more
Rick
Rick
HVAC Supervisor
26,111 satisfied customers
I am trying to do a high limit reset on my furnace, model number
I am trying to do a high limit reset on my furnace, model number carrier furnace 58sta135 code 33 error… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
I have a Pf-80 that keeps locking out on DHW ignition: Locking
I have a Pf-80 that keeps locking out on DHW ignition: Locking Error Code A01. Never happens on CH operation and boiler fires without fail when Reset button is pushed. Visual inspection of igniter and… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
I have a Carrier furnace (Carrier 58MTB080-F-10112) that stopped
I have a Carrier furnace (Carrier 58MTB080-F-10112) that stopped working sometime early this morning. I'm getting error code 13/33 which is saying the flame rollout switch needs to be reset. I've loca… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,468 satisfied customers
House temperature stays at 66-68 degF, but setpoint is at 70
House temperature stays at 66-68 degF, but setpoint is at 70 degF. If I turn the power to the furnace off and on the house will heat up to 70 degF. I have to reset it once or twice per day. Any idea w… read more
Appliance Guru
Appliance Guru
19,152 satisfied customers
I have a Laars Endurance gas furnace. It periodically shuts
I have a Laars Endurance gas furnace. It periodically shuts off, displaying LO (lockout) in the readout area. There does not seem to be any rhyme or reason as to what causes this to happen. It could b… read more
V12Tech
V12Tech
252 satisfied customers
I have a Payne PG8JAA furnace. The blower stays on. Ive read
I have a Payne PG8JAA furnace. The blower stays on. I've read that I may have to manually reset the control switch. But I can't find it. I have taken the access panels off. I see a circuit board, but … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
I have a Evcon furnance (1998-app) Model No DGAT070BDE, Serial
I have a Evcon furnance (1998-app) Model No DGAT070BDE, Serial N. XXXXXXXXX and it will cycle on and off (varies on length & number of attempts) before it will stay on. Sometimes it will start and run… read more
MRANSWER
MRANSWER
TECHNICIAN
Bachelor's Degree
6,158 satisfied customers
I have a Lennox 80MGF furnace that is acting strange. The
I have a Lennox 80MGF furnace that is acting strange. The sequence is: 1) Thermostat calls for heat. 2) Combustion chamber is cleared. 3) Igniter fires. 4) Burners light. 5) Circulation fan comes on. … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,009 satisfied customers
Hello, I have a Peerless Pinnacle #PI-80REV1 that is four
Hello, I have a Peerless Pinnacle #PI-80REV1 that is four years old. The boiler fires up and stays on until the water temp reaches 104 and then shuts off. The control board shows an FO9 error code. I … read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
I HAVE A MILLER FURNACE MMHA CODE 3 ON THE BOARD, IGNITION
I HAVE A MILLER FURNACE MMHA CODE 3 ON THE BOARD, IGNITION / GAS VALVE PROBLEM. THE HOT SURFACE IGNITOR LIGHTS THE GAS FOR ABOUT 10 SECONDS UNTIL THE GAS VALVE SLOW RELEASE GOES TO FULL OPEN. AT THIS … read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
the problem is about a month or so old...the furnace just randomly
the problem is about a month or so old...the furnace just randomly doesn't start, unless you 'reset' it. the transformer would alos occasionally hum with the rest, and if you 'bump' it , it would then… read more
Robert
Robert
Associate Degree
161 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x