HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a Nordyne Series 80+ or 90+ Furnace that the red
Hello Pearl. I have a Nordyne Series 80+ or 90+ Furnace that the red light flashes twice indicating pressure switch is open and inducer motor is on. I am wondering what are the possible causes of this… read more
Appliance Guru
Appliance Guru
19,153 satisfied customers
Had 31 one code with intermitiant heat coming on and off
Had 31 one code with intermitiant heat coming on and off with blower on all the time. I read if I pulled the hose and blew through it it may help on clog. Now I get 23 code and no fan or anything is h… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,011 satisfied customers
I have a carrier furnace 58mca120 16-120 error code 33
I have a carrier furnace 58mca120 16-120 error code 33 followed by error code 13. replaced both the high limit and roll out switch and still have the error code. There are no other switches in the cir… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
York Furnace won't even cycle on. Immediately starts with 4
York Furnace won't even cycle on. Immediately starts with 4 blinking red light error code "Limit Switch Open or 24V fuse is open" … read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
morning, my furnace lights then ater a fuew seconds the flame
morning, my furnace lights then ater a fuew seconds the flame goes out. i relpaced the flame sensor last week and it has started this again. sometimes it will burn for a min. berfore the flame goes ou… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,011 satisfied customers
I have a 1995 Payne Plus 80 furnace that, for the past few
I have a 1995 Payne Plus 80 furnace that, for the past few mornings, decides not to relight the pilot light. I am able to relight the pilot and it heats for the rest of the day and into the evening, b… read more
V12Tech
V12Tech
252 satisfied customers
How to troubleshoot Lennox ml193uh furnace that quit working?
My furnace, ML193UH, has been working very well. This morning I awoke to an unusually cool house and checked the diagnostic lights and was sure enough, the green light was blinking slowly. When I chec… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,011 satisfied customers
rheem furnace is not igniting. motor starts, runs for 30 seconds
rheem furnace is not igniting. motor starts, runs for 30 seconds but i dont hear clicking to ignite. any ideas?… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,375 satisfied customers
Good morning, I have a Trane XL 80. The heater is not coming
Good morning, I have a Trane XL 80. The heater is not coming on. The furnace filter is clean, igniter is clean, and the sensor near the burners is clean. When the unit tries to start it goes thru the … read more
servtech50
servtech50
HVAC/R service tech
296 satisfied customers
I got an Armstrong G1N80AU natural gas furnace and got a 4
I got an Armstrong G1N80AU natural gas furnace and got a 4 flashes failure code which as per the O&M manual indicates an open limit switch or limit switch circuit fault. I checked the rollout switch, … read more
servtech50
servtech50
HVAC/R service tech
296 satisfied customers
I have a Carrier Weathermaker gas furnace that runs for several
I have a Carrier Weathermaker gas furnace that runs for several minutes, then shuts off. The fault code displayed is 31, which has seven different causes. I had an HVAC repair company replace the indu… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,481 satisfied customers
I have a 31 fault code on the LED. No blockage in my exhaust
I have a 31 fault code on the LED. No blockage in my exhaust and intake pipes. The manual suggests a pressure switch fault. I have intermittent flame. When I do have flame, the LED code goes away to s… read more
MRANSWER
MRANSWER
TECHNICIAN
Bachelor's Degree
6,158 satisfied customers
i have a heil furnace model # N8MPL 100,000 BTu, in the heat
i have a heil furnace model # XXXXX 100,000 BTu, in the heat mode, the vent inducer fan will start, after that igniter will work, burner will work after that, but when blower fan is ready to start, th… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,011 satisfied customers
I have a Lennox G27M5-120A-2 furnace. LED flashing codes
I have a Lennox G27M5-120A-2 furnace. LED flashing codes that indicated: 1. Secondary limit was open 2. Pressure switch was open Additionally blower was not cycling on in normal fashion. Troubleshooti… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,011 satisfied customers
my rheem classic quiet 80 furnace will not light. the led pair
my rheem classic quiet 80 furnace will not light. the led pair has one flashing and one on solid. the flashing one appears to be flashing code "two".… read more
Paul
Paul
Vocational, Technical or Trade Scho
112 satisfied customers
I have an automatic pilot light that wont light. When the
I have an automatic pilot light that wont light. When the furnace is turned on, it goes through the cycle 5 or 6 times and then the blower kicks on, but no fire. i am getting a one blink code which iv… read more
Wes
Wes
HVAC Technician
Associate Degree
137 satisfied customers
I have an Ariston Micro Genus II combi boiler. It stopped working
I have an Ariston Micro Genus II combi boiler. It stopped working properly last night and has E33 on the display panel. I know that i have to get an engineer but could you tell me what the E33 means p… read more
Dan Linger
Dan Linger
Lead Technician / Energy Consultant
Bachelor's Degree
62 satisfied customers
Hi Im working on a nat gas furnace 80%+. It gives a fault
Hi I'm working on a nat gas furnace 80%+. It gives a fault code of 3 blinks, that pressure switch is stuck closed. Over the period of a week it has progressively gotten worse about not firing. The ign… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x