HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
My EnergyRite Lochinvar pool heater goes through its start
My EnergyRite Lochinvar pool heater goes through its start up sequence and the main burners come on. The heater runs for 20 seconds and the goes to pre-purge mode runs through its start up again... ig… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
I have a American Standard furnace Freedom 80 that is having
I have a American Standard furnace Freedom 80 that is having problems. It will firs most of the time, but sometimes it just blows cold air. It will eventually fire heat again. It works again if I also… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,940 satisfied customers
I have a TRANE XR80 and it is blowing cold air,when it should
I have a TRANE XR80 and it is blowing cold air,when it should be calling for heat.I have opened the front panel,and can see the igintor glowing,then the gas does ingnite,but then after only 2 seconds … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,037 satisfied customers
I have a Carrier STA090---10114 gas fired furnace. I have been
I have a Carrier STA090---10114 gas fired furnace. I have been having an intermittent problem. The draft inducer comes on like it should with a call for heat and then the hot surface ignitor comes on … read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,264 satisfied customers
My trane xr90 furnace is in a lockout mode and is continuously
My trane xr90 furnace is in a lockout mode and is continuously blowing cold air. I took off the covers and the red led light is blinking 9 times for check ignitor. So I replaced the ignitor because it… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
Arcoaire RPJ 2 furnace installed in 1995.When ignition cycle
Arcoaire RPJ 2 furnace installed in 1995.When ignition cycle begins the Glow plug operates and one of the four burner tubes ignites. Then everything goes out and ignition cycle repeats with same resul… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
Warm air furnace NTN3/NBF (?) When heat is called for, main
Warm air furnace NTN3/NBF (?) When heat is called for, main burner does not always ignite, so fan keeps blowing cold air indefinitely. I can start it by turning everything off, waiting about 15 minute… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
i have a lenox whisper model numberc23-41-1 wont light just
i have a lenox whisper model numberc23-41-1 wont light just hear clicking noise and in a few seconds blower clicks on with know heat jusy blowing cold air, thanks… read more
Kenton Guidry
Kenton Guidry
HVAC Technician
Vocational, Technical or Trade Scho
963 satisfied customers
Furance question, the thermastad does not turn on when it is
Furance question, the thermastad does not turn on when it is suppose to, sometimes if it is set to 68 it heats to 64 degrees then shuts off if I raise the temp 4 or 5 degrees it starts up, also i hear… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,940 satisfied customers
have a carrier weather maker 8000. starts up fine all burners
have a carrier weather maker 8000. starts up fine all burners are on and working but only lasts for about 20 to 25 seconds, then shuts down the fan runs and it goes thru the whole cycle again. almost … read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
I have a Trane XE 78 that just continues to blow cold air.
I have a Trane XE 78 that just continues to blow cold air. I turned off the system for a day to recheck but I continue to get cold air.… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,369 satisfied customers
The burners come on for about 10 seconds and as soon as the
The burners come on for about 10 seconds and as soon as the glo coil goes out the burners shut off leaving the fan blowing cold air. It then repeats the same cycle over and over again… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
768 satisfied customers
American Standard Furnace error codes 2 flashes. Blowing cold air.
We have an American Standard Furnace that has had problems since installation approx. 6 years ago. The furnace will ignite (sometimes) and heat will be distributed -- then switch to cold air and cycle… read more
G Wurtz
G Wurtz
Instructor of HVACR Program
Master's Degree
57 satisfied customers
Lately when it has been real cold outside at night, I am woken
Lately when it has been real cold outside at night, I am woken up with cold air blowing from the vents and the room temperature much lower than the thermostat setting. I can usually get the furnace to… read more
Bill P.
Bill P.
Installer/ Troubleshooter/Technician
338 satisfied customers
I have a York furnace, model P3URD20N11201. It goes through
I have a York furnace, model P3URD20N11201. It goes through its normal ignition cycle. Then, a few seconds after the burners light, it goes into "flame rollout mode": gas shuts off, status light blink… read more
AC MEDIC
AC MEDIC
Master Service Technician
Heating contractor
20 satisfied customers
My 2nd stage heating wont kick on. The system just blows cold
My 2nd stage heating won't kick on. The system just blows cold air. It's very cold outside...… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,087 satisfied customers
Furnace is Corsaire by Rheem, Model FGPJ-07EAUER, Serial EB5D302F429810676 Problem
Furnace is: Corsaire by Rheem, Model FGPJ-07EAUER, Serial EB5D302F429810676 Problem: No Heat - I see the heating element get hot, 3 jet-type burners light with flames, (kinda cool to watch), air blows… read more
ComfortZone
ComfortZone
Associate Degree
515 satisfied customers
I have an Air Ease Ultra SX 80 furnace that is 12 years old.
I have an Air Ease Ultra SX 80 furnace that is 12 years old. The T-stat calls for heat, the HSI(hot start igniter) gets yellow hot, the pilot light starts burning, the FS(flame sensor) gets red hot, a… read more
Ronald
Ronald
Consultant
Bachelor's Degree
4 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x