HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
I have an intermittent lockout code on my Trane XL80. If I
I have an intermittent lockout code on my Trane XL80. If I cycle power, the problem goes away. So I am trying to see if I find anything in your forum … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
7,807 satisfied customers
Trane XL80 Gas furnace. No heat tonight. Thermostat
Thermostat batteries were gone, replaced batteries. Furnace gas comes on, won't light. Trying to..... … read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,362 satisfied customers
I have a Trane XL90 model TUC100B960A0 Furnace. I was told
I have a Trane XL90 model TUC100B960A0 Furnace. I was told by "HVAC Guru" (justanswer.com HVAC Technician) in May that my board needed to be replaced due to non-start condition. I have purchased a Whi… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,870 satisfied customers
I'm ***** *****. I have a 2 year old rodgers 50E47-843
Customer: Hi I'm ***** *****. I have a 2 year old white rodgers 50E47-843 controller that is no longer outputting 120V to the igniter, measures about 3.5v … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,870 satisfied customers
Weil-Mclain VHE furnance short cycles -60 secs with no
Weil-Mclain VHE furnance short cycles for 30-60 secs with no error code on ICM. Replaced flame rod. Voltage across gas valve was erratically dropping from 24 down to zero tripping the solenoid repeate… read more
Appliance Guru
Appliance Guru
18,639 satisfied customers
Trane XE 70 lights for a few seconds and then turns off.
Trane XE 70 lights for a few seconds and then turns off. Turn furnace off and it tries again. Some times it works. Cleaned flame sensor, same thing. Installed new flame sensor same thing.… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
Hi, I think I have a problem with the control board on my
Hi, I think I have a problem with the control board on my York Diamond 80 gas furnace. Keep getting 3 blinks (pressure switch stuck open or closed...don't remember which). Replaced pressure switch and… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,870 satisfied customers
GOOD afternoon, I have a furnace using a white rogers(model
GOOD afternoon, I have a furnace using a white rogers(model #50E47-843) controlling system, on a intermark ??? furnace model #G901-5H, serial #0258, that will not light. Apparently controlling appears… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
red light flashin on my 50e47-843 hsi mod and only getting
red light flashin on my 50e47-843 hsi mod and only getting 98vac between hs1 and L2, Seems like I need a new control mod, Has this happened to anybody else out there… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
7,807 satisfied customers
Trane xe80 TDE080A945KO I am trying to troubleshoot an intermittent
Trane xe80 TDE080A945KO I am trying to troubleshoot an intermittent stoppage on my Trane xe80 gas furnace. Once or twice a day (beginning 4 days ago) the unit fails to function with an LED trouble cod… read more
type2technician
type2technician
253 satisfied customers
I believe the white rogers model 50e47-060 module on my gas
I believe the white rogers model 50e47-060 module on my gas furnace is broken, my furnace goes thru the normal start up but will not ignite. the module has a flashing red light on it, I have turned of… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,870 satisfied customers
Hi, I replaced the ignition control circuit board on my
Hi, I replaced the ignition control circuit board on my Rheem natural gas furnace model RGUC-07EAAER with a universal White Rodgers model 50e47-843 (thanks to your assistance on a previous conversatio… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
Comfortmaker - RPJ Heat Exchanger Model # - GUH100A016CIN Manf.
Comfortmaker - RPJ Heat Exchanger Model # XXXXX GUH100A016CIN Manf. # XXXXX GUH100AGCIN Input BTU - 100,000 Output BTU - 93, 000 Thermostat: White-Rodgers Programmable Here is the problem: I have the … read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a 21 year old York P2UCD08N06101 that starts normally
I have a 21 year old York P2UCD08N06101 that starts normally in the heat mode. Sometimes the burner stays on 30 seconds and sometimes 3 minutes. As soon as the burner trips it re-cycles normally, agai… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,362 satisfied customers
I would like to know the proper way of wiring up a White Rodgers
I would like to know the proper way of wiring up a White Rodgers 50E47-843 Furnace Control Box. I had a WR 50E47-140 and it was bad. I wired up the 843 but it isn't working. Here is how I had it wired… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
768 satisfied customers
I have a trane XL80 (from 91). Heat worked fine 2 days ago.
I have a trane XL80 (from '91). Heat worked fine 2 days ago. No heat yesterday. HSI gets no voltage. Voltage at both sides of pressure switch (crap meter so cant tell voltage - I will remember to get … read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
I have an amana 80 gas furnace with an white rodgers 50e47-843
I have an amana 80 gas furnace with an white rodgers 50e47-843 ignition control module. The ignitor doesn't light up and after 3 tries it shuts down with a blinking red light. I don't have 120V betwee… read more
Bill
Bill
High School or GED
318 satisfied customers
Do I need to replace my control module Thermostat calls for
Do I need to replace my control module? Thermostat calls for heat, purge fan comes on, there is a slight delay (20-30 seconds), gas valve opens, burner fails to light, gas valve closes, unit starts cy… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,791 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x