HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

I have a Goodman furnace that has tripped the lockout

Customer Question
I have a Goodman...

I have a Goodman furnace that has tripped the lockout sensors twice now

Contractor's Assistant: Did you check the furnace's filters?

Replaced. Brand new.

Contractor's Assistant: Do you plan on doing the work yourself?

If I can.

Contractor's Assistant: Anything else we should know to help you best?

I don't think do. so

Submitted: 3 months ago.Category: HVAC
Show More
Show Less
Ask Your Own HVAC Question
Answered in 3 minutes by:
12/27/2017
HVAC Technician: airheatman, HVAC Technician replied 3 months ago
airheatman
airheatman, HVAC Technician
Category: HVAC
Satisfied Customers: 8,977
Experience: Furnace, A/C and heat pump specialist.
Verified

Give me a few more details

1.Model on furnace?

2. Which lockout sensors are we referring to?

Ask Your Own HVAC Question
Customer reply replied 3 months ago
1. GMS91155DXA2. There are 2 sensors just below the flames. I have to reset those to get the furnace to operate.Works fine until I put the cover back on it. Then it may or may not keep running but one of the sensors trips and it either stops running or just blows cold air (no flame).
Customer reply replied 3 months ago
I see you can't call. Did you get the answers to my questions?
HVAC Technician: Rick, HVAC Supervisor replied 3 months ago
Rick
Rick, HVAC Supervisor
Category: HVAC
Satisfied Customers: 23,800
Experience: 40+ yrs. experience as a licensed oil & gas technician.
Verified

Welcome to Just Answer, my name is ***** ***** I will do my best to help you with your issue. If my initial response doesn’t answer your question then let me know and we can continue our conversation.

If you have to repeatedly reset the rollout sensors then your heat exchanger needs to be cleaned by a pro.

Ask Your Own HVAC Question
HVAC Technician: Rick, HVAC Supervisor replied 3 months ago

Do you have more questions?

Ask Your Own HVAC Question
Was this answer helpful?
Ask Rick Your Own Question
Rick
Rick
Rick, HVAC Supervisor
Category: HVAC
Satisfied Customers: 23,800
23,800 Satisfied Customers
Experience: 40+ yrs. experience as a licensed oil & gas technician.

Rick is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

6,938 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

953 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Related HVAC Questions
I have a goodman furnace model # GCH90904CXAB the code light
I have a goodman furnace model # GCH90904CXAB the code light comes on solid red. The induction fan is on when the power is turned on even if the thermostat is turned way down. … read more
HVAC Guru
HVAC Guru
Service Technician
Associate Degree
682 satisfied customers
Goodman furnace with trouble code no data, yes, at this time
furnace will not start draft inducer motor no signal.… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,700 satisfied customers
Have Goodman furnace model CNPVP3017ALAAAAA. Yesterday had
Yesterday had to shut down [with thermostat] to change some gas lines. It ran ok upon restart, but today blower runs continuously no matter what setting the thermostat is adjusted to. … read more
Rick
Rick
HVAC Supervisor
23,800 satisfied customers
I have a Goodman furnace. And it's continually blinking.. I
I have a Goodman furnace. And it's continually blinking.. I was wondering how does it reverse polarity?.... … read more
Brian HVAC Guy
Brian HVAC Guy
HVAC Technician
High School
953 satisfied customers
How to clean heat exchanger coils, filters have been clean
filters have been clean recently and I am getting an airflow alarm on the thermostat … read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,700 satisfied customers
I have goodman furnace GMH80803BNBB, WILL NOT START, RED
I have goodman furnace GMH80803BNBB, WILL NOT START, RED LIGHT BLINKING 6 TIMES UNDER bottom case. yesterday furnace fired but not ignite today not firing, what?… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have new goodman furnace model GMVC960603BNAA that my
i have new goodman furnace model GMVC960603BNAA that my plumer could not start for first time with code 88 … read more
Chris Wagner
Chris Wagner
None
27 satisfied customers
My Goodman furnace is blowing cold air. No flame noted.
My Goodman furnace is blowing cold air. No flame noted. Light flashes … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
The high temp wire that is wrapped around the heat exchanger
the high temp wire that is wrapped around the heat exchanger is showing no continuity, I get A2 error code … read more
airheatman
airheatman
HVAC Technician
8,977 satisfied customers
Goodman furnace will not start. Solid red light. Checked the
Goodman furnace will not start. Solid red light. Checked the transformer have 24 volts. By-paqssed the thermostat at the board (jumped R & W) nothing when pushing door switch on. Also, at the beginnin… read more
airheatman
airheatman
HVAC Technician
8,977 satisfied customers
I have a goodman furnace mod# GMH950904CXAA 2 blinks for
I have a goodman furnace mod# ***** 2 blinks for code … read more
Rick
Rick
HVAC Supervisor
23,800 satisfied customers
My heat exchangers do not function any where near the rated
My heat exchangers do not function any where near the rated BTU output. They were installed three years ago by a professional electrician. The units operate, but you can only tell by putting your hand… read more
F. Naz
F. Naz
CA Finalist & Completed B.com
278 satisfied customers
I have a goodman furnace. It will turn on the initial blower
I have a goodman furnace. It will turn on the initial blower to prepurge, then it will ignite and as soon as the main blower turns on, the flame will go out. It will keep igniting and going out for a … read more
Rick
Rick
HVAC Supervisor
23,800 satisfied customers
I have a nine-year-old Goodman furnace it won't start it has
I have a nine-year-old Goodman furnace it won't start it has a one flash code I go through the reset procedures and it does the same thing again price start three times and locks out … read more
airheatman
airheatman
HVAC Technician
8,977 satisfied customers
Goodman furnace acts as if it's not getting gas. Slightly
We just went through about 2wks of extreme cold temps. For whatever reason when the furnace has a lead time that lapses the furnace shuts down.… read more
HVAC Guru
HVAC Guru
Service Technician
Associate Degree
682 satisfied customers
Goodman furnace won't stay lit. Replaced the board with an
Replaced the board with an updated one, replaced gas valve, replaced flame sensor, replaced limit switch.… read more
Steve Peck
Steve Peck
NC
16 satisfied customers
I have a Goodman furnace that has tripped the lockout
I have a Goodman furnace that has tripped the lockout sensors twice now … read more
Rick
Rick
HVAC Supervisor
23,800 satisfied customers
Is it unsafe to have a cracked heat exchange on your
Is it unsafe to have a cracked heat exchange on your furnace? … read more
Rick
Rick
HVAC Supervisor
23,800 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x