HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
25-PDVC/55-SHP10 upper auger not feeding. cleaned burn area
25-PDVC/55-SHP10 upper auger not feeding. cleaned burn area and hopper. Checked fuse in control switch and vacuum switch port. Upper auger not feeding. Lower auger turns. … read more
Iohn Keffer
Iohn Keffer
HVAC Technician
77 satisfied customers
I have a gas fireplace insert which uses LP gas and I
I have a gas fireplace insert which uses LP gas and I believe is Haley and efficient. The chimney goes out the side of the house and so I'm assuming it's a zero clearance fireplace. I would like to re… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,375 satisfied customers
How do you test your user control board, About three months.
About three months. The stove starts ok and burns for about 20 to 30 minutes and stops putting pellets in … read more
Webb-Guy
Webb-Guy
Maitenance Supervisor
Associate Degree
4,012 satisfied customers
Question on a castile quadrafire pellet stove - about 13
question on a castile quadrafire pellet stove - about 13 years old. Flame is always low (even at the high setting) and barely clears the firepot. All of the ash from the fire is all over the inside of… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
My breckwell pellet stove only throws hot air three feet from
My breckwell pellet stove only throws hot air three feet from the stove a 400 square foot room.… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
have an astroflamm integra pellet stove. turned it on yesterday
have an astroflamm integra pellet stove. turned it on yesterday and it ran fine with auger/blower etc working. today, the auger light is out and not spinning. it is not jammed and the motor bench test… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
Stove has been working fine the little I have used it so far
Stove has been working fine the little I have used it so far this month. Attempted to start just now and it wont go to start up, goes directly to E2. Any ideas?… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
From Don in Hillsboro, Oregon. Do you answer questions regarding
From Don in Hillsboro, Oregon. Do you answer questions regarding the Quadrafire 1200-I pellet insert? I think my feed motor is bad, but at this point I am not sure What I am wondering about now, is ho… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
I have a 1973 era woodburning fireplace heatilator that I want
I have a 1973 era woodburning fireplace heatilator that I want to put a pellet stove into the fireplace. My problem is that it is a free standing fireplace (brick) and I need to get electricity to the… read more
TheHouseDoctorJA
TheHouseDoctorJA
14 satisfied customers
Englander model 25PD sometimes shuts off by itself
Englander model# 25 PD Serial # WHI 020967 Unit will shut off, sometimes just momentarily and restart by itself. Sometimes just shut down and have to hit on button to restart. With the pellet feed set… read more
V12Tech
V12Tech
252 satisfied customers
my quadrafire pellet stove wont start. the fan doesnt com on.
my quadrafire pellet stove wont start. the fan doesnt com on. there is just a huming noise when it tries to start… read more
Scott
Scott
Self Employed HVAC Service Technician
Associate Degree
400 satisfied customers
I have a Austroflame firplace insert pellet stove. I recently
I have a Austroflame firplace insert pellet stove. I recently been having problems starting the stove. It does not have an igniter. It is about 10 yeasr old. When starting it seems to put out too many… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
We have an older Pellet Pro 2. Probably 16 years old. It is
We have an older Pellet Pro 2. Probably 16 years old. It is spilling over un-burnt pellets. We have turned down the fuel feed but still does noit burn the pellets right. The manual says problem with u… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
I bought a used Austroflamm Integra wood pellet stove. With
I bought a used Austroflamm Integra wood pellet stove. With the power control on "MAX" the auger light comes on for only 0.5 to 1.0 seconds every 6 seconds. The pellet feed is slow, and the stove neve… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
I have an Austaflamm Integra, first generation and some time
I have an Austaflamm Integra, first generation and some time ago it malfunctioned with the burn-pot filling up and overflowing with pellets during start up ignition cycle, snuffing out the fire and sm… read more
Stans Fireplace
Stans Fireplace
fireplace repair tech.
High School or GED
2 satisfied customers
We have an older (1992) Austroflamm Integra FS pellet stove
We have an older (1992) Austroflamm Integra FS pellet stove that came with the house and is in its first winter's use. We are very pleased with the stove with the exception of one recurring problem wi… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
I have an old Rheem rgma-125a gas furnace that needs to be
I have an old Rheem rgma-125a gas furnace that needs to be started up. How do I do this? It doesn't have an obvious pilot device like the hot water heater.… read more
Richard
Richard
District Technical Manager
Vocational, Technical or Trade Scho
1,514 satisfied customers
I have an Austroflamm Integra pellet stove. Yesterday & again
I have an Austroflamm Integra pellet stove. Yesterday & again today after the stove has been running for awhile the circulating fan has stopped. The combustion fan & auger continued to operate. After … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,963 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,791 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x