HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

I have a tg8s130d20mp11b i think i need more return air can…

Customer Question
I have a tg8s130d20mp11b...

I have a tg8s130d20mp11b i think i need more return air can i plug off two burners to reduce the btus to 100,000 without problems?

Contractor's Assistant: Did you double-check the thermostat's settings? And what about the filters?

There ok i changed the thermostat and i had the same thing. i think the furnace is going of on the hi/limit.

Contractor's Assistant: Do you plan on doing the work yourself?

Yes

Contractor's Assistant: Anything else we should know to help you best?

I want to reduce the output temporarily until i put additional return air

Submitted: 8 months ago.Category: HVAC
Show More
Show Less
Ask Your Own HVAC Question
Answered in 3 minutes by:
12/8/2017
HVAC Technician: Gaztech, HVAC Technician replied 8 months ago
Gaztech
Gaztech, HVAC Technician
Category: HVAC
Satisfied Customers: 937
Experience: Owner at Gaztech
Verified

Hi I amCustomer a independent technician, I will assist you with your issue.

Don't forget to rate the 5 star rating AT THE TOP OF PAGE if we are done. this will credit me for assisting you.

How long have you had this furnace ? and has this always been a problem??

Ask Your Own HVAC Question
Customer reply replied 8 months ago
This is the third win0ter . Always the same
Problem .
HVAC Technician: Gaztech, HVAC Technician replied 8 months ago

Did you adjust blower speed tab to increase air flow? refer to manual to adjust speed.

and adjust gas pressure lower to reduce btus at the main regulator screw on gas valve

Here is manual link, refer page 10 to see gas valve, then page 23 for proceedures

http://www.thermopride.com/wp-content/uploads/2014/09/Spirit-Gas-TG8S-Series-Single-Stage-80-PSC-Install-Manual.pdf

Ask Your Own HVAC Question
HVAC Technician: Gaztech, HVAC Technician replied 8 months ago

Hello? are you doing the adjustments,

I am leaving for work soon and will check for your updates from time to time,

Ask Your Own HVAC Question
HVAC Technician: Gaztech, HVAC Technician replied 8 months ago

I noticed question is still opened, please dont forget to rate the 5 star rating if we are done.

Sincerely

Customer/p>
Ask Your Own HVAC Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a hvac technicianLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Gaztech Your Own Question
Gaztech
Gaztech
Gaztech, HVAC Technician
Category: HVAC
Satisfied Customers: 937
937 Satisfied Customers
Experience: Owner at Gaztech

Gaztech is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Related HVAC Questions
We head a non-profit charity. We recently purchased a
We head a non-profit charity. We recently purchased a building. There is not heat in the building. The boiler was old to begin with, then pipes froze. We are looking to heat the building by using gas … read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
We have a Heil 92% efficient furnace, model number:
We have a Heil 92% efficient furnace, model number: N9MPD125L20A2; serial number: A114058475. It is over sized for the house which according to heating contractors needs a 90,000 BTU furnace. My quest… read more
Airheatman
Airheatman
Heating & Air Conditioning Contractor
6 years college
1,836 satisfied customers
HVAC Short Cycling Nordyne 624631-A. Clean air is fine,
HVAC Short Cycling Nordyne 624631-A. Clean air is fine, exhaust is fine, coils are clean. Constantly starting stopping even if only running for 3-5mins. Get constant blinking LED on control board… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
I believe I have a problem with the size of ducts on my furnace.
I believe I have a problem with the size of ducts on my furnace. A few years ago I had my old furnace replace with a 100,000 BTU gas forces air. I have had a code 4 ever since. When the call for heat … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Hi - my honey wells total zone 4 controller shows the Heat
Hi - my honey wells total zone 4 controller shows the Heat led flashing, which apparently means "high limit" according to installation manual. what does "high limit" mean and what should I do about it… read more
HVAC_Doug
HVAC_Doug
Vocational, Technical or Trade Scho
I am getting instant blowback into the burner tube on my gas
I am getting instant blowback into the burner tube on my gas ceiling mounted infrared heaters for an outbuilding - this started last year at the beggining of winter when I first turned it on, and it b… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
I recently obtained two estimates to replace my furnace & central
I recently obtained two estimates to replace my furnace & central A/C which are 22 years old (they're still running, but I don't want to take chances on them anymore). Although both estimates are with… read more
Nathan Marshall, MP
Nathan Marshall, MP
Master Plumber,HVAC Tech,Tradesman
Vocational, Technical or Trade School
275 satisfied customers
L O N G POST! My home has a dual fuel split system with
L O N G POST! My home has a dual fuel split system with a 60k BTU 13 seer R22 air-source heat pump a 92%+ efficient 120k BTU NG furnace (5 ton blower). The compressor failed on the heat pump last summ… read more
3genhvac
3genhvac
2 satisfied customers
I have a williamson 5 in 1 furnance dating back to 1980 or
I have a Williamson 5 in 1 furnace dating back to 1980 or so we've lived in a two story house for 26 years but haven't use the 2nd floor much until now,not getting very much heat or air upstairs we ha… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
I have a 2 year old Westinghouse two stage variable speed furnace
I have a 2 year old Westinghouse two stage variable speed furnace that I had a contractor install in my house that I built new. ( I am a licensed electrician and builder) The furnace will, (what I gue… read more
V12Tech
V12Tech
252 satisfied customers
I am about to change the fan/limit switch on an old Janitrol
I am about to change the fan/limit switch on an old Janitrol fec 105 furnace. I was able to find a new switch identical to the one i am replacing (on ebay, still in box). Question is what temperature … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have a Heil furnace Model h9mpv075f12c1 Serial a053259287.
I have a Heil furnace Model h9mpv075f12c1 Serial a053259287. when the furnace comes off low cycle and goes into high the burners shut off. the code is 4 which means limit or rollout switch. I took off… read more
Richard
Richard
District Technical Manager
Vocational, Technical or Trade Scho
1,416 satisfied customers
I have an arcoaire 90%. i believe it went out on high limit,
I have an arcoaire 90%. i believe it went out on high limit, due to not having enough return air. I have temporarily opened up the connection between the return air boot & the ductwork. when turning t… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,010 satisfied customers
I have a 7900 series standing pilot furnace about 21 years
I have a 7900 series standing pilot furnace about 21 years old. It has started to struggle to keep up and maintain 72 degree temperature. Filter is kept clean but I've noticed the lower limit thermost… read more
Ladd Straatmann
Ladd Straatmann
Bachelor's Degree
13 satisfied customers
I have a Rheem Model # RGDA-07EA-CR 75000 BTU forced air furnace
I have a Rheem Model # XXXXX 75000 BTU forced air furnace with electric ignition. Last year it had the problem of coming on when the thermostat called for heat, run for about 10 minutes and then shut … read more
Rick the plumber
Rick the plumber
Owner
9,857 satisfied customers
We recently had a power outage. When the power was returned
We recently had a power outage. When the power was returned the burner in the furnace would not light even though the pilot light was working. I've replaced the thermo-coupler, thermostat, fan switch … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
We have a client that wants to add a 600 sq. ft. addition on
We have a client that wants to add a 600 sq. ft. addition on to their 2650 sq ft colonial. They have a Trane XE90 110 BTU furnace, is this big enough to handle the addition?… read more
JBM HVAC
JBM HVAC
HVAC/R Technician
Vocational, Technical or Trade Scho
50 satisfied customers
I have a 100,000 btu Coleman Evcon propane fired hot air furnace.
I have a 100,000 btu Coleman Evcon propane fired hot air furnace. It is +- 11 years old. The burners ignite and run for +- 1 minute and when the blower fan kicks on, the burner shuts down. The red err… read more
HVAC22
HVAC22
Residential Service Team Supervisor
High School or GED
32 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x