HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a Lennox G51MP that is flaking (no ignition). It just
Hi Pearl. I have a Lennox G51MP that is flaking (no ignition). It just ran through a purge cycle (again) and then shut down. … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,257 satisfied customers
I have a rude achiever series super quiet 80 which was
I have a rude achiever series super quiet 80 which was cycling off after the the burners kicked on for a few seconds, I cleaned the flame sensor and now the blower comes on, the light labeled “ok” bli… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,257 satisfied customers
My unit is acting a little quirky... It was working fine and
It was working fine and then it stopped responding to the thermostat. I went and killed the power to it and then waited a minute and kicked it back on. After a few minutes of it resetting it worked fine for 2 1/2 days. Then it repeated the processes. This has been going on in 2 1/2 day increments for the last week. … read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
10,115 satisfied customers
I have an Amana furnace with the code blinking 6 times. The
I have an Amana furnace with the code blinking 6 times. The blower runs all the time with not flame. … read more
Brian HVAC Guy
Brian HVAC Guy
HVAC Technician
High School
1,024 satisfied customers
Having trouble with a Trane AUC120C960. I have replaced the
Having trouble with a Trane AUC120C960. I have replaced the igniter but still no flame. I cannot locate the thermocouple to check it as well.… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,375 satisfied customers
I have a Carrier 8000TS. It is not staying on to warm house
I have a Carrier 8000TS. It is not staying on to warm house up. I did some research, cleaned the sensor, and the error code changed from 14 to 33. I read what it said to do, but cant find the flame ro… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,969 satisfied customers
lennox G20Q5e -150Hard start... when turning the furnace
lennox G20Q5e -150 Hard start... when turning the furnace on, the pilot will light then go out. it will not try and restart. after manually restarting the furnace, it seems that the pilot sensor gets … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,257 satisfied customers
Bryant 310 JAV that gives me code 13 or 33. I shorted
I have a Bryant 310 JAV that gives me code 13 or 33. No burner flame. Ran self test ok. I shorted out the Flu sensor and still will not lite. I wanna try shorting Limit sensors (looks like there are 3… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
Hi,It is 11 30 P.M. on one of the coldest nights of the year
Hi, It is 11:30 P.M. on one of the coldest nights of the year and our furnace is not working. The furnace is a MILLER Model: G4RA - 096C - 16 - H. It was installed in 1994. I have cleaned the flame se… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a Bryant 395 cav upflow furnace. (10 yrs old) It showed
I have a Bryant 395 cav upflow furnace. (10 yrs old) It showed a code 33, I had a service tech out and he told me that the circuit board needed to be replaced, after troubleshooting the pressure senso… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,969 satisfied customers
I have a Carrier weathermaker 9200 , installed in 1997 . The
I have a Carrier weathermaker 9200 , installed in 1997 . The unit runs about 10 minutes and flame goes out. Light code is 1 long flash and 3 short flashes. Furnace will restart after an hour or so aft… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
my forced-air furnace ignites, runs for a minute then shuts
my forced-air furnace ignites, runs for a minute then shuts down. it circuit breaks at the reset button and halts the gas flow with blower running for an additional couple of minutes. the red light on… read more
ComfortZone
ComfortZone
Associate Degree
515 satisfied customers
my goodman furnace keeps restarting continually while trying
my goodman furnace keeps restarting continually while trying to get up to set temperature. It runs for a couple of minutes and then restarts again, runs for a couple of minutes and does it again?? I'v… read more
TimVZ26
TimVZ26
Service Foreman
Vocational, Technical or Trade Scho
157 satisfied customers
I Have A Ruud silhoute Thermostat tells unit to heat,purge
I Have A Ruud silhoute Thermostat tells unit to heat,purge comes on,then igniter lites furnce then fan comes on. After the fan blower is on for 10 seconds gas shuts off flames go out, blower still run… read more
Heath Moyer
Heath Moyer
1,064 satisfied customers
My gas furnace has been intermittently stopping. Several times
My gas furnace has been intermittently stopping. Several times the last few days we would wake up to very cold because furnace wasn't running. When we turn thermostat off and on, it comes on immediate… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
This is basicly a continuation on my first question. The
This is basicly a continuation on my first question. The furnace when flame out sends a 4 flash sequence, the controller is cnt03606. I think its responding to a temp limit circuit. It will go out rig… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
my furnace isnt working right it was just blowing cold air
my furnace isnt working right it was just blowing cold air last night when i turned it off waited 5mins and turned it on it would work for a little bit but then the warm air turned cold again today th… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
our LED sensor on our gas furnace blinks a 33 which is a limit
our LED sensor on our gas furnace blinks a 33 which is a limit or a flame roll out switch is open. It is christmas and 16 degrees out side , can I disconnect the flame roll out sensor? I am a electric… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

10,115 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x