HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
Goodman furnace with 4 blinks on red light. I reset the
Goodman furnace with 4 blinks on red light. I reset the limits on both sides and it works for a few minutes blowing heat and then the error code/ 4 blinking red lights return! Any suggestions? … read more
airheatman
airheatman
HVAC Technician
9,703 satisfied customers
Furnace not lighting. Going into lockout mode. Need help!
I have a Gibson kg7sa 072c-24b1 furnace. Over the past year I have experienced several problems and in each case it was a different fault code. 1. pressure switch (replaced switch) 2. flame sensor (re… read more
Rick
Rick
Supervisor
24,947 satisfied customers
my furnace keeps shutting off. I press the reset button, it
my furnace keeps shutting off. I press the reset button, it comes on then reaches the set temp goes off, then wont come back on until I hit the reset button again.… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,264 satisfied customers
Have a roof ac/heater that was installed in 2006-7.
Have a roof ac/heater that was installed in 2006-7. Yesterday found that even though it sounds like the thermostat is clicking The heater is not coming on . I believe this is a America Standard unit, … read more
airheatman
airheatman
HVAC Technician
9,703 satisfied customers
I just read through your help with Jeff. What an adventure.
I just read through your help with Jeff. What an adventure. I have the same background as Jeff, but I sure don't want to go through what he and you went through. I have two York (model P1SPD16N08001A)… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
Hi, I was just reading your prior conversation on the bryant
Hi, I was just reading your prior conversation on the bryant 350aav. I had a similar problem, code 31.. cleaned out the condensation trap and was working well for a few weeks. Today, got code 31 again… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
I have a york furnance the flame would not stay lit, i replaced
I have a york furnance the flame would not stay lit, i replaced the glow bar as it had a crack i replaced the flame sensor as the porcelin was cracked.this furnace fires up stays burning for two minut… read more
rpen7111
rpen7111
119 satisfied customers
I have a Carrier WeatherMaker 8000 2 speed furnace (17 years
I have a Carrier WeatherMaker 8000 2 speed furnace (17 years old). It used to switch into high speed if it took, say more than 10 minutes to bring the room temp. up to the thermostat setting. I have n… read more
Bart Jay
Bart Jay
Vocational, Technical or Trade Scho
Im a residential customer located in New Jersey and in November
I'm a residential customer located in New Jersey and in November of 2009 my HVAC professional replaced my 2nd Floor furnace (my home has 2 zone heating/AC) with a Goodman GMV950453BX 2-Stage natural g… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
Hi, Im trying to reset the limit on my Trane XE-90 furnace.
Hi, I'm trying to reset the limit on my Trane XE-90 furnace. I know it's easy but I can't remember the steps. Any advice?… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
My Bryant furnace is not putting out warm air. I just went
My Bryant furnace is not putting out warm air. I just went and looked at the RED LED status light and it was blinking. After removing both panels and then replacing the top panel, the light remained o… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
I have a Rheem Furnace Model - FGPJ-10EBRJR Serial - EB5D307F199900304 I
I have a Rheem Furnace: Model - FGPJ-10EBRJR Serial - EB5D307F199900304 I have replaced the igniter, flame sensor, and the IFC board. Furnace will still not heat. Induced draft blower motor starts, 5 … read more
Richard
Richard
District Technical Manager
Vocational, Technical or Trade Scho
1,514 satisfied customers
I have a Goodman (Amana) AMV9. The troubleshooting LED indicator
I have a Goodman (Amana) AMV9. The troubleshooting LED indicator is blinking with a 4 flash pattern, which indicates "insufficient conditioned air over the heat exchanger, blocked filters, restrictive… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
768 satisfied customers
carrier series 150, model 58PAV090-14 furnace, serial # 2299A07962.
carrier series 150, model 58PAV090-14 furnace, serial # XXXXX error code 33, blower does not shut off. is this the flame rollout switch and where is it. i don't see a fusable link to check. Is this sw… read more
TimVZ26
TimVZ26
Service Foreman
Vocational, Technical or Trade Scho
157 satisfied customers
I have a Payne PG 8MAA048110 furnace which flashes an LED code
I have a Payne PG 8MAA048110 furnace which flashes an LED code of 33. I purchased a spare limit and flame roll out switch for backup a few years ago. I replaced the flame roll out switch and still had… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I HAVE GOODMAN CETRAL HEATING MODEL NUMBER GMP100-4. ONLY BLOWER
I HAVE GOODMAN CETRAL HEATING MODEL NUMBER GMP100-4. ONLY BLOWER RUNS BUT NO HEAT. I TURNED OFF ELECTRIC CURRENT FROM THE BREAKER, AND TURNED ON, SAME THING. HOW DO I FIND WHAT PART IS BAD? DRAFT INDU… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
my Bryant heater is not working - the led code is #21 - what
my Bryant heater is not working - the led code is #21 - what is involved and what is the cost to fix that problem?… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
Hi, I have an upflow Carrier 58 PAV. I cant get the furnace
Hi, I have an upflow Carrier 58 PAV. I cant get the furnace to run more than 90 seconds, I replaced the control board a last winter, the blower last summer, the flame sensor today, the inducer motor l… read more
Kenton Guidry
Kenton Guidry
HVAC Technician
Vocational, Technical or Trade Scho
963 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,791 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x