HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
, ruud silhouette II ignition cycle beings burners
ruud silhouette II ignition cycle beings burners light up and run for 60-90 seconds or so. have 2 green lights and one yellow and all is good. then the burners shut off prior to the fan coming on. about 30 seconds after the burners turn off the fan turns on … read more
airheatman
airheatman
HVAC Technician
6 years college
9,571 satisfied customers
Hi I own a Ruud Silhouette II (UGPH-05eauer). the fan starts
Hi I own a Ruud Silhouette II (UGPH-05eauer). the fan starts up, the power light stays green the ok light cycles on and off with the fan sometimes is runs for 10 sec sometimes just on and off. I can't… read more
Scott
Scott
Self Employed HVAC Service Technician
Associate Degree
400 satisfied customers
My RUUD Silhouette Gas Furnace will not always come on when
My RUUD Silhouette Gas Furnace will not always come on when the temperature is below the setting. I notice that the "OK" LED is blinking 4 times then pauses. If the "OK" LED is steady, the Gas will co… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Ive got a Ruud Silhouette II that wont ignite. Ive noticed
I've got a Ruud Silhouette II that won't ignite. I've noticed my Inducer motor isn't running but it feels very hot. Blower is blowing. T-stat seems to be working. Just won't ignite. Power and Status L… read more
V12Tech
V12Tech
252 satisfied customers
help find the right LIMIT switch for my gas furnace
I found the model number of my gas furnace ruud silhouette II and I wonder if you can help me find the right limit switch to buy. The model number is XXXXX… read more
caleb
caleb
63 satisfied customers
We just bought a house which has a Ruud Silhouette II furnace
We just bought a house which has a Ruud Silhouette II furnace and I installed a new 3M-30 thermostat. The old thermostat only used a red and a white wire. When I hooked the thermostat up, and the ther… read more
rickyhadaway
rickyhadaway
SENIOR TECH
High School or GED
1 satisfied customers
I have a Ruud Silhouette II and I took off the panels to the
I have a Ruud Silhouette II and I took off the panels to the blower and furnace and I cannot locate any filters. The return air inside the house has a filter of course but I can't find anything inside… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Just bought a house that has both a heat pump and a gas furnace How
Just bought a house that has both a heat pump and a gas furnace How do I know 1) how to switch between heat pump and furnace 2) which one I want to use 3) which one is currently configured to be used … read more
airheatman
airheatman
HVAC Technician
6 years college
9,571 satisfied customers
I have a Silhouette II Ruud ventilation system in my attic
I have a Silhouette II Ruud ventilation system in my attic and it makes a LOT of noice. Any advise as to how to reduce the noice?… read more
Richard
Richard
District Technical Manager
Vocational, Technical or Trade Scho
1,416 satisfied customers
i have a 16 yr old ruud silhouette II gas furnace. the circuit
i have a 16 yr old ruud silhouette II gas furnace. the circuit board inside had been replaced once several years ago,on the board is a set of 4 dip switches all pushed to one side. what are they for?… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Have a RUUD silhouette ii gas furnace. It will not ignite.
Have a RUUD silhouette ii gas furnace. It will not ignite. Have a good gas supply going to it, the exaust blower starts up, after about 30 sec the gas valve clicks and the igniter starts sparking but … read more
Heath
Heath
Vocational, Technical or Trade Scho
1,002 satisfied customers
Ruud Silhouette II ugph 10eamer gas furnace wont start the
Ruud Silhouette II ugph 10eamer gas furnace won't start the burners are not igniting. When I turned the unit back on after cleaning sensors, it made only a humming sound - like it was trying to start … read more
Bill P.
Bill P.
Installer/ Troubleshooter/Technician
286 satisfied customers
My RUUD Silhouette II plus 2 cycles on, but after 3-5 seconds
My RUUD Silhouette II plus 2 cycles on, but after 3-5 seconds of the burners going it shuts off and the blower continues to blow for 30 seconds and then shuts off also.… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have a Ruud Silhouette II plus 2. When it first kicks on,
I have a Ruud Silhouette II plus 2. When it first kicks on, the draft inducer starts, then the electronic ignitors spark. Flame will start, but the burner only stays lit for 10-15 seconds. I noticed t… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
have ruud silhouette II furnace; UTEC IIBC Tech has replaced
have ruud silhouette II furnace; UTEC IIBC Tech has replaced igniter, flame sensor, & thermostat. Unit comes on and heats to set temperature. Flame goes out, but main fan and draft motor continue to r… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have a 15yr old Ruud Silhouette II gas furnace, that has
I have a 15yr old Ruud Silhouette II gas furnace, that has been running fine until last week, when it didn't come on when I turned it on for the first of this season. I eventually replaced the thermos… read more
Rick
Rick
HVAC Supervisor
24,887 satisfied customers
We have a Ruud Silhouette II unit with the AC unit outside.
We have a Ruud Silhouette II unit with the AC unit outside. It looks like a PVC pipe runs from the top unit (on top of the Silhouette unit). Is this a drainage pipe? We have water underneath the unit … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Hi. I have a RUUD Furnace model UGVG-07NAMGR, 75,000 BTU/hr,
Hi. I have a RUUD Furnace model UGVG-07NAMGR, 75,000 BTU/hr, Silhouette series and I have a problem with it continuing to run. The vent motor initially starts then the ignitor glows and then the burne… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x