HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
We have a Trane XE 80 furnance. Recently started having some
We have a Trane XE 80 furnance.Recently started having some problems. First had to replace the blower and capacitor that went out. Next replace the flame sensor.. All seemed to be working fine until t… read more
Rick
Rick
Supervisor
24,971 satisfied customers
Hello, I have a York Diamond 80 upflow furnance and it stopped
Hello, I have a York Diamond 80 upflow furnance and it stopped working today. Just 1 flash on the control board (system lockout). Few days ago it had 7 flashes (low flame sense signal). I tried to pow… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,264 satisfied customers
I have a Goodman GMH8 furnace...the system is currently not
I have a Goodman GMH8 furnace...the system is currently not heating...i have turned the furnace off and back on...the burners ignite a few times but then stop...i have tried turning the gas switch off… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,887 satisfied customers
Janitrol Furnace Blower Motor Runs For A Few Minutes, Won't Ignite
Janitrol furnace won't ignite. Has a new flame sensor. Igniter glows when trying to ignite but nothing happens except blower motor runs for 3--4 minutes and shuts off. Tried to reset by turning switch… read more
airheatman
airheatman
HVAC Technician
9,703 satisfied customers
Amana Air command 80 Heater. Blower turns on, Glow plug lights
Amana Air command 80 Heater. Blower turns on, Glow plug lights bright but 3 or 4 times a week I will not hear the slight click of the gas being fired. The glow plug will keep going bright then off unt… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,887 satisfied customers
Honeywell SV9520 Gas blower controler gives six flashes on
Honeywell SV9520 Gas blower controler gives six flashes on LED and doesn't stay on. It comes on for a second then back off and repeats this four times before completely shutting down. Furnace main out… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
my furnace comes on... the starter glows... then the gas ignites...
my furnace comes on... the starter glows... then the gas ignites... then 6 seconds later when the starter glow wanes, the gas flames just go out... then the same cycle happens about a minute later... … read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a janitrol gas furnace. The inducer motor turns on,then
I have a janitrol gas furnace. The inducer motor turns on,then the ceramic ignitor comes on, then the gas turns on for 3 seconds and goes out. I replaced the flame sensor. The ignitor glows orange sho… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,887 satisfied customers
Amana Air Command 80 Model GUI forced air, natural gas. Works
Amana Air Command 80 Model: GUI forced air, natural gas. Works fine for 10 minutes, but when on longer flame goes out, vent blower contines to run, and unit tries to relight, but fails and red light o… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
Carrier Furnace - Model Number 58PAV090 - 16 will not light
Carrier Furnace - Model Number 58PAV090 - 16 will not light up. I've read through many similar issues that others have posted here and tried most of the suggested fixes with no luck. Heater seemed to … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,887 satisfied customers
I have an amana air command 80 (GSI90A30) the vent blower comes
I have an amana air command 80 (GSI90A30) the vent blower comes on for 30 sec. or so then the igniter comes on but the gas valve does not open consistently to let it lite. Serviceman tried new control… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
I have a armstrong ultra 80 sx furnace. Upon a call for heating,
I have a armstrong ultra 80 sx furnace. Upon a call for heating, everything starts up fine. Then, after about thirty seconds of operation the burners cut out. However, the fan and blower remain on. Th… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have an amana air command 80.... Most years I just need to
I have an amana air command 80.... Most years I just need to clean the flame sensor, this time I did that and everything seems to be working normally except I do not see the element glowing....the is … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,887 satisfied customers
I have a Amana Air command 80sse Furnace The draft motor runs
I have a Amana Air command 80sse Furnace The draft motor runs the igniter glows and then ignites, the burners stay lit for about10- 15 seconds then go out, the furnace will re ignite and stay lit do I… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
I have an amana air command 80 sse gas furnace. my problem
I have an amana air command 80 sse gas furnace. my problem is when the thermastat sends a signal for heat the ignitor comes on then the furnace lights up. after about 10 to 15 seconds the fire goes ou… read more
Kenton Guidry
Kenton Guidry
HVAC Technician
Vocational, Technical or Trade Scho
963 satisfied customers
I have an amana air command high efficiency furnace and the
I have an amana air command high efficiency furnace and the ignitor glows the gas comes on ignites and in a few seconds goes off. It retrys once more same result. This has been going on for a while. S… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Amana furnace mod. GHI45A25, Command 80 wont fire all the
Amana furnace mod. GHI45A25, Command 80 won't fire all the time. I cleaned the burner tray, air flow tube, and flame sensor. The blower comes on, ignighter glows bright, gas valve clicks but no igniti… read more
Jim Eastwood
Jim Eastwood
Lead service
High School or GED
100 satisfied customers
I have an Amana Air Command 80 (gas) that has been acting up
I have an Amana Air Command 80 (gas) that has been acting up lately. It will ignite and heat up most of the time, but will at times, start to ignite and then shut off. I have been able to turn it off,… read more
hvacmrfixit
hvacmrfixit
disabled
Vocational, Technical or Trade Scho
118 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,791 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x