HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

No ignition - how do I get to and change ignitor. Just

Customer Question
No ignition - how...

No ignition - how do I get to and change ignitor

Contractor's Assistant: I'll do all I can to help. How long have you been dealing with this?

Just recently quit igniting

Contractor's Assistant: Do you plan on doing the work yourself?

Yes

Contractor's Assistant: Anything else we should know to help you best?

Not at this time

Submitted: 10 months ago.Category: HVAC
Show More
Show Less
Ask Your Own HVAC Question
Answered in 3 minutes by:
10/4/2017
HVAC Technician: Gaztech, HVAC Technician replied 10 months ago
Gaztech
Gaztech, HVAC Technician
Category: HVAC
Satisfied Customers: 937
Experience: Owner at Gaztech
Verified

Hi I amCustomer a independent technician, I will assist you with your issue.

Don't forget to rate the 5 star rating AT THE TOP OF PAGE after we are done. this will credit me for assisting you.

What equipment do you have?

Ask Your Own HVAC Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a hvac technicianLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Phil Your Own Question
Phil
Phil
Phil, Mechanical Engineer
Category: HVAC
Satisfied Customers: 7,426
7,426 Satisfied Customers
Experience: Retired HVAC/ Electrical & Boiler contractor. Industrial

Phil is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,426 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Related HVAC Questions
The ignitor on my Weber quit working. Changed the battery
The ignitor on my Weber quit working. Changed the battery and still no action. … read more
Bill
Bill
Service Mgr
114 satisfied customers
We have a trance xc95m installed in 2013 and good till this
Hello we have a trance xc95m installed in 2013 and good till this winter. Quit 3 times in the last two months with the igniter burned up. First time igniter had chip out of it, second time a little wh… read more
Gaztech
Gaztech
HVAC Technician
937 satisfied customers
My gas furnace Model 80+AFUE runs for a few days and then
my gas furnace Model 80+AFUE runs for a few days and then quits igniting. All the switches and sensors seem to be functioning. When the thermostat calls for heat, everything starts up okay. The ignigh… read more
Rick the plumber
Rick the plumber
Owner
9,857 satisfied customers
Ignitor glows, gas starts blowing as ignitor is going out,
Ignitor glows, gas starts blowing as ignitor is going out, pilot doesn't light, cycle starts over... Replaced high temp control switch last year. Can u help??… read more
HVAC Guru
HVAC Guru
Service Technician
Associate Degree
682 satisfied customers
I have a 20 year old Rheem furnace with a Honeywell programable
I have a 20 year old Rheem furnace with a Honeywell programable thermastat.Recently on several occasion the furnace has failed to light. The first time I saw the firebox fan was working but the ignite… read more
HVAC Guru
HVAC Guru
Service Technician
Associate Degree
682 satisfied customers
I have a Rheem (Paloma) natural gas tankless water heater that
I have a Rheem (Paloma) natural gas tankless water heater that I installed new myself 3 years ago. It has performed flawlessly until recently when it does not start heating water when the faucet is tu… read more
HVAC Guru
HVAC Guru
Service Technician
Associate Degree
682 satisfied customers
i have a trane xe 80, it quit working in middle of the night..
i have a trane xe 80, it quit working in middle of the night.. i turned ignitor box off, replaced batteries in thermostat.. it cycles through, but does not ignite.. all blowers come on, and after seve… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Green flashing light and furnace wont ignite. The ignitor has
Green flashing light and furnace wont ignite. The ignitor has been replaced recently and they say I may need a new controller board (expensive). Trane XL90. Flashing green light when I looked at the l… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,010 satisfied customers
I have a york Diamond 90 the led diag. board was indicating
I have a york Diamond 90 the led diag. board was indicating open limit switch ( code 4 red blinks ) a tech replaced the limit switch. but the furnace still has an intermitant problem of a mini explosi… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have a 1991 Comfortmaker Furnace model GUH060A012IN that
I have a 1991 Comfortmaker Furnace model GUH060A012IN that will not fire. I have 120 VAC to the ignition but will no 24 VAC to the to the gas valve. Induced fan is running when calling for ignition. I… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
We have a Rheem 90 Plus furnace. It was originally propane
We have a Rheem 90 Plus furnace. It was originally propane and later converted to natural gas. For quite a while we have had an intermittent problem that when the furnace calls for heat, the glow bar … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have had continual problems with the Goodman furnace since
I have had continual problems with the Goodman furnace since installed in Aptil 2007. The blower starts the igniter comes on... no ignition, It cycles 3 times and then locks out. chThey most recently … read more
Tim H
Tim H
Lead building engineer
Vocational, Technical or Trade Scho
1,922 satisfied customers
I have a Lennox G26 furnace , converted for LP/propane with
I have a Lennox G26 furnace , converted for LP/propane with conversion kit 63687B. It is a 100,000 BTUH model (G26Q3/4-100-1. The ignitor is working only some of the time - I get the green LED flahing… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
4,135 satisfied customers
I have a trane XV80 and the furnace quite heating. I check
I have a trane XV80 and the furnace quite heating. I check a the furnace it was blinking 9 time so pulled the ignitor and check with a omh meter I had on a open circut when I touched one lead to the p… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
my lennox whisper quiet gas furn will not ignite. the damper
my lennox whisper quiet gas furn will not ignite. the damper opens,green lite on,igniter fires for 2 min then quits. the green lite slowly flashes after the igniter quits. the unit is about 10yr old. … read more
HVAC_Doug
HVAC_Doug
Vocational, Technical or Trade Scho
I have a ruud silhouette ii that stops at step 6 of the below
I have a ruud silhouette ii that stops at step 6 of the below sequence, so I'm not sure if the gas valve is opening. 1. Draft inducer blower starts. 2. Draft inducer switch proves pressure. 3. Ignitio… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have an amana 80%efficient installed approximately 1988.
I have an amana 80%efficient installed approximately 1988. It had a rotary dial, merc switch thermostat. I recently changed it to a honeywell rth6300b programmable. Since then it does two weird things… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,209 satisfied customers
I have York Diamond 80 furnace that is apprx 15yrs old (model#
I have York Diamond 80 furnace that is apprx 15yrs old (model# XXXXX D16N 09601D). I live in Missouri so it is quite cold now. It often takes 3 or 4 ignition cycles before the burners actually light. … read more
coolman1973
coolman1973
AC/Heat Tech
Vocational, Technical or Trade Scho
162 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x