HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
We have a Trane XE 80 furnance. Recently started having some
We have a Trane XE 80 furnance.Recently started having some problems. First had to replace the blower and capacitor that went out. Next replace the flame sensor.. All seemed to be working fine until t… read more
Rick
Rick
HVAC Supervisor
24,855 satisfied customers
I've got a comfortmaker furnace with a honeywell sv9541
I've got a comfortmaker furnace with a honeywell sv9541 smart valve. When my thermostat calls for heat the exhaust fan comes on, the pilot ignites, and the igniter glows. It goes through this twice th… read more
Rick
Rick
HVAC Supervisor
24,855 satisfied customers
I have a American Standard furnace Freedom 80 that is having
I have a American Standard furnace Freedom 80 that is having problems. It will firs most of the time, but sometimes it just blows cold air. It will eventually fire heat again. It works again if I also… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Trane XR80 Furnace, need help with the 3 blinks red light(too
Trane XR80 Furnace, need help with the 3 blinks red light(too many attempts to ignite)The glow plug is working the unit starts 4 seconds and stops. This goes on until the unit goes into error. What to… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
4,135 satisfied customers
I have a 1-year-old MidcoE200 natural gas furnace forced air
I have a 1-year-old MidcoE200 natural gas furnace forced air burner. Its a converison unit for an oil-fired boiler. Output is setup at approximately 75,000 BTUs as I am on the Oregon Coast and have mi… read more
Tim H
Tim H
Lead building engineer
Vocational, Technical or Trade Scho
1,922 satisfied customers
I have a Model GMS9 converted for propane gas. Its worked
I have a Model GMS9 converted for propane gas. It's worked great for 7 years. When it starts up the gas ignites normally but then shuts off in about 7 seconds and the same cycle repears itself. I've c… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I HAVE A NORDYNE FURNACE (MIMC070ABW) ITS ABOUT 7 YRS OLD .
I HAVE A NORDYNE FURNACE (MIMC070ABW) ITS ABOUT 7 YRS OLD . THE CODE COMING UP IS LOCK OUT DUE TO FAILED IGNITION. I CHECK TO SEE IF IT WAS GETTING GAS UP TO THE FURNACE AND IT IS. WHAT COULD BE THE P… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,010 satisfied customers
my NTI boiler has stopped working. it shows Err 6. when i turn
my NTI boiler has stopped working. it shows Err 6. when i turn it off and then on it cycles through and seems to call for ignition but then the red light flashes 3 time to indicate ignition lockout. w… read more
theplumber717
theplumber717
Plumber
Vocational, Technical or Trade Scho
792 satisfied customers
Thought I had solved the problem of Code 7 "Lockout Caused
Thought I had solved the problem of Code 7 "Lockout Caused by No Ignition After 3 Attempts" by cleaning the flame sensor located on the far right burner (of four) of my late-2003 York Diamond 90 Model… read more
phillipshvac10
phillipshvac10
1 satisfied customers
Our furnance sounds like its firing up, but then it just shuts
Our furnance sounds like its firing up, but then it just shuts off.....It doesnt have a pilot light… read more
ComfortZone
ComfortZone
Associate Degree
485 satisfied customers
I have a payne furnace model #ZIPG9Maa048100ADKA The glow
I have a payne furnace model #ZIPG9Maa048100ADKA The glow plug is only lighting up for about 7 seconds, and the furnace never fires up fully. what would the glow plug part number be? Is that my proble… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,010 satisfied customers
Every once in a while (1 out of 20 times) when the thermostat
Every once in a while (1 out of 20 times) when the thermostat calls for heat the furnace will not create the flame. This symptom started after replacing the original, but broken glow plug with a unive… read more
Heath
Heath
Vocational, Technical or Trade Scho
1,002 satisfied customers
Carrier Furnace - Model Number 58PAV090 - 16 will not light
Carrier Furnace - Model Number 58PAV090 - 16 will not light up. I've read through many similar issues that others have posted here and tried most of the suggested fixes with no luck. Heater seemed to … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have a Trane XV80 natural gas furnace and it has a problem.
I have a Trane XV80 natural gas furnace and it has a problem. The ignitor will glow and the gas will ignite for a couple of seconds and then shut off. This repeats several times and then it will lock … read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
4,135 satisfied customers
I have a 50 gallon Powervent Gas Hot Water Tank about 1 year
I have a 50 gallon Powervent Gas Hot Water Tank about 1 year since install. It has recently developed a starting issue. We found that it had locked out due to too many attempts. I went through the shu… read more
ComfortZone
ComfortZone
Associate Degree
485 satisfied customers
I HAVE A GOODMAN 70,000 BTU 80% FURNACE, ABOUT 4 YEARS OLD.
I HAVE A GOODMAN 70,000 BTU 80% FURNACE, ABOUT 4 YEARS OLD. INTERMITTANT PROBLEM HAS NOW BECOME CONSTANT. FURNACE GOES INTO LOCK OUT AFTER TRYING TO FIRE 3X. WHEN CALLS FOR HEAT, INDUCER FAN STARTS, I… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have Rheem heater RGDD-08NE-GR. Pilot glows, gas is flowing,
I have Rheem heater RGDD-08NE-GR. Pilot glows, gas is flowing, there is ignition however the gas shuts off within a few seconds.… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
i have a carrier furnace model 58MCA. when the stat calls
i have a carrier furnace model 58MCA. when the stat calls for heat, the unit makes 3 attempts to ignite,fails these 3 attempts and the LED gives a 34 error code. i removed the flame sensor and cleaned… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,209 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,426 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x