HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
i have a weather maker 9200 that is kicking out code 31. The
i have a weather maker 9200 that is kicking out code 31. The furnace comes on and tries to blow out heat, but is only successfully like half of the time. any ideas?… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,522 satisfied customers
I have a Philco furnace gas forced hot air system that will
I have a Philco furnace gas forced hot air system that will run can see flame blows cold air and 20 min will shut down , reset at flood switch will do the same… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,522 satisfied customers
My Bryant thermostat has no display, I opened it to look to
My Bryant thermostat has no display, I opened it to look to see if there is a battery, but it doesn't appear so. The furnace sounds operational, but no heat. What do I do to troubleshoot?… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,087 satisfied customers
I have a Bryant model 350 MAV converted to LP and is at 4800
I have a Bryant model 350 MAV converted to LP and is at 4800 ft elevation that has recently started blowing a flame back towards the window in the fire box. This causes the high temp switch to trip an… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,634 satisfied customers
We are receiving error code 31 on a Bryant Model 340 MAV.
We are receiving error code 31 on a Bryant Model 340 MAV. We were able to tinker with the pressure switch and get the furnace to kick on for one full cycle. However, no such luck now and it is minus 1… read more
Appliance Guru
Appliance Guru
19,174 satisfied customers
I have a PAYNE furnace, model PG9MAB (Combustion furnace),
I have a PAYNE furnace, model PG9MAB (Combustion furnace), and I am receiving error code 33. I have tested till I don't know what to test. I have replaced the limit sensor and batteries in the thermos… read more
V12Tech
V12Tech
252 satisfied customers
I have a Payne PG9MAB that is about 2.5 years old. We had
I have a Payne PG9MAB that is about 2.5 years old. We had never had a problem until last night. It was working fine yesterday but overnight it stopped. The red LED is steady on, which appears to be no… read more
joeydelia
joeydelia
HVAC-R Tech supermarket refrigeration
182 satisfied customers
I have a Bryant 90 plus furnace. When I have the T-stat
I have a Bryant 90 plus furnace. When I have the T-stat set to call for heat and turn off, then on again the switch on the side of the furnace, the furnace will cycles and heat. However when it heats … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,522 satisfied customers
Hi. I have an american standard freedom 90 furnace that
Hi. I have an american standard freedom 90 furnace that is not firing up. Whenever power is turned on to the unit, the blower kicks on and runs continuously. When the tstat is in the off position, the… read more
HotWired
HotWired
Industrial Electrician
Associate Degree
154 satisfied customers
I have a Bryant 355 MAV and my system will not blow cold air
I have a Bryant 355 MAV and my system will not blow cold air through the house. The outdoor unit turns on and I get condensation (and eventually ice) on the coolant line but the furnace fan will not t… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
intermittent Carrier Weathermaker 9200 displays a continuous
intermittent Carrier Weathermaker 9200 displays a continuous red led light. What does this mean? How do I know if it is red light 1 or red light 2? Thanks!… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,016 satisfied customers
My Bryant furnace is not putting out warm air. I just went
My Bryant furnace is not putting out warm air. I just went and looked at the RED LED status light and it was blinking. After removing both panels and then replacing the top panel, the light remained o… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,016 satisfied customers
I had a Goodman GMVC95 furnace installed on 12/8/10. I get
I had a Goodman GMVC95 furnace installed on 12/8/10. I get repeated (once a day) E2 codes even after the installer has replaced 2 pressure switces. We have eliminated the combustion air inlet as a pro… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a Goodman LP, Model#GMPN120-5 REVV, Serial #0112609216.
I have a Goodman LP, Model#GMPN120-5 REVV, Serial #0112609216. when I call for heating in either zone thae fan will start but the furnace will not fire. I have gone through the pilot restart instructi… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a Bryant plus 80 with an error code of 3 short blinks
I have a Bryant plus 80 with an error code of 3 short blinks and 1 long blink (31?) Blower comes on and does not ignite, blower runs about 10 minutes and then shuts off. What could be thee issue?… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
I have a Bryant rooftop combo unit which is missing the service
I have a Bryant rooftop combo unit which is missing the service manual and the heating section is dead. The unit has power and natural gas-- mdl # XXXXX and I am getting 9 flashes on the board. What p… read more
Heath Moyer
Heath Moyer
1,065 satisfied customers
I have a Good GMS950504CXA, which runs on propane. It is 3
I have a Good GMS950504CXA, which runs on propane. It is 3 yrs. old. It kicks on & runs for a few minutes, kicks off, then repeats this until the requested temp is reached? What is wrong?, How can I f… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
our 340 MAV CONDENSING GAS FURNACE IS PRESENTLY ON EMERGENCY
our 340 MAV CONDENSING GAS FURNACE IS PRESENTLY ON EMERGENCY HEAT STATUS, CYCLING EVERY TWO HOURS. THE ROLLOUT SWITCH APPEARS TO NOT BE WORKING, BUTTON DOES NOT SEEM TO PRESS/DEPRESS. ERROR CODE IS 31… read more
Bill
Bill
High School or GED
318 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x