HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
Nest Themostat. when I get home and its cold starts out at
Nest Themostat. when I get home and its cold starts out at 62 degrees stays on to 64 degrees then shuts off. Then I have to keep readjusting to get it to above 70 for the night … read more
Patrick
Patrick
Bachelor's Degree
2,591 satisfied customers
I have a comfortmaker furnace (model N9MPD). It works, but
i have a comfortmaker furnace (model N9MPD). It works, but it never gets up to the temperature that the thermostat is telling it. It turns on for about 5 min and then off and then back on again, but a… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,202 satisfied customers
ok originally my goodman furnace model # ***** Gas
ok originally my goodman furnace model # ***** Gas Fired kept tripping off on the roll out switch top left side only. so when I removed the top cover it would stay running. I get 6 flashes stating blo… read more
Comfort Specialist
Comfort Specialist
Mechanical Designer & Estimator
Vocational, Technical or Trade School
1,368 satisfied customers
Ultra 155 goes through ignition cycle....see flame in chamber,
Ultra 155 goes through ignition cycle....see flame in chamber, unit rattles a little, flame goes out. reading 1 54 at start then 2 54 ignite, flame and unit rattles then 6 58 flame goes out.… read more
Rick
Rick
Supervisor
25,511 satisfied customers
I have an American Standard Freedom 90 Single Stage furnace...about
I have an American Standard Freedom 90 Single Stage furnace...about 7 years old. I have had few problems, and nothing wrong yesterday. Last night the outside temps dropped to -9 in Illinois. I woke up… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,375 satisfied customers
Hey, I have a Lennox c33-24B-F. I notice that the furnace
Hey, I have a Lennox c33-24B-F. I notice that the furnace seemed as though it wanted to kick on, but then didnt after about 3 min. I tried to reset ignition switch and restarted. Again, the same thing… read more
hvacexpertjoe
hvacexpertjoe
Electronics Technician
Vocational, Technical or Trade Scho
183 satisfied customers
Hi, I am having a problem getting our main air conditioner
Hi, I am having a problem getting our main air conditioner to function. We have a larger furnace and air conditioner for the larger part of the house and a smaller one for the master bedroom side of t… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
8,202 satisfied customers
I have a York Diamond 80 with the filter in the bottom. I just
I have a York Diamond 80 with the filter in the bottom. I just replaced the filter and cleaned the flame sensor. It has a glow ignition. What happening is that there doesn't seem to be enough gas to i… read more
Scott
Scott
Self Employed HVAC Service Technician
Associate Degree
400 satisfied customers
I have an Amana AirCommand 80. After it reaches temp after
I have an Amana AirCommand 80. After it reaches temp after a power cycle. Blowers shut off fine. then within seconds the exhaust fan or smaller blower kicks on and stays on and heat is no longer gener… read more
Comfort Specialist
Comfort Specialist
Mechanical Designer & Estimator
Vocational, Technical or Trade School
1,368 satisfied customers
I have an Armstrong Ultra SX 80 forced air gas furnace. The
I have an Armstrong Ultra SX 80 forced air gas furnace. The unit tries to turn on, but it seems that it acts as if there's no call for heat as it revs up and then stops after 5 seconds. Technician fro… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
Hi I have a 58PAV gas furnace about 12 years old. The burner
Hi I have a 58PAV gas furnace about 12 years old. The burner keeps cutting our after about 5 seconds, then the air handler cycles and the system resets and then the igniter comers on and the burner fo… read more
Heath Moyer
Heath Moyer
1,064 satisfied customers
Our Trane Furnace was working fine until we turned up the gas
Our Trane Furnace was working fine until we turned up the gas in our gas fireplace for a second last night. We had a strong gas oder and had to air out the house. Then the furnace quit putting out hea… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,962 satisfied customers
I have a 5 ton Maytag central heating furnace with a 3 zone
I have a 5 ton Maytag central heating furnace with a 3 zone control system on it. The system is only about 5 years old. Last year, the safety switch kept turning off the flame, I have to go down stair… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,375 satisfied customers
I have a Trane XE78 furnace thats 17 years old. The burners
I have a Trane XE78 furnace that's 17 years old. The burners aren't igniting so the fan comes on and blows cold air until I shut it off manually at the thermostat or the main switch at the furnace. I'… read more
Heath Moyer
Heath Moyer
1,064 satisfied customers
White-Rogers thermostat is blinking the flame icon. Help
My White-Rogers thermostat is blinking the flame icon. Went away for the weekend, turned it down to 55. Came home Sunday night turned it back up to 66. Monday - gone most day, came home at night notic… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a Coleman Evcon, gas-forced hot air/ac, furnace in my
I have a Coleman Evcon, gas-forced hot air/ac, furnace in my summer home. I would estimate the unit to be 10 to 12 years old, Model G8C07516MUC11A. I check on the house weekly to every other week in t… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,375 satisfied customers
I have a York High Efficiency tubular heat exchanger GY8S
We have had furnace for two years. We lost power last night and furnace has not come back on. There is no pilot with this gas furnace. The furnace will not light. I have tried to cycle several times a… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
I have a Clare Megasave I gas furnace. Last night it stopped
I have a Clare Megasave I gas furnace. Last night it stopped working properly. I went down to the furnace, took the cover off and noticed that the burner would go on and within 15-20 seconds it would … read more
buck3371
buck3371
Vocational, Technical or Trade Scho
22 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,791 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x