HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a quadrafire 1200 pellet stove and the auger stopped
i have a quadrafire 1200 pellet stove and the auger stopped working. i've had this happen once before and replaced the auger and it was fine. i put in a new motor and nogood. so i replaced the vacuum … read more
HVAC Guru
HVAC Guru
HVAC TECH
19,551 satisfied customers
I have a Quadra fire castile the auger stopped working I
I have a Quadra fire castile the auger stopped working I cleaned thoroughly replaced #2 snap disk the vacume switch seems to work correctly same as other snap disks only thing I can think of is the co… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,062 satisfied customers
Quasar fire castile pellet stove , I had to replace the
I had to replace the combustion fan. Once I did it worked great. After it ran for a couple of hours it I went to reload pellets and it tripped GFI breaker. I reset the breaker and nothing. No lights on the control box what so ever. I had to detach wires and re attach in order to get the combustion fan in. I either re connected in correct or when I went to load the pellets I caused something to fry out. I had the side all open where the control box is when I went to load and I must have brushed up against something while doing so. The wire going to to the snap disk near the auger motor looked like it was burned at the terminal. … read more
HVAC Guru
HVAC Guru
HVAC TECH
19,551 satisfied customers
Mount Vernon AE will not feed pellets. Initial error was Min
Mount Vernon AE will not feed pellets. Initial error was Min pot temp, after resetting it said auger jammed. Removed all pellets, cleared auger. Now trys to start up but no pellets will drop. If I put… read more
HVAC Guru
HVAC Guru
HVAC TECH
19,551 satisfied customers
I know very little about pellet stoves. I have a quadrafire
I know very little about pellet stoves. I have a quadrafire pellet stove. It seems to be on, but the auger will not feed. I read a lot of forums about the snap switches, but these snap switches do not… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,968 satisfied customers
my quadrafire pellet stove model mbk has not worked correctly
my quadrafire pellet stove model mbk has not worked correctly since I replaced the exhaust blower a week ago with a fasco motor. it will not drop pellets after the initial start up. It will start and … read more
HVAC Guru
HVAC Guru
HVAC TECH
19,551 satisfied customers
I have a quadra fire castile insert, the lights will not come
I have a quadra fire castile insert, the lights will not come on at all. Have checked connections, thermocouple, replaced control box, checked breakers, and outlet, and still no lights come on. Ideas?… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
Hi, I have a Quadra fire classic bay 1200. Its 3 yrs old and
Hi, I have a Quadra fire classic bay 1200. Its 3 yrs old and has now stopped feeding pellets into the pot. Ive pulled out the auger and did a cleaning just in case there was a jam. Ive bypassed the va… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,968 satisfied customers
Hi Jerry , I have a quadra fire contour pellet stove . We have
Hi Jerry , I have a quadra fire contour pellet stove . We have had it for years . The Stove will work for a few days or nights and then will stop . The call light is on but will not ignite . Changed s… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,968 satisfied customers
Quadra-Fire CB1220-I Pellet Insert Shut off during the night
Quadra-Fire CB1220-I Pellet Insert Shut off during the night and won't start. We have power to the vacuum switch, snap disk #1, snap disk #3 we don't have power to snap disk #2 I jumped the vacuum swi… read more
HVAC Guru
HVAC Guru
HVAC TECH
19,551 satisfied customers
Winslow P140 Pellet Stove Insert Our stove shuts down and
Winslow P140 Pellet Stove Insert Our stove shuts down and red light blinks 2 short blinks. We purchased and installed new fire snap switch, completely cleaned unit and cleared exhaust vent pipe. Auger… read more
Mike R.
Mike R.
3,230 satisfied customers
Im trying to fix a Quadra-Fire 1200 pellet stove, the serial
I'm trying to fix a Quadra-Fire 1200 pellet stove, the serial number is XXXXX It is full of pellets, the thermostat is set high and it is plugged in with correct voltage. The call light is on, but not… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,968 satisfied customers
I HAVE A QUADRA-FIRE SANTA FE PELLET STOVE AND THE AUGER HAS
I HAVE A QUADRA-FIRE SANTA FE PELLET STOVE AND THE AUGER HAS QUIT FEEDING THE FUEL. I HAVE TRIED EVERYTHING FROM TAKING IT APART AND CLEANING IT OUT TO BY-PASSING THE VACUUM SWITCH VIA A PAPER CLIP AN… read more
HVAC Guru
HVAC Guru
HVAC TECH
19,551 satisfied customers
QF 1200 classic bay apron 10 years old replaced auger motor
QF 1200 classic bay apron 10 years old replaced auger motor new style 2 years ago.no power to stove this morning ,happy new year :-(,sourced problem to snap disk 3 pushed reset power on,but one termin… read more
Mike R.
Mike R.
3,230 satisfied customers
Non AE Mt. Vernon Pellet stove that will feed pellets
I have a Quadra Fire Non AE Mt. Vernon Pellet stove that will not feed pellets. I've bypassed the #2 snap disc, cleaned the vacuum tube from the switch to the auger tube, checked the auger and tube fo… read more
MsBabyD
MsBabyD
Senior International Building Inspector
Vocational, Technical or Trade School
60 satisfied customers
Red light is on on the electronic box on my 2005 quadra fire
Red light is on on the electronic box on my 2005 quadra fire pellet stove. the remote does not work. The wheel fan is always on if the unit is plugged in. Squirel cage fan does not work as there is no… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
my feed motor does not come on do I need a new motor or should
my feed motor does not come on do I need a new motor or should I replace the#2 snap ring or ???… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
we have a Lopi pellet stove that keeps over feeding and pellets
we have a Lopi pellet stove that keeps over feeding and pellets spills on to the front of the stove which causes it to go into default mode.We have to clean the stove out 2-3 x' a day. What can we do … read more
tinman
tinman
n/a
Vocational, Technical or Trade Scho
171 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,634 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x