HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
Quadrafire 800 questions. Awhile..its a no run condition
exhaust fan wont shut off when plugged in...stove is polished clean..tested snap disks..unplugged machine and removed control box..plugged back in and no read condition to t-stat… read more
Iohn Keffer
Iohn Keffer
HVAC Tech
Associate Degree
77 satisfied customers
I have a quadrafire 1200 pellet stove and the auger stopped
i have a quadrafire 1200 pellet stove and the auger stopped working. i've had this happen once before and replaced the auger and it was fine. i put in a new motor and nogood. so i replaced the vacuum … read more
Appliance Guru
Appliance Guru
18,649 satisfied customers
I have a Quadra fire castile the auger stopped working I
I have a Quadra fire castile the auger stopped working I cleaned thoroughly replaced #2 snap disk the vacume switch seems to work correctly same as other snap disks only thing I can think of is the co… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
951 satisfied customers
Quasar fire castile pellet stove , I had to replace the
I had to replace the combustion fan. Once I did it worked great. After it ran for a couple of hours it I went to reload pellets and it tripped GFI breaker. I reset the breaker and nothing. No lights on the control box what so ever. I had to detach wires and re attach in order to get the combustion fan in. I either re connected in correct or when I went to load the pellets I caused something to fry out. I had the side all open where the control box is when I went to load and I must have brushed up against something while doing so. The wire going to to the snap disk near the auger motor looked like it was burned at the terminal. … read more
Appliance Guru
Appliance Guru
18,649 satisfied customers
I know very little about pellet stoves. I have a quadrafire
I know very little about pellet stoves. I have a quadrafire pellet stove. It seems to be on, but the auger will not feed. I read a lot of forums about the snap switches, but these snap switches do not… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
My Lennox edv 4035cpm-v propane fireplace has a blower that
My Lennox edv 4035cpm-v propane fireplace has a blower that runs all the time. Is it supposed to have a heat sensor or am I supposed to have it run on a wall switch? Or a dimmer so it will change spee… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
1100 I quadrafire, convection fans stop when stove is hot and
1100 I quadrafire, convection fans stop when stove is hot and running, unit overheats and shuts down, I replaced snap disk 1 , if I turn thermostat down to turn off demand after blowers stopped, they … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
Jerry. I have a quadrafire 1200i. Everything is working properly except I cannot get a
Jerry. I have a quadrafire 1200i. Everything is working properly except I cannot get a flame that goes above the fire pot. The feed rate is set to high. The lights in control box are working properly.… read more
Jerry
Jerry
Service Technician
3,367 satisfied customers
I have a Quadrafire 1100I (approximately 15 years old). Smaller
I have a Quadrafire 1100I (approximately 15 years old). Smaller convection motor does not run. When thermocouple reaches 1000 deg. I here what seems to be a contactor clicking rapidlly and red light o… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
7,807 satisfied customers
I have a quadra fire castile insert, the lights will not come
I have a quadra fire castile insert, the lights will not come on at all. Have checked connections, thermocouple, replaced control box, checked breakers, and outlet, and still no lights come on. Ideas?… read more
Jerry
Jerry
Service Technician
3,367 satisfied customers
My quadrafire 1100 is pluged in and the thermstate is set the red light on the side won�
My quadrafire 1100 is pluged in and the thermstate is set the red light on the side won't turn on I cleaned the stove and checked the fuse. Everything looks good but it won't turn on!!! What should I … read more
Jerry
Jerry
Service Technician
3,367 satisfied customers
Hi, I have a Quadra fire classic bay 1200. Its 3 yrs old and
Hi, I have a Quadra fire classic bay 1200. Its 3 yrs old and has now stopped feeding pellets into the pot. Ive pulled out the auger and did a cleaning just in case there was a jam. Ive bypassed the va… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
We have a Quadrafire 1200-I. But it has stopped working.
We have a Quadrafire 1200-I. But it has stopped working. The pellets were dropping, but it wasn't igniting. We purchased a new ignitor, which we installed, but now it's as though it's not getting powe… read more
Expert
Expert
Quadra-Fire CB1220-I Pellet Insert Shut off during the night
Quadra-Fire CB1220-I Pellet Insert Shut off during the night and won't start. We have power to the vacuum switch, snap disk #1, snap disk #3 we don't have power to snap disk #2 I jumped the vacuum swi… read more
Appliance Guru
Appliance Guru
18,649 satisfied customers
Hi, I have an quadrafire castile insert pellet stove. Last
Hi, I have an quadrafire castile insert pellet stove. Last night it just stopped working. The auger is no longer feeding pellets… read more
AppTech8579
AppTech8579
1,776 satisfied customers
Im trying to fix a Quadra-Fire 1200 pellet stove, the serial
I'm trying to fix a Quadra-Fire 1200 pellet stove, the serial number is XXXXX It is full of pellets, the thermostat is set high and it is plugged in with correct voltage. The call light is on, but not… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
I have an older model Quadrafire 1100i, came when I bought
I have an older model Quadrafire 1100i, came when I bought the house 15 yrs ago. When I plug in the stove, the fan comes on and it ignites, but the fan never turns off. Is this a snap disk 1 or 2 issu… read more
Jerry
Jerry
Service Technician
3,367 satisfied customers
Hi there, we have an older quadrafire 1100i pellet stove.
Hi there, we have an older quadrafire 1100i pellet stove. Wouldn't fire off shortly after vacuuming out the inside, although I'm not convinced we caused the problem by cleaning it. I've been reading o… read more
Jerry
Jerry
Service Technician
3,367 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,791 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x