HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
I have a circa 1987 Dunkirk boiler. Honeywell l8148e
I have a circa 1987 Dunkirk boiler. Honeywell l8148e aquastat and a y8610u replacement kit including the new gas valve and control. Boiler has a power inducer vent. Installed by a pro, and still no he… read more
Brian HVAC Guy
Brian HVAC Guy
HVAC Technician
High School
1,024 satisfied customers
I am sorry must have t the worng button. However, I am
HI, I am sorry must have hit the worng button. However, I am working on the S86H conversion to S8610U3009. I am having some problems with the wire "translation". I am going to have one more test and I… read more
Brian HVAC Guy
Brian HVAC Guy
HVAC Technician
High School
1,024 satisfied customers
I have a heil sp80 furance which doesn't seem to ignite consistently.
I have a heil sp80 furance which doesn't seem to ignite consistently. the inducer motor turns on and the pressure switch clicks and sends signal to the gas valve ,but one time it will fire in about a … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
7,807 satisfied customers
Hi I have a ern402 and Im getting soft lockout ignition
Hi I have a ern402 and I'm getting soft lockout ignition Failure. I have checked gas pressure replaced igniter , cleaned flame sensor , I have 992 ohms on the wire , there are on obstructions on the a… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
Working on my furnace which was not firing except when I asked
Working on my furnace which was not firing except when I asked for higher temp. Or if I switched it off then on. Hmmm...this seemed mechanical so I discovered loose wire in Tstat wiring. Yet after sho… read more
Rick
Rick
HVAC Supervisor
25,129 satisfied customers
I have a carrier furnace model 58GS that burners will not ignite.
I have a carrier furnace model 58GS that burners will not ignite. I am an electrician so I checked all the voltage outputs-I have 120volts to the furnace and 24 volts coming to the circuit board via t… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
We have a Olsen Duomatic HC52 750 (75,000 btu) gas furnace
We have a Olsen Duomatic HC52 750 (75,000 btu) gas furnace in our home. This spring, when we turned on our AC, the burners kept firing when the thermostat called for cool, so we shut off the gas valve… read more
servtech50
servtech50
HVAC/R service tech
296 satisfied customers
I have a Rheem 80 furnace that wont light. The pilot lights,
I have a Rheem 80 furnace that wont light. The pilot lights, but the main burner won't ignite… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
7,807 satisfied customers
I have Munchkin 80 MLP boiler. Error is Ignition failure (4
I have Munchkin 80 MLP boiler. Error is Ignition failure (4 pulses). Manual says," check that the gas valve is operating correctly and the plug is fully connected to the valve (nothing in the schemati… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,087 satisfied customers
I have a Lennox furnace model G24M3/4-100A-2. It worked fine
I have a Lennox furnace model G24M3/4-100A-2. It worked fine till the end of last season, but when 3 days ago I tried to use the heater it didn't work. It starts the ventilator, after while I hear som… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
CAN YOU TELL ME IF I CAN INSTALL A H.S.I. LP SYSTEM CONTROL
***I'M NEEDING TO GET THIS A.S.A.P.*** CAN YOU TELL ME IF I CAN INSTALL A H.S.I. LP SYSTEM CONTROL MODULE 40' FROM THE H.S. INGITOR AND BURNER ASSEMBLIES AND STILL HAVE AN OPERATIONAL FLAME SENSOR FUN… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
7,791 satisfied customers
Coleman Evcon model BGM07512AX burners ignite for about 1 minute
Coleman Evcon model BGM07512AX burners ignite for about 1 minute then shutoff. The ignitor heats back up but burners will not ignite. Then led begins flashing. It flashes 5 times which manual says is … read more
Mike
Mike
Service Tech/ Installer
High School or GED
153 satisfied customers
I have a ruud silhouette ii that stops at step 6 of the below
I have a ruud silhouette ii that stops at step 6 of the below sequence, so I'm not sure if the gas valve is opening. 1. Draft inducer blower starts. 2. Draft inducer switch proves pressure. 3. Ignitio… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
Trane Gas XE60. My pilot lights, but the furnace doesnt fire.
Trane Gas XE60. My pilot lights, but the furnace doesn't fire. None of the breakers are tripped. The fan blows when turned on. Any suggestions?… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
I recently tried to turn on the furnace and the igniter glowed
I recently tried to turn on the furnace and the igniter glowed but the burners did not ignite and the green light started blinking..it worked fine this summer in air conditioner mode...is there a rese… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Hello. Ive got a Payne furnace, with a schematic marked 307758-401
Hello. I've got a Payne furnace, with a schematic marked 307758-401 rev c, whose burner won't start. Its thermostat was disconnected by painters, but I think I've reconnected it as it was. Only 3 wire… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Good Morning, Janitrol 92 (Mfg by Goodman) Model GUN075-3,
Good Morning, Janitrol 92 (Mfg by Goodman) Model GUN075-3, 75,000 BTU, unit equiped with spark ignition & White-Rogers gas control valve with (four) terminals. Symtom: When calling for heat, combustio… read more
Rick
Rick
HVAC Supervisor
25,129 satisfied customers
GOODMAN DOWNDRAFT FURNACE. COULD SMELL GAS, FOUND IGNITOR WAS
GOODMAN DOWNDRAFT FURNACE. COULD SMELL GAS, FOUND IGNITOR WAS BURNED UP. REPAIR MAN CAME OUT AND REPLACED IGNITOR AND MENTIONED THAT THE FLAME WAS NOT JUMPING FROM THE FIRST BURNER, TO THE 2ND TO THE … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
13,875 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,791 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x