HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Ask an Expert,
Get an Answer ASAP!

Related HVAC Questions
I have an older carrier furnace, installed in the 90s. I
I have an older carrier furnace, installed in the 90s. I would like to troubleshoot why my furnace is not reaching the temperature on the thermostat before shutting off. It's a vertical furnace locate… read more
airheatman
airheatman
HVAC Technician
9,555 satisfied customers
We have replaced the ignitor when the the furnace it only
we have replaced the ignitor when the the furnace it only runs for 10 seconds then shuts off … read more
airheatman
airheatman
HVAC Technician
9,555 satisfied customers
I have problems w/ a Coleman DGAA 70 gas furnace. Runs fine
I have problems w/ a Coleman DGAA 70 gas furnace. Runs fine for about 3~4 cycles then I get a green flashing light. Reset switch and runs fine for another 3~4 cycles. Help… read more
HVAC Guru
HVAC Guru
Service Technician
Associate Degree
682 satisfied customers
Having trouble with my furnace. It's electric with a heat pump.
Having trouble with my furnace. It's electric with a heat pump. It will kick on and run for roughly 40 seconds or so, then it will kick off. It will stay off for 1-2 minutes tops. It will go through t… read more
mranswer
mranswer
TECHNICIAN
Bachelor's Degree
481 satisfied customers
I have an Armstrong furnace that does not stay running (heating)
I have an Armstrong furnace that does not stay running (heating) when heat is called for. Model GUH80E 075D14-1A Serial 8499F2551B I have always had the programmable thermostat set to run the fan all … read more
hvac-technician
hvac-technician
Service Manager
Vocational, Technical or Trade Scho
62 satisfied customers
I have a carrier 58MVP furnace it starts up, lights flame and
I have a carrier 58MVP furnace it starts up, lights flame and runs for about 3 minutes then shuts off flame ECM motor runs for 60 seconds and stops. Sometimes the furnace doesn't respond to the thermo… read more
mranswer
mranswer
TECHNICIAN
Bachelor's Degree
481 satisfied customers
I have a Thermal Zone forced air furnace. It runs perfectly
I have a "Thermal Zone" forced air furnace. It runs perfectly for 5-10 minutes on an initial cold start( I shut it off for an hour or longer) then after that it occasionaly will make it through a whol… read more
mranswer
mranswer
TECHNICIAN
Bachelor's Degree
481 satisfied customers
I have a carrier 58gs075-2 furnace. Pilot lights fine and then
I have a carrier 58gs075-2 furnace. Pilot lights fine and then burners light. Fan is supposed to come on shortly after that but does not come on for several minutes untill the overheat circuit is acti… read more
Kenton Guidry
Kenton Guidry
HVAC Technician
Vocational, Technical or Trade Scho
963 satisfied customers
My white rodgers digital comfort set 2, 1F90-51 is malfunctioning
My white rodgers digital comfort set 2, 1F90-51 is malfunctioning it seems. When we set the temp, and press hold temp, it will work initially then it seems to reboot. The screen fades away and then co… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
Lennox high eff. Model g26 gas furnace 11 years old. Problem..unit
Lennox high eff. Model g26 gas furnace 11 years old. Problem..unit not running...no heat Action: - turned everythinh off (power & gas) - waited 20 minutes turned everything back on....nothing happened… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,010 satisfied customers
I have 2 Westinghouse Model FG6RC 080C -12B furnaces in myhouse.
I have 2 Westinghouse Model FG6RC 080C -12B furnaces in myhouse. Duringthe Blizzard last night the intake and exhaust pipes got covered in snow. I cleaned off the pipes and it doesn't look like there … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have a old Lennox furnace with a 13H406 control and a 33f37
I have a old Lennox furnace with a 13H406 control and a 33f37 flame sensor, I have cleaned the sensor because it only runs for 1 and 1/2 min and then flame shuts off and after about 4 min comes back o… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,010 satisfied customers
I have a Lennox Pluse 21 furnace that was installed in 1993.
I have a Lennox Pluse 21 furnace that was installed in 1993. In the past couple months it was begun to run for 5 - 15 minutes and then shut off. In about a minute or so it will stsart up again and run… read more
DuWayne
DuWayne
Sales/ Service
Vocational, Technical or Trade Scho
126 satisfied customers
I was on with Billy on the 23rd. Had the 1985 Bryant gas fired
I was on with Billy on the 23rd. Had the 1985 Bryant gas fired furnace. I replaced the board as recomended. The unit ran great for about 2-1/2 days. Now it has quit again. The fan will work in the on … read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
I have a 1985 model Bryant gas fired furnace with AC. The blower
I have a 1985 model Bryant gas fired furnace with AC. The blower does not want to shut off unless I shut off the power disconnect to the furnace and it is also cycling on and off in heating. It runs f… read more
Billy
Billy
Journeyman Service Technician
State Licensed Mechanical Contractor
9,330 satisfied customers
My furnace prematurely shuts off. The ignition sparks and
My furnace prematurely shuts off. The ignition sparks and lights the pilot. A few moments later the burners all light. A few moments later the blower starts. The furnace then runs for about 3 minutes … read more
coolman1973
coolman1973
AC/Heat Tech
Vocational, Technical or Trade Scho
162 satisfied customers
Why does my gas furnace cycle when my thermostat is set at
Why does my gas furnace cycle when my thermostat is set at 70 degrees and the temperature is 73 degrees? It cycles every 3 seconds for approximately 10 or 15 minutes. It sounds as if it is trying to k… read more
coolman1973
coolman1973
AC/Heat Tech
Vocational, Technical or Trade Scho
162 satisfied customers
I have a 9 yr old Amana 90 Air Command Furnace, Model CCA42FDC,
I have a 9 yr old Amana 90 Air Command Furnace, Model CCA42FDC, Serial # XXXXX When thermostat calls for heat, the furnace ignites and lights, when the blower starts, it either runs for several minute… read more
HVAC22
HVAC22
Residential Service Team Supervisor
High School or GED
32 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

7,426 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,024 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Rick Ridley

Rick Ridley

UK Heating Engineer

871 satisfied customers

Retired But have had 30 years on the tools, Ex CORGI

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x