HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a sure heat natural gas fireplace. The set is in the
I have a sure heat natural gas fireplace. The set is in the firebox of an older wood burning stove. Just moved into the house. When I finally got the pilot light lit, the burner started up fine. The f… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,381 satisfied customers
I have an AS Freedom90 that was installed without intake
I have an AS Freedom90 that was installed without intake filters about 7 years ago. This year I figured out how to put a 16x20 filter in the opening and have had some ignition failures. I had a tech c… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,426 satisfied customers
I have a reproducible problem with my gas furnace. Lennox G20Q3E-75-4,
I have a reproducible problem with my gas furnace. Lennox G20Q3E-75-4, newer ignition control unit Honeywell S8610U. This is set up with separate spark and flame sense electrodes. The burner box has a… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
have a Bryant/carrier built Model #398aaw036080d plus 90 furnace
have a Bryant/carrier built Model #398aaw036080d plus 90 furnace have been working on for awhile, started with the 3 wire igniter/ pilot light was not sparking tapped on it and then received a spark w… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,118 satisfied customers
I have a rheem 1x200..it wont ignite but goes through
I have a rheem 1x200..it won't ignite but goes through the rest of cycles..internal small fan starts up and the blower starts up after a few attempts and runs for a few and then shuts off. Gas is on t… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,265 satisfied customers
becket honeywell r7184b have to start furnace by pushing red
becket honeywell r7184b have to start furnace by pushing red button.it will run then shut off again with light flashing half second intervals.… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,381 satisfied customers
I have a Kenmore Power Miser 80 furnace. Its having trouble
I have a Kenmore Power Miser 80 furnace. It's having trouble heating the house as of two days ago. Here are the symptoms: Thermostat calls for heat. Exhaust fan comes on. Ignitor clicks, gas comes on,… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,118 satisfied customers
I have a payne furnace model #ZIPG9Maa048100ADKA The glow
I have a payne furnace model #ZIPG9Maa048100ADKA The glow plug is only lighting up for about 7 seconds, and the furnace never fires up fully. what would the glow plug part number be? Is that my proble… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
here is a question for all you clever people out there as I
here is a question for all you clever people out there as I am stumped I have an ariston a23 boiler, from cold it lights up ok and runs for about 20 min then the reset button comes on it shuts down bu… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
I have a day & night furnace model 394JAZ036065. It will just
I have a day & night furnace model 394JAZ036065. It will just stop working but works again by simply turning the electric power switch off and back on. I don't know how to diagnose which part is bad.… read more
Bill
Bill
High School or GED
318 satisfied customers
my lennox whisper quiet gas furn will not ignite. the damper
my lennox whisper quiet gas furn will not ignite. the damper opens,green lite on,igniter fires for 2 min then quits. the green lite slowly flashes after the igniter quits. the unit is about 10yr old. … read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,118 satisfied customers
Bard Furnace. Small exhaust fan comes on, igniter starts sparking
Bard Furnace. Small exhaust fan comes on, igniter starts sparking with what looks like a good spark to me, but 70% of the time it won't light the natural gas. Gas flow is then shut off and small exhau… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
i have a gmt & gmth power vented multi position gas furnace.
i have a gmt & gmth power vented multi position gas furnace. my thermostate is set on 70 and the house isnt warming up at all the temp is lowering now it is down to 61 what can i do… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,381 satisfied customers
it all started with a transformer melt down a wire was shorted
it all started with a transformer melt down a wire was shorted direct to ground before the control board and needed to be replaced. however before i tested for 24vac i pulled the control board out and… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,381 satisfied customers
Rheem Criterion II gas furnace main burner will not stay lit
My Rheem Criterion II gas furnace main burner will not remain lit. What should I check first?… read more
coolman1973
coolman1973
AC/Heat Tech
Vocational, Technical or Trade Scho
162 satisfied customers
I have a Tempstar 9000 M mul075bg03 the burner stays on for
I have a Tempstar 9000 M mul075bg03 the burner stays on for 20 sec. and cycles on & off. I have jumped all the switches one at a time,replaced the control module and the igniter & cleaned the ground t… read more
coolman1973
coolman1973
AC/Heat Tech
Vocational, Technical or Trade Scho
162 satisfied customers
I have a Goodman gas furnace with an electric ignitor that
I have a Goodman gas furnace with an electric ignitor that glows, the gas burner ignites, burns for approx. 10 seconds, shuts off and then cycles back on in approx. 20-30 seconds. The fan runs constan… read more
coolman1973
coolman1973
AC/Heat Tech
Vocational, Technical or Trade Scho
162 satisfied customers
I have an Air Ease Ultra SX 80 furnace that is 12 years old.
I have an Air Ease Ultra SX 80 furnace that is 12 years old. The T-stat calls for heat, the HSI(hot start igniter) gets yellow hot, the pilot light starts burning, the FS(flame sensor) gets red hot, a… read more
Ronald
Ronald
Consultant
Bachelor's Degree
4 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x