HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a jandy 250 lite2 millivolt gas propane heater for my
hi,' I have a jandy 250 lite2 millivolt gas propane heater for my pool and spa. It goes to full flame BUT powerful yellow flames are shooting up into the wiring in the chamber above( never happened be… read more
Rick
Rick
Supervisor
29,107 satisfied customers
I have furnace and showing code 33 and after 3-4 mins of
i have bryant furnace and showing code 33 and after 3-4 mins of just blower fan running the code changes to 13 … read more
Rick
Rick
Supervisor
29,107 satisfied customers
I have a Raypak 266a pool heater. It heats fine, but I want
I have a Raypak 266a pool heater. It heats fine, but I want to be sure the pressure switch which shuts the heater down if there is no water pressure works. I tested it by turning the adjusting knob cl… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
I have a raypak 406 nat electronic swimming pool heater and
I have a raypak 406 nat electronic swimming pool heater and its make a gargling noise. Almost like water is boiling. Pressure on system is ideal at 19psi. any idea on what that could be?… read more
Rick
Rick
Supervisor
29,107 satisfied customers
I have a Payne furnace, Model PG9MAB, 1.5 years old, its worked
I have a Payne furnace, Model PG9MAB, 1.5 years old, it's worked fine up until now, but yesterday it would not kick the burners on, I removed the power for over three hours, then when power was applie… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,258 satisfied customers
I have a Model 600 sears wall furnace cira 1970(NNN) NNN-NNNN65000
I have a Model 600 sears wall furnace cira 1970(NNN) NNN-NNNN65000 input BTU,has worked great in my camp, last couple times I used it noticed the subsequent time it recycled I noticed fire what I call… read more
servtech50
servtech50
HVAC/R service tech
296 satisfied customers
My BRYANT 310AAV/JAV Is not giving out heat fan is continuously
My BRYANT 310AAV/JAV Is not giving out heat fan is continuously running just changed filters code changed from 13 to 33 after i took panel off now what can I do to get the heat back.… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,258 satisfied customers
Our church is currently operating with a 20+ year old Weben-Jarco
Our church is currently operating with a 20+ year old Weben-Jarco boiler and we have received estimates from four different contractors to replace the 500 KBTU boiler. One estimate is for the Raypak M… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
hello I have a carrier weathermaker 9200 The furnace will
hello I have a carrier weathermaker 9200 The furnace will blow cold air and it will flash code 33- limit or flame rollout switch. I turn off furnace and manually reset limit switch and the furnace wil… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,433 satisfied customers
We have an older (1992) Austroflamm Integra FS pellet stove
We have an older (1992) Austroflamm Integra FS pellet stove that came with the house and is in its first winter's use. We are very pleased with the stove with the exception of one recurring problem wi… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
I have a Raypak 151,00 BTU natural gas heater that is approximately
I have a Raypak 151,00 BTU natural gas heater that is approximately 20 years old. It does not heat the water. I inspected the burners and they seem to all be working and the heat exchanger is not plug… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
I keep getting the flow fault indicator on my Hi-E2 pool heater.
I keep getting the flow fault indicator on my Hi-E2 pool heater. I can keep the heater going by jumpering the venturi pressure switch and removing the jumper right after the gas valve kicks on. The bu… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
I have an 18 yr old XL80 Trane (with 7 burners and 2 speed
I have an 18 yr old XL80 Trane (with 7 burners and 2 speed fan). I had 2 licensed HVAC techs to my home because the thermostat would say "Heat ON" but it was not on. This was happening at least 1x/day… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
American Standard YCC030F1M0BB keeps losing flame rollout
American Standard YCC030F1M0BB keeps losing flame rollout sensor. Air flow is good through heat exchanger (anemometer reading matches other units on site) supply blower seems like it is good. I have o… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,118 satisfied customers
Have a Heil GasPack year 1992 (Model P6AA60G1K1) - runs well
Have a Heil GasPack year=1992 (Model P6AA60G1K1) - runs well except the system shuts off due i think to thermocouple sensor sensing too hot surface above burners (... system will not shut off when cov… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,410 satisfied customers
Ref GMPN 100-4 , s/n XXXXXXXXXX (condencing/high effiency
Ref: GMPN 100-4 , s/n XXXXXXXXXX (condencing/high effiency furnace). Initial problem, draft unducer motor failed and roll out limit opened. Action: replaced draft unduction assenbly & reset roll out s… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,410 satisfied customers
I have a goodman GMH95/GCG9 Furnace. Just installed today.
I have a goodman GMH95/GCG9 Furnace. Just installed today. When I tried to call for heat for the first time, the fan turned on, then the burners turned on and 3 seconds later it turned off giving me 6… read more
Jim Eastwood
Jim Eastwood
Lead service
High School or GED
100 satisfied customers
I had a unit that appeared to have a bad roll out switch.
I had a unit that appeared to have a bad roll out switch. I changed it, it ran for 1 day and is out again. How can I check to see how much air the inducer motor should be moving?… read more
Rick
Rick
Supervisor
29,107 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x