How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask TimVZ26 Your Own Question
TimVZ26, HVAC Technician
Category: HVAC
Satisfied Customers: 157
Experience:  6 Years exp. Nate Cert. in Air-to-Air Heat Pumps, Lots of Bryant/Carrier exp.
Type Your HVAC Question Here...
TimVZ26 is online now
A new question is answered every 9 seconds

luxaire 90 % furnace induced draft limit switch opens , 4 flashes

This answer was rated:

luxaire 90 % furnace induced draft limit switch opens , 4 flashes , hi limit ok furnace is about 2 yrs old
make sure that the venting is clear and that the motor is also running at full speed, there also may be a drainage problem plugging the venting causing your problem
Customer: replied 7 years ago.
vent seems up to speed also if not furnace should shut down via air flow sw. and if drain was clogged . it takes an hr between failures will recheck .
ok, check it out because sometimes there will be a slight blockage and will let enough pressure through to make pressure switch but still not enough to vent properly. The other thing that may be is gas pressure may be overtired however I would more likely to expect a limit switch trip rather that a vent limit trip
TimVZ26 and 2 other HVAC Specialists are ready to help you