How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Roy Your Own Question
Roy
Roy, Import/Domestic Specialist
Category: Honda
Satisfied Customers: 5861
Experience:  ASE Master Tech
3506196
Type Your Honda Question Here...
Roy is online now
A new question is answered every 9 seconds

I'm replacing 2007 Honda CR-V AC clutch/coil without

Customer Question

I'm replacing 2007 Honda CR-V AC clutch/coil without removing compressor. Ordered/received kits. Today, I couldn't get the pulley off with pulley puller. Had to remove compressor. Still couldn't get pulley off. Yes, I removed the snap ring. Finally got
it off with chisel and hammer. WOW!!! Bearing came out with clutch pulley. There is no bearing in the kit. It looks like it was supposed to stay attached to the compressor. Any ideas!!!
Submitted: 2 years ago.
Category: Honda
Expert:  Roy replied 2 years ago.
good afternoon my name is ***** ***** I will assist
no, the bearing stays with the pulley. it presses out of the pulley and gets pressed into the replacement part. when you re install the pulley, use some vasoline or lubricating grease on the shaft of the compressor.
Roy
Customer: replied 2 years ago.
There's no mention of a bearing in the procedures or the drawings. Very important part i would think.
Customer: replied 2 years ago.
It looks like the bearing was attached to compressor housing. Maybe rust or corrosion.
Expert:  Roy replied 2 years ago.
yes it is but it is transferable from the old pulley to the new one.
Roy
the inner race get dirt or corrosion on the shaft making it difficult to remove
Roy
Expert:  Roy replied 2 years ago.
how are you making out???
Customer: replied 2 years ago.
Had to go to work. I'll deal with it in the morning.
Expert:  Roy replied 2 years ago.
ok, I will be back on around noon est
Roy