Home Improvement

Home improvement questions? Ask a handyman for answers

Connect one-on-one with {0} who will answer your question

Related Home Improvement Questions
My washing machine is 2 1/2 to 3 years old, It stopped
It stopped pumping out and spinning I have had the repair man twice hi has replaced the pressure release on door and cleaned out all filters and pimps . it ran one cycle the the code E1 F 9 appeared again ,he can back again pumped out water , it started and then stopped after washing . not pumping out and door will not open until we get water out . I am very upset over a NEW washer breaking down . my repair man is stumped . I am requesting a call from a technician to throw a light on this … read more
Mark M
Mark M
Appliance Repair Technician / Handyman
Bachelors
1,810 satisfied customers
I'm getting f7 e1 code on my maytag bravos MCT mvwx655dw1.
I'm getting f7 e1 code on my maytag bravos MCT mvwx655dw1. I've changed the acuator. I was getting I was getting f2e1 code also but after I cleared the codes and ran test it went away. But still getti… read more
Austin
Austin
12,023 satisfied customers
I have a Kenmore model 110.21302013 (Whirlpool), that goes
I have a Kenmore model 110.21302013 (Whirlpool), that goes completely through the wash cycle, until drain/spin, when it stops. We find the "cycle complete" light on, but the clothes are still wet, hav… read more
Austin
Austin
12,023 satisfied customers
We have just installed an AO 35,000 grain water softener. A
We have just installed an AO Smith 35,000 grain water softener. A plumber installed it. We don't have soft water after even three days. The screen indicates that water is flowing through the system. I… read more
Appliance Guru
Appliance Guru
21,760 satisfied customers
Re: Maytag MVWX655DW) - The inner tub or basket hub seems to
re: Maytag MVWX655DW) - The inner tub or basket hub seems to be in pretty good shape and I don't see any broken or worn teeth. The spline on the shaft appears good. There isn't any slop when the hub i… read more
Mark M
Mark M
Appliance Repair Technician / Handyman
Bachelors
1,810 satisfied customers
I have a GE water softener, only about 2 years old. Noticed
I have a GE water softener, only about 2 years old. Noticed very low water pressure so put softener in by-pass and water pressure returned. Have been exploring options - took venturi apart and cleaned… read more
Appliance Guru
Appliance Guru
21,760 satisfied customers
Dremel model 395 quit working. Cannot plug in and run. Have
Dremel model 395 quit working. Cannot plug in and run. Have completely dismantled several times, all seem ok. Could it bean issue with brushes? … read more
Mark M
Mark M
Appliance Repair Technician / Handyman
Bachelors
1,810 satisfied customers
I have a Kenmore Water Softening system that is about 15
I have a Kenmore Water Softening system that is about 15 years old. I went to add pellets to the system, as I do on a regular basis and saw that the water level is very high. I could not add the salt … read more
Rick
Rick
Supervisor
29,233 satisfied customers
My dishwasher never seems to have hot water due to the lag
My dishwasher never seems to have hot water due to the lag time to supply hot water in between cycles as the DW calls for water. Is there an adjustment to make to my RL75 tankless unit? … read more
Machinc
Machinc
Retired
1,137 satisfied customers
We have a Aqua Logic controller and the check system light
We have a Aqua Logic controller and the check system light has been on for some time. We have changed the chlorinator, the probes have been cleaned and it is still on. It us a salt pool. … read more
David Bowden
David Bowden
Owner
3,570 satisfied customers
I have a Culligan Platinum series water softener that is approximately
I have a Culligan Platinum series water softener that is approximately 5 years old. I started having problems after recently cleaning out the brine tank. ( I don't know if the problem is related to th… read more
Marc
Marc
Master plumber, oil burner technician
Vocational, Technical or Trade Scho
1,590 satisfied customers
Genie GS 1930 is very slow moving in drive no fault codes
Genie GS 1930 is very slow moving in drive no fault codes displayed Battery voltage is 25 volts. Not sure if it is supposed to beep when driving. Up and down functions work correctly. It is just movin… read more
AssuredElectrical
AssuredElectrical
Electrical Contractor
High School or GED
3,844 satisfied customers
I installed a new drive gear. It will not go into down position
I installed a new drive gear. It will not go into down position to reattach chain. Opener model # XXXXX… read more
Stephen Cutler
Stephen Cutler
Registered Residential Contractor
licensed residential contractor
1,851 satisfied customers
I have a door handle assembly on an exterior door with a bro
I have a door handle assembly on an exterior door with a broken latch. I've removed the inside and outside handles but due to small broken parts, can't remove the latch to open the door. Hoping to get… read more
Martin
Martin
Electrical Engineer
Bachelor's Degree
789 satisfied customers
I have a craftsman opener model 139.53963SRT. The door began
I have a craftsman opener model 139.53963SRT. The door began going back up at the end of the cycle like it was trying to close too far. I have adjusted the opener with the adjustment screws on the sid… read more
Stephen Cutler
Stephen Cutler
Registered Residential Contractor
licensed residential contractor
1,851 satisfied customers
whom it concerns have a kenmore dryer (11066742500) - less
whom it concerns: have a kenmore dryer (11066742500) - less than 2 yrs old - drum turns, but no heat and dryer won't shut off. I've been through owner's manual and installation instructions and tried … read more
Stephen Cutler
Stephen Cutler
Registered Residential Contractor
licensed residential contractor
1,851 satisfied customers
i have an Amana wash machine, modle LW8303W2. It appears ...
i have an Amana wash machine, modle LW8303W2. It appears that the motor works in the wash mode or at least it doesn't stop at this phase. Just before the rince or spin mode(when the tub is full of wat… read more
The Home Smithy
The Home Smithy
Home Builder
Vocational, Technical or Trade School
2,084 satisfied customers
I have a Dacor raised vent system model RV46 designed to ...
I have a Dacor raised vent system model RV46 designed to exhaust cooking odors from a gas range. It raises automatically from the top of the counter and the blower comes on when the UP/Down button is … read more
Glenn
Glenn
Maintenance, Technician
Associate Degree
1,612 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Thank you for the expeditious answer. It's good to know you're out there and awake in the wee hours when I finally have time to ask questions about my Jenn Air.

JeanRiverhead, NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

Brian

Brian

Architect

2,153 satisfied customers

Licensed Architect- 17 years, L.E.E.D. AP

The Home Smithy

The Home Smithy

Home Builder

2,084 satisfied customers

#1 Home Improvement Expert 30+ years experience

Steve G.

Steve G.

Handyman

229 satisfied customers

VP of electronic repair company and home theater advisor.

StructuralEng

StructuralEng

Civil Engineer

15 satisfied customers

Licensed Structural Engineer

Eric M. Bright

Eric M. Bright

We Don't Comprehend the Word Can't!

1,734 satisfied customers

I've been been doing things for my clients that others have said cant be done for over a 1/4 Century

Phil

Phil

Mechanical Engineer

789 satisfied customers

Retired contractor, 51 years experience

Martin

Martin

Electrical Engineer

789 satisfied customers

Design, construct, fix and grow stuff around and in the home.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x