Heavy Equipment

Heavy equipment repair questions? Ask an Expert now.

Connect one-on-one with {0} who will answer your question

Related Heavy Equipment Questions
HI,I have a propane powered van and it runs great..my van..hill
HI, I have a propane powered van and it runs great at idle or speeds below 35 mph. my van cannot travel at Speeds above 35 or up any hill at more than 25 mph. But if at a stop you can gun the engine a… read more
Curtis B.
Curtis B.
service manager
Associate Degree
2,364 satisfied customers
FORK..LIFT IS RUNNING A WHILE AND THEN IT QUITS LIKE IT..FUEL LINE
MY CLARK FORK LIFT IS RUNNING A WHILE AND THEN IT QUITS LIKE IT IS OUT OF GAS. BUT THE PROPAINE TANK IS FULL. ALSO THE VALVE IS OPEN.I NOTICED THE FUEL LINE IS ICING UP. I NEVER SEEN IT DO THIS BEFORE… read more
Jeff
Jeff
High School or GED
325 satisfied customers
Mitsubishi: regulator..solenoid..all cylinders, new cap..intake
I have a mitsubishi forklift engine model 4G54 that runs on propane. my original problem was it would only idle when I put a load on it it would stall. I replaced the regulator , all fuel lines ,fuel … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,227 satisfied customers
I have an older Clark Propane Forklift that has a J&S 9model
I have an older Clark Propane Forklift that has a J&S 9model 600) two diaphram low pressure regulator on a four cylinder engine. It has been running great and ran out of fuel, I had the tank filled an… read more
Jeff
Jeff
High School or GED
325 satisfied customers
Nissan: forklift..engin RPM running high the choke moved
We have Tailift forklift model FG18P with Nissan 4 sylinders engin. When engin RPM running high the choke moved up and down and make the RPM unstable. What problem it could be? Karl… read more
Jeff
Jeff
High School or GED
325 satisfied customers
225 dodge: cylinder..engine starts..I push the gas pedal..hoses
I am working in a forklift (yale)which it has a 225 dodge propane gas engine(6 cylinder). well the engine starts without any problems, but when I accelerate and I push the gas pedal it does not accele… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,227 satisfied customers
I have a 1977 Hyster H50 propane powered forklift. We had
I have a 1977 Hyster H50 propane powered forklift. We had a cold snap recently and when I tried to start it once it warmed up to 30 degrees or so, it would fire but not run. I replaced plugs, wires, d… read more
Curtis B.
Curtis B.
service manager
Associate Degree
2,364 satisfied customers
Forklift..wont stay..you hold the ignition to start position
clark propane forklift will turn over but wont stay started unless you hold the ignition to start position.… read more
Curtis B.
Curtis B.
service manager
Associate Degree
2,364 satisfied customers
Reverse..i release clutch the shuttle box forward slips to neutral
forward/reverse shuttle box with 5 speed trans bolted on. this is on a clark forklift and has a clutch. When i release clutch the shuttle box forward slips to neutral. what causes this.… read more
Jeff
Jeff
High School or GED
325 satisfied customers
Forklift..carburetor..The inside linkage that is spring loaded..pull
I own a Clarke C 500 Y 45 forklift. One of my employees removed the carburetor to clean it and now we can't figure out the linkage situation. The inside linkage that is spring loaded wants to pull the… read more
Jeff
Jeff
High School or GED
325 satisfied customers
Crank..dip stick..The low oil pressure alarm was sounding after I
Came in to work to find my Clark forklift would not crank, it was turning over fine. Checked the oil and none was showing on the dip stick. The low oil pressure alarm was sounding after I tried to cra… read more
Jeff
Jeff
High School or GED
325 satisfied customers
tranny slips..there an adjustment anywhere to tighten up the slippage
I need a service manual for a Clark LPG 25B. My tranny slips something awful. Is there an adjustment anywhere to tighten up the slippage?… read more
Jeff
Jeff
High School or GED
325 satisfied customers
Toyota: cylinder..block..I can put vacuum to regulator and it starts
I have a 4 cylinder toyota forklift running on propane that is hard to start. I can block air getting into the air cleaner and it starts every time. If it's cold I can put vacuum to regulator and it s… read more
Jeff
Jeff
High School or GED
325 satisfied customers
Weak brakes on my clark forklift. E brake is fine. Where should
Weak brakes on my clark forklift. E brake is fine. Where should I start? Thanks, XXXXX XXXXX PA… read more
daves71
daves71
Service Manager
High School or GED
668 satisfied customers
Hyster 90xm forklift(propane). The motor wont start. Its
Hyster 90xm forklift(propane). The motor won't start. It's firing good. I think its flooding out. Sometimtimes it will try to to start after I turn the fuel off. I just rebuilt the regulator. The old … read more
CaseFace
CaseFace
High School or GED
168 satisfied customers
shut off in my shop..It runs but the trans will not engage.
I have a clark GCSMB and the other day it was shut off in my shop, and when it was started it would not move. It runs but the trans will not engage.… read more
Diesel Pro
Diesel Pro
diesel tech
Vocational, Technical or Trade Scho
38 satisfied customers
I have an old Allis Chalmers forklift that runs on propane.
I have an old Allis Chalmers forklift that runs on propane. In very cold weather it will fire right up but after running for a minute or two it dies and is very difficult or impossible to get it runni… read more
daves71
daves71
Service Manager
High School or GED
668 satisfied customers
to idle and the Check Engine Light will come on..turn engine
1. CAT GC25K, S/N AT82DO1760 Sometimes when you are driving forklift it will go to idle and the Check Engine Light will come on. If you stop and turn engine off and back on the forklift well return to… read more
Rudolph Diesel
Rudolph Diesel
Service manager/ Master mechanic
Vocational, Technical or Trade Scho
1,918 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Chris (aka - Moose)

Chris (aka - Moose)

Technician

124 satisfied customers

24 years of experience diagnosing & repairing

Tim

Tim

Foreman

338 satisfied customers

23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry

Cat Man

Cat Man

Caterpillar Engine Expert

3,777 satisfied customers

23 Years Caterpillar Engine experience.

Wayne

Wayne

Journeyman

3,227 satisfied customers

34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.

DR.Cummins

DR.Cummins

FIELD SERVICE TECHNICIAN

2,389 satisfied customers

16 Years working on Cummins Diesel engines,

Curtis B.

Curtis B.

service manager

2,364 satisfied customers

30 years exp. with diesel engines, heavy equipment and forklifts, including lp forklifts

Don

Don

Mechanic

553 satisfied customers

35 years experience journeyman mechanic transport truck and trailer including off road equipment

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x