Heavy Equipment
Heavy equipment repair questions? Ask an Expert now.
Connect one-on-one with {0} who will answer your question
Answered in 4 hours by:
1/15/2017
DR.Cummins, FIELD SERVICE TECHNICIAN
Category: Heavy Equipment
Satisfied Customers: 4,512
Experience: 16 Years working on Cummins Diesel engines,
VerifiedAs per Cummins book time is 1.4 hrs. Please don't forget to Accept/Rate my service.
Manufacturer KENWORTH
Model Series T600
Group 11 - Exhaust System
Procedure 607 - EGR Valve - Remove and Install
11-607
EGR Valve - Remove and Install Service
Total labor is 1.4 hrs
Manual)
Includes:
-Disconnect and connect batteries
-Drain and fill coolant
-Remove and install:
. Air intake pipe
. CAC connection
. EGR valve coolant lines
. EGR valve
-Operate Engine until Thermostat Opens to Check
for Leaks, Proper Operation and Correct
Fluid Levels
DR.Cummins, FIELD SERVICE TECHNICIAN
Category: Heavy Equipment
Satisfied Customers: 4,512
Experience: 16 Years working on Cummins Diesel engines,
VerifiedDR.Cummins and 87 other Heavy Equipment Specialists are ready to help you
How JustAnswer works
Describe your issueThe assistant will guide you
Chat 1:1 with a technicianLicensed Experts are available 24/7
100% satisfaction guaranteeGet all the answers you need
Related Heavy Equipment Questions
We put a Cummins N14 Celect Plus 525 in a 2010 Kenworth. We
we put a Cummins N14 Celect Plus 525 in a 2010 Kenworth. We got the wiring harness and the datalink processor all hooked up and everything works, all the gauges jakes everything. the only problem we a… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
Hello, I have a 2003 Kenworth with a Cummins ISX pre-egr and
Hello, I have a 2003 Kenworth with a Cummins ISX pre-egr and the truck has low fuel pressure. We have changed all fuel actuators, both fuel pumps, replaced all injectors and replaced all fuel lines go… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
2006 Kenworth T600 with Cummins ISX is having an intermittent
2006 Kenworth T600 with Cummins ISX is having an intermittent firing problem. We have been trying to pin point the problem for months already. We had it checked at Kenworth last week. The only problem… read more
spankyjr1
Retired
Vocational, Technical or Trade Scho
420 satisfied customers
Volvo: cummins..hills, turbo farts or coughs at lower rpms, idles
I have 06 Volvo w/ cummins ISX and getting code MID 128 PID 412 FMI 0. We are being told that we need new turbo. symptoms are brownish smoke, low power on hills, turbo farts or coughs at lower rpms, i… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
cummins isx..oil pressure..check engine light and shutdown..oil filter
I got a 2010 pete 388 with a cummins isx motor with 130,000 on it. About 6 mnths ago the truck would start to lose oil pressure 150 hrs into a 300 hour service interval to the point the check engine l… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
NO LEAKS..OIL NOT IN trans guages NORMAL WHATS GOING ON NEED HELP
I HAVE A 2004 KENWORTH T600 I LOSE WATER DURING DAILY USE HAVE TO PUT IN THREE GALLONS OF WATER EVERY MORNING BEEN PRESURE TESTED NO LEAKS NO SIGNS OF WATER NOT IN OIL NOT IN TRANS GUAGES NORMAL WHATS… read more
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,308 satisfied customers
I have a 2005 KW with ISX # 79047117 PID 131 FMI 4 and PID
I have a 2005 KW with ISX # XXXXX PID 131 FMI 4 and PID 27 FMI 4 all my resources don't cover egr engines, truck idle eratic.… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
cummins isx 2004..05 international 9200 268 rears..mil
cummins isx 2004-05 international 9200 268 rears 10 speed getting about 4.8 fuel,how can i get better fuel mil… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
electronics to replace an egr isx cummins s/n 14046387..kenworth
what do I have to do to the electronics to replace an egr ISX cummins s/n 14046387 with a non egr model s/n 14038472 it is in a 2003 Kenworth truck… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
A 2004 KW with an ISM and 10spd eaton auto shift..vibration..exhaust
I have a 2004 KW with an ISM and 10spd eaton auto shift. When under a load I have a vibration thru the engine. Also it sounds like it is going BA BA BA thru the exhaust at this time. The EGR valve was… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
Diff..bad low er rpms until chk eng lite came on steady (code 27
2005 Kenworth W900L w/ISX400 - inactive codes 411 & 412; active code 27 (egr diff press high) does that make sense? what would be the most likely part to be failing/have failed with these codes? was l… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
i have 07 9400 International 475 cummins ISX 890,000km when
i have 07 9400 International 475 cummins ISX 890,000km when under 1300rpm and loaded there is alot of black smoke out exhaust engine warning light comes on for 3-4 seconds and goes out if truck is res… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
Blowing..dark grey smoke and rattling and idling rough..isx..cummins
my 2005 kenworth w900 is blowing dark grey smoke and rattling and idling rough it has a isx cummins in it can you give me any ideas as to what might be going on?… read more
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,308 satisfied customers
according: aftermarket suppliers for egr Valves..if the manifold..ecm
Are there any aftermarket suppliers for EGR Valves for cummins engine ISX 400 HP according to the dealer valve's are not serviceble? if the manifold beteween parts is leaking can this be repaired also… read more
Andy
truck /coach technician
Vocational, Technical or Trade School
214 satisfied customers
black smoke..dpf..on new doser, new egr valve, ran overhead, all tests
This is in reference to a T-660 2008, cummins ISX, motor that has been in the shop several times. It is currently smokes with black smoke but does not use oil. Cleaned DPF,put on new doser, new EGR va… read more
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
4,512 satisfied customers
Isx..three egr valves and an egr cooler in in the last 3 years
I have a 2004 kw t600 with the isx motor. I have put three egr valves and an egr cooler in in the last 3 years. I put a new air to air cooler in 2 weeks ago. Now the egr just went again. I need to mak… read more
JCTech
Technical Specialist
Vocational, Technical or Trade Scho
352 satisfied customers
2004 cummins isx 400hp over 600000 mi on it, only drove it
2004 cummins isx 400hp over 600000 mi on it, only drove it bobtail and its like 5 mi a galon on average. hooked a trailer to it and it was bellow 4 mi a gallon. Took it to a cummins crosspoint in nash… read more
Heath
Service Tech
Diesel technology
62 satisfied customers
Check engine light..KW T-300 with a Cummins ISC..cruise control
I hate to bother anyone, but how can I check the check engine light codes on a 2006, KW T-300 with a Cummins ISC 8.3L? I was told to turn the key on, engine off, and hold the cruise control in the res… read more
Heath
Service Tech
Diesel technology
62 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
JustAnswer in the News:
Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.
What Customers are Saying:
I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.
Elm City, NC
used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.
Richmond, TX
9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.
Marysville, CA
Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.
Walnut Creek, CA
As a single woman, I really appreciate an excellent and affordable opinion.
Charleston, WV
Thank you Geordie, I will not hesitate to contact justanswer in the future!
Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.
Castleberry, FL
Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.
Freshfield, Liverpool, UK
< Previous | Next >
Meet the Experts:
Chris (aka - Moose)
Technician
133 satisfied customers
24 years of experience diagnosing & repairing
Tim
Foreman
338 satisfied customers
23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry
Cat Man
Caterpillar Engine Expert
3,777 satisfied customers
23 Years Caterpillar Engine experience.
Wayne
Journeyman
3,308 satisfied customers
34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.
Curtis B.
service manager
2,404 satisfied customers
30 years exp. with diesel engines, heavy equipment and forklifts, including lp forklifts
DR.Cummins
FIELD SERVICE TECHNICIAN
4,512 satisfied customers
16 Years working on Cummins Diesel engines,
Don
Mechanic
553 satisfied customers
35 years experience journeyman mechanic transport truck and trailer including off road equipment
< Previous | Next >
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
