Heavy Equipment

Heavy equipment repair questions? Ask an Expert now.

Connect one-on-one with {0} who will answer your question

hello im working on 1999 rv diesel pusher 8.3 cummins. eng # 45674114…

Customer Question
hello im working on 1999...
hello im working on 1999 rv diesel pusher 8.3 cummins. eng # XXXXX died on hwy and no start. was towed to me. pull codes cummins insite. 277 and 276. click test on icv shows activated but no click sound. front and rear pump valve can hear click. ohm out stator o.4 ok. inspected ecm pin connections ok. possible icv valve or tran suppressor, have suppressor cut out not sure how to test. can you help
Submitted: 10 years ago.Category: Heavy Equipment
Show More
Show Less
Ask Your Own Heavy Equipment Question
Answered in 14 minutes by:
6/7/2012
Technician: sevn103, Journeyman replied 10 years ago
sevn103
sevn103, Journeyman
Category: Heavy Equipment
Satisfied Customers: 275
Experience: Cummins,International certified diesel mechanic
Verified
I would replace the transient suppressor , and the icv, the suppressor isolates the surges from the icv, if the icv is not clicking it has failed but you should replace the suppressor as well
sevn103
sevn103, Journeyman
Category: Heavy Equipment
Satisfied Customers: 275
Experience: Cummins,International certified diesel mechanic
Verified
sevn103 and 87 other Heavy Equipment Specialists are ready to help you
Ask your own question now
Customer reply replied 10 years ago
can you tell me where the icv is located and how long it takes. access is difficult on this one. im not familiar with this system. any pics would help and is there a test for failure for the suppressor so i can show ex warr.
Customer reply replied 10 years ago
Relist: Answer came too late.
working on 1999 8.3 cummins not familiar with this system where the icv is located on the pump any pics would help or explain. Relist: Answer came too late.
working on 1999 8.3 cummins not familiar with this system where the icv is located on the pump any pics would help or explain.
Customer reply replied 10 years ago
can you tell me where the injection control valve is located on the caps fuel pump. i need to replace it. not familiar with this system. its on a 1999 8.3 cummins access is difficult and about how long it takes to r/r it. any pics would help
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a technicianLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask sevn103 Your Own Question
sevn103
sevn103
sevn103, Journeyman
Category: Heavy Equipment
Satisfied Customers: 275
275 Satisfied Customers
Experience: Cummins,International certified diesel mechanic

sevn103 is online now

Related Heavy Equipment Questions
Cummins ISC 8.3L SN: 45761879 CAPS Fuel System in Case IH
Cummins ISC 8.3L SN: 45761879 CAPS Fuel System in Case IH MX240 Service call on a tractor that ran fine when shut off for the evening, and next morning no start condition. Fault code 277 was #1 on the… read more
Nich1019
Nich1019
Diesel Technician
Vocational, Technical or Trade School
57 satisfied customers
2001 freightliner isc fault code sid 18 fmi 7 says fuel control
2001 freightliner isc fault code sid 18 fmi 7 says fuel control vl system not responding. just quit when driving down the road . it is a fl60 model.… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
2001 sterling 7500 with a 8.3 isc with a caps injection pump
2001 sterling 7500 with a 8.3 isc with a caps injection pump wont start at all died on road… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
Had starter control valve replaced, cost 3000$ and now light
Had starter control valve replaced, cost 3000$ and now light is flashing again and starts slow. Only 600 mi sense Repair.… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
I have a Cummins ISC with a no start issue. Engine cranks
I have a Cummins ISC with a no start issue. Engine cranks and fires randomly. The lift pump is running engine rpm is present. When the unit came in it had an engine rpm code and a controller 2 code. A… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
my truck..2001 peterbilt with cummins..air filter..fluid it wont start
hi,maybe you can help me with my truck problem. i have 2001 peterbilt with cummins isc 8.3 315 hp. the problem is with the hot engine start. when the engine is cold it starts right away with no proble… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
I HAVE A ISC CUMMINS WITH FAULT CODES 0278 ,0277,AND 0276,
I HAVE A ISC CUMMINS WITH FAULT CODES 0278 ,0277,AND 0276, HAVE GOOD FUEL SUPPLY . BUT NO START… read more
sevn103
sevn103
Journeyman
275 satisfied customers
engine codes..there were 2 fault codes..engine controller..low fuel
Hi, I have a Freightliner with a 8.3 litre Cummins engine.The engine will not start, it turns over fine but will not fire.I had the engine codes scanned and there were 2 fault codes one was for the en… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
cummins isc with the caps fuel pump..vehicles..faulty..fault codes
Hi I work at a bus company we run a fleet of enviro 400 with cummins isc with the caps fuel pump. they are all around 6 years old.just recently started having start problems. all the vehicles pop and … read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
2001 newmar rv..I changed the heads..last engine check..fault code
I have a 2001 Newmar RV with an ISX cummins engine. I changed the heads and put a turbocharger on it. At the last engine check up they found the fault code #277 inactive 42 times. What does this mean … read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
cummins..getting a amber check engine light..injector control valve
I have a transit bus with a 8.3 cummins and I am getting a amber check engine light with a 276 code which is high current coming from injector control valve… read more
sevn103
sevn103
Journeyman
275 satisfied customers
Hi Dr cummins I have a 8.3 with a 276 check engine code and I
Hi Dr cummins I have a 8.3 with a 276 check engine code and I need some assistance can you please help… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
An 8.3 cummins engin that wont start..injection..control valve
I have a 2000 FL70 with an 8.3 cummins engin that won't start. The code that shows is 276 injection control valve stator ciruit. I have not found a problem with the solinoid valve any suggestions what… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
Cummins..an Injector Control Valve or pump..voltage..white smoke
I have a 300 HP Cummins ISC engine........ Cummins came out and read the following codes.........277X1 and 539 Both Have something to do with the Injector Control Valve..... Cummins repairman said he … read more
Clayton
Clayton
Technician
Vocational, Technical or Trade Scho
627 satisfied customers
A cummins isc 8.3liter engine..warning light..under load..acceleration
I have a 2001 blue bird q-bus with a cummins isc 8.3liter engine. it recently started surging heavily at idle and will flash the stop eng light or eng warning light under load or heavy acceleration, o… read more
Joel Bos
Joel Bos
909 satisfied customers
I have a Cummins ISC 8.3 with a CAPS pump in a Case ag tractor
I have a Cummins ISC 8.3 with a CAPS pump in a Case ag tractor that has an intermitant low power issue possibly related to heat. After about 4 to 5 hours of consistant running it starts throwing codes… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
Cummins..Rough idle and misses throughout rpm range
I have a 2001 FL70 with 207432 miles, Cummins 8.3 ISC 225. Rough idle and misses throughout rpm range. Changed all injectors and still experiencing this problem. Had a friend with a prolink and got SI… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,389 satisfied customers
A CAPS Cummins injection pumps leaking..rotor..fault code..leaks
I have A CAPS Cummins injection pumps leaking from small rotor holes located over delivering rotor fittings when the machine reach working temperature and 277 code is displayied, I am not sure if the … read more
JCTech
JCTech
Technical Specialist
Vocational, Technical or Trade Scho
352 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Chris (aka - Moose)

Chris (aka - Moose)

Technician

127 satisfied customers

24 years of experience diagnosing & repairing

Tim

Tim

Foreman

338 satisfied customers

23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry

Cat Man

Cat Man

Caterpillar Engine Expert

3,777 satisfied customers

23 Years Caterpillar Engine experience.

Wayne

Wayne

Journeyman

3,257 satisfied customers

34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.

DR.Cummins

DR.Cummins

FIELD SERVICE TECHNICIAN

2,389 satisfied customers

16 Years working on Cummins Diesel engines,

Curtis B.

Curtis B.

service manager

2,375 satisfied customers

30 years exp. with diesel engines, heavy equipment and forklifts, including lp forklifts

Don

Don

Mechanic

553 satisfied customers

35 years experience journeyman mechanic transport truck and trailer including off road equipment

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x