Heavy Equipment
Heavy equipment repair questions? Ask an Expert now.
Connect one-on-one with {0} who will answer your question
Answered in 10 minutes by:
7/14/2011
ebnel, Technician
Category: Heavy Equipment
Satisfied Customers: 282
Experience: master certification diagnostics and repair
VerifiedCustomer:
Hello and Thank You for selecting Just Answer,Get back with me if you need more help after reading my answer. Suspect you still have internal leakage or weak transmission pump. One thing you can try is leaving tractor run with cold oil And without moving any functions and check temperature of steering, rockshaft,selective control valves,loader valve. see if anything heats up. any component heating up would indicate internal leakage. This checks out ok,pto,hi/lo or trans pump either leaking or weak. Would need to perform pressure checks to verify pump is ok.
JACUSTOMER-aava9k5y- : already tgis the only thing that heats up is the steering but i am having no problems with steering would this be normal
ebnel, Technician
Category: Heavy Equipment
Satisfied Customers: 282
Experience: master certification diagnostics and repair
Verifiedebnel and 87 other Heavy Equipment Specialists are ready to help you
How JustAnswer works
Describe your issueThe assistant will guide you
Chat 1:1 with a technicianLicensed Experts are available 24/7
100% satisfaction guaranteeGet all the answers you need
Related Heavy Equipment Questions
hi can someone help me I have john deer 240 skidsteer just
hi can someone help me I have john deer 240 skidsteer just brought it there where no oil in hyduralic I add oil but the bucket will not go up no down it will tilt back and foward… read more
Rudolph Diesel
Service manager/ Master mechanic
Vocational, Technical or Trade Scho
1,918 satisfied customers
4010 john deere that the 3-point lifts very slowly. The shop
4010 john deere that the 3-point lifts very slowly. The shop manual shows an adjustment screw for lowering speed and one for the raising speed. I have adjusted these to no avail. the 3-point lifts hea… read more
Kevin
2 years John Deere Tech school
235 satisfied customers
JOHN DEERE 1630, HYDRAULIC PUMP TURNING, STEERING WORKING,
JOHN DEERE 1630, HYDRAULIC PUMP TURNING, STEERING WORKING, LOADER LIFTS VERY SLOWLY => i JUST CHANGED THE FILTER AND CHECKED THE SCREEN AT BACK OF TRANSMISSION. WHERE ELSE CAN i CHECK?… read more
ebnel
Technician
High School or GED
282 satisfied customers
john deere tractor that the 3 point hitch goes..levers
i have a john deere tractor that the 3 point hitch goes up when you start it up but can't get it to go down again. i have to turn it off for it to bleed down . i can't get it down with the levers. is … read more
ebnel
Technician
High School or GED
282 satisfied customers
John Deere..The loader creeps up and the bucket creeps..oil filter
I have a 4010 John Deere that I put a loader on. The loader creeps up and the bucket creeps down. I took my supply from a T by the brake peddles and return to the hydraulic oil filter. My power beyond… read more
Kevin
2 years John Deere Tech school
235 satisfied customers
Hello, i own a JD 3520 compact tractor with the power reverser.
Hello, i own a JD 3520 compact tractor with the power reverser. The machine has been at the dealer for 78 of it's 150 hour life so far. The problems are all hydraulic in nature. So far the tractor has… read more
tj
Bachelor's Degree
457 satisfied customers
The hydraulic control lever for tilting the bucket..tractor..rod
The hydraulic control lever for tilting the bucket of the John Deere model 175 loader on my John Deere tractor, Model 2440, is not working. I think the cable needs to be replaced, but I cannot remove … read more
Jeff
High School or GED
325 satisfied customers
John deere..valves..the steering and brakes still work
Hi I have a 1973 john deere 4630, for many hours sometimes a half a day the hydraulics work fine, then all of a sudden without warning the rear hydraulics valves will quit working but the steering and… read more
ebnel
Technician
High School or GED
282 satisfied customers
My 1963 1010 John Deere tractor bucket has diminished lifting
My 1963 1010 John Deere tractor bucket has diminished lifting capacity after 10 minutes or so of use. What my potential problems be?… read more
Don
Mechanic
Vocational, Technical or Trade Scho
553 satisfied customers
Next time..the tractor would not pull in the lower 4 gears
Help, I have a 4840 tractor that has a transmission problem.It worked find last time I used it (worked good in all gears). Next time I went to pull (couple weeks later), hooked up and the tractor woul… read more
Tyler
High School or GED
14 satisfied customers
I have a john deere 440 tractor..hydraulics..changing
I have a john deere 440 tractor. Not too many hours ago I lost the function of the hydraulics. After changing the filter, and the Y filter, new fluid it has operated less than 100 hours. The hydraulic… read more
Jeremy
Field Tech.
High School or GED
62 satisfied customers
drops down..down even..control or the hydraulic cylinders
I inhereted a John Deere 950 tractor with a front loader. The bucket drops down even without anything in the bucket. Do I need to replace/repair the control or the hydraulic cylinders?… read more
dd85
Service Manager
20 years Service Manager at Dealersh
227 satisfied customers
We have JD 4440tractor with a265 loader and a 3 point..hitch..half way
we have JD 4440tractor with a265 loader and a 3 point hitch the hydralics were all working fine. all at once the 3 point hitch and the loader stopped working. The loader islocked up in the half way up… read more
John
tech
Vocational, Technical or Trade Scho
112 satisfied customers
Hydraulic rotary tiller for John Deere 455 tractor, What Tiller
Hydraulic rotary tiller for John Deere 455 tractor, What Tiller will work on my 455 compact tractor with the Hydraulic pump that attaches to the front PTO output that is the OEM PTO? Also any of the n… read more
northern mechanic
Vocational, Technical or Trade Scho
52 satisfied customers
John Deere 300B w/front loader,power steering,3 point hitch,
John Deere 300B w/front loader,power steering,3 point hitch, and reverser. I need to know which hydraulic lines to tap into to add auxiliary hydraulics to utilize hydraulic equipment on the 3 point hi… read more
John
tech
Vocational, Technical or Trade Scho
112 satisfied customers
Tractor..the hydraulic system the steering column..pushes
Tractor = 1963 4010 ; problem = when applying pressure to the hydraulic system the steering column pushes up approximately 1/8 inch and hydraulic oil squirts out around the steering shaft.… read more
Eric
John deere tech.
Vocational, Technical or Trade Scho
50 satisfied customers
I have a JD 955 tractor. I was dragging a tree stump with my
I have a JD 955 tractor. I was dragging a tree stump with my gannon in the raised position when I heard a pop and now the rear implement lift wont raise. I can raise and lower it by hand but the hydra… read more
John
tech
Vocational, Technical or Trade Scho
112 satisfied customers
I have a john deere 1520 tractor, the hydraulics..power steering..lift
i have a john deere 1520 tractor, the hydraulics are not working properly. the power steering, and hydraulics will not go up steadily, the tractor will sit there dead and than after a few minutes it w… read more
Rudolph Diesel
Service manager/ Master mechanic
Vocational, Technical or Trade Scho
1,918 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
JustAnswer in the News:
Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.
What Customers are Saying:
I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.
Elm City, NC
used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.
Richmond, TX
9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.
Marysville, CA
Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.
Walnut Creek, CA
As a single woman, I really appreciate an excellent and affordable opinion.
Charleston, WV
Thank you Geordie, I will not hesitate to contact justanswer in the future!
Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.
Castleberry, FL
Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.
Freshfield, Liverpool, UK
< Previous | Next >
Meet the Experts:
Chris (aka - Moose)
Technician
133 satisfied customers
24 years of experience diagnosing & repairing
Tim
Foreman
338 satisfied customers
23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry
Cat Man
Caterpillar Engine Expert
3,777 satisfied customers
23 Years Caterpillar Engine experience.
Wayne
Journeyman
3,308 satisfied customers
34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.
Curtis B.
service manager
2,404 satisfied customers
30 years exp. with diesel engines, heavy equipment and forklifts, including lp forklifts
DR.Cummins
FIELD SERVICE TECHNICIAN
2,392 satisfied customers
16 Years working on Cummins Diesel engines,
Don
Mechanic
553 satisfied customers
35 years experience journeyman mechanic transport truck and trailer including off road equipment
< Previous | Next >
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
