Heavy Equipment
Heavy equipment repair questions? Ask an Expert now.
Connect one-on-one with {0} who will answer your question
Answered in 2 days by:
4/6/2011
Adam Sntr, Technician
Category: Heavy Equipment
Satisfied Customers: 68
Experience: John Deere, Ag equiptment, Diesel engines, Hydraulics, Electronics
VerifiedYou can use the tractor hydraulics but you would have to add a power beyond valve to the tractor. Also you need to make sure that the valve you are using now is an open center valve. You sometimes can borrow power from the three point on these tractors but it requires a valve to do this. I have seen some tractors with a front mounted auxiliary pump that runs off the front engine pulley. If the tractor has an existing auxiliary rear remote you can simply tie into its supply and add another stack valve to operate the loader.
Adam Sntr, Technician
Category: Heavy Equipment
Satisfied Customers: 68
Experience: John Deere, Ag equiptment, Diesel engines, Hydraulics, Electronics
VerifiedAdam Sntr and 87 other Heavy Equipment Specialists are ready to help you
How JustAnswer works
Describe your issueThe assistant will guide you
Chat 1:1 with a technicianLicensed Experts are available 24/7
100% satisfaction guaranteeGet all the answers you need
Related Heavy Equipment Questions
I have an old mf 300 backhoe. We broke the tie rod or connecting
I have an old mf 300 backhoe. We broke the tie rod or connecting link bar on the front end.It bent the hydraulic pump shaft. I cannot see how the shaft comes apart from the flange at the crankshaft en… read more
Curtis B.
service manager
Associate Degree
2,404 satisfied customers
hydraulic..front end..power steering going good brakes going
case895xl rear hydraulic wont go down front end loader wont go up power steering going good brakes going… read more
Curtis B.
service manager
Associate Degree
2,404 satisfied customers
I cannot access through pto lever plate as there are hyd.
I want to change hyd. filter om a MF 165. I cannot access through PTO lever plate as there are hyd. lines attached to it. Is there any other way to access filter short of breaking tractor in two? Is t… read more
Curtis B.
service manager
Associate Degree
2,404 satisfied customers
How to install aux.hyd. to a MF 231 for rear equip.what do
How to install aux.hyd. to a MF 231 for rear equip.what do i need in parts and funds to install these parts… read more
dd85
Service Manager
20 years Service Manager at Dealersh
227 satisfied customers
Ram..ton..I am trying to find out where to connect the hydraulic hose
I purchased a ram splitter log splitter, 3 point, 16 ton. I am trying to find out where to connect the hydraulic hose… read more
dd85
Service Manager
20 years Service Manager at Dealersh
227 satisfied customers
64 h.p. 2005, with 200 hours, all maintenance has been performed
I have a JD 5303 with 64 h.p. 2005, with 200 hours, all maintenance has been performed on schedule. The rockshaft will not raise or lower so that I can attach implements. The tractor is used for sherd… read more
ebnel
Current Certified Master technician
High School or GED
251 satisfied customers
I HAVE A JOHN DEERE 2750 TRACTOR WITH CAB LOADER FRONT WHEEL
I HAVE A JOHN DEERE 2750 TRACTOR WITH CAB LOADER FRONT WHEEL ASSIST.IT HAS HYDRAULIC PROBLEMS , IT DOES NOT SEEM TO DESTROKE, WE PUT A NEW REMAN PUMP ON IT ,WE RE SEALED AND CHECKED THE CHARGE PUMP,RI… read more
tj
Bachelor's Degree
457 satisfied customers
L300: hydraulic..hyd..I know that Kubota sells a kit but it
I want to attatch a hydraulic grapple to my L3400. Can I use the hyd port on the Right side of the transmission for the grapple thumb. I know that Kubota sells a kit but it's a bit pricy. I want to ma… read more
Benjy
Bachelor's Degree
273 satisfied customers
I have a 1250 MF backhoe which I..Loader..cylinder
I have a 1250 MF backhoe which I just installed a new "Brand LV22" Loader valve. I purchased a power beyond cartridge and I want to install a remote 3 way valve to operate a single acting cylinder for… read more
Curtis B.
service manager
Associate Degree
2,404 satisfied customers
my ford 6640 85 hp has only 3960 hours loses power after 15
my ford 6640 85 hp has only 3960 hours loses power after 15 to45 minutes.when cold performs excellently,frontend loader lifts a tonne.sometimes goes okay for two hours but when pulling it loses power … read more
ebnel
Current Certified Master technician
High School or GED
251 satisfied customers
A new clutch after remounting the cab and connecting hydraulics..lift
I removed the cab off my mf285 and installed a new clutch after remounting the cab and connecting hydraulics I can't make the lift to work . Oil is flowing but seemingly not enough .Could something be… read more
ebnel
Current Certified Master technician
High School or GED
251 satisfied customers
operating manual shows me where to hook into the tractors hydraulics.
I have a B6100E tractor and a 748A snowcaster. Neither operating manual shows me where to hook into the tractor's hydraulics. Can you help? A picture would be great! Thanks.… read more
Benjy
Bachelor's Degree
273 satisfied customers
Excellent: which is a 2005 model mf 451 4wd..Tires..Seat..lights work
I am looking for a +/- value of my tractor which is a 2005 Model MF 451 4wd: Please advise using the following: Tractor Specs: Condition of Tractor Excellent Geographic Region North Central Texas Tire… read more
daves71
Service Manager
High School or GED
668 satisfied customers
Blew..tractor..you can turn the steering or pick up the lift
I live in Thailand and bought a Kubota m105s 2-1/2 years ago, first the back end got so hot it blew off the filler cap at the back end along with hydraulic oil, then the casing above the top link spli… read more
Benjy
Bachelor's Degree
273 satisfied customers
I own a 2006 Massey Ferguson Model 451 that is a 4wd tractor
I own a 2006 Massey Ferguson Model 451 that is a 4wd tractor with 52 HP That snapped in Half. Is there any other like models that have done the same thing? I have also researched looking for other 200… read more
Benjy
Bachelor's Degree
273 satisfied customers
I have a 1965 John Deere 2020 which I had a hydraulic leak
I have a 1965 John Deere 2020 which I had a hydraulic leak ( someone used a piece of regular rubber hose for a connection in the fron to the main pump and it blew). I replaced the piece of rubber hose… read more
mike
Vocational, Technical or Trade Scho
109 satisfied customers
Hydraulic..the back of the tractor for the loader,but i..stick
I have a tn70 newholland with a 32la loader. I was wanting to hook up a 3pt post driver(hydraulic) and not sure how to hook the inlet and return on the hydraulics of the driver.I have the hookups on t… read more
dd85
Service Manager
20 years Service Manager at Dealersh
227 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
JustAnswer in the News:
Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.
What Customers are Saying:
I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.
Elm City, NC
used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.
Richmond, TX
9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.
Marysville, CA
Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.
Walnut Creek, CA
As a single woman, I really appreciate an excellent and affordable opinion.
Charleston, WV
Thank you Geordie, I will not hesitate to contact justanswer in the future!
Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.
Castleberry, FL
Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.
Freshfield, Liverpool, UK
< Previous | Next >
Meet the Experts:
Chris (aka - Moose)
Technician
133 satisfied customers
24 years of experience diagnosing & repairing
Tim
Foreman
338 satisfied customers
23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry
Cat Man
Caterpillar Engine Expert
3,777 satisfied customers
23 Years Caterpillar Engine experience.
Wayne
Journeyman
3,308 satisfied customers
34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.
Curtis B.
service manager
2,404 satisfied customers
30 years exp. with diesel engines, heavy equipment and forklifts, including lp forklifts
DR.Cummins
FIELD SERVICE TECHNICIAN
2,392 satisfied customers
16 Years working on Cummins Diesel engines,
Don
Mechanic
553 satisfied customers
35 years experience journeyman mechanic transport truck and trailer including off road equipment
< Previous | Next >
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
