Heavy Equipment
Heavy equipment repair questions? Ask an Expert now.
Connect one-on-one with {0} who will answer your question
Answered in 12 hours by:
7/22/2010
Greg Torseth, Mechanic
Category: Heavy Equipment
Satisfied Customers: 82
Experience: Over 15 years of Agriculture and Construction Equipment repair expierence . Factory Trained
VerifiedIt sounds like you had a transmission failure. Pull your hyd and trans filters and cut them open. If you see brass or clutch material you will know. Your best bet is to get the tractor to a dealer to have them run some diagnostic tests.
Greg
How JustAnswer works
Describe your issueThe assistant will guide you
Chat 1:1 with a technicianLicensed Experts are available 24/7
100% satisfaction guaranteeGet all the answers you need
Related Heavy Equipment Questions
I have a deere 5403 tractor. Power Steering gradually became
I have a john deere 5403 tractor. Power Steering gradually became worse as i was mowing now feels like there is limited power steering and my breaks barely work and the hydraulics to the front loader and 3 point hitch are very slow. Check Hydraulic fluid and it was full. … read more
Tristen J Hamm
Certified Diesel Technician
5 satisfied customers
I have a New JD 6150R. In terms of PTO speeds, I have 540,
I have a New JD 6150R. In terms of PTO speeds, I have 540, 540E and 1000. I would also like 1000E. Is it possible to get this just by reprogramming, since the speeds are just selected in the command c… read more
Kevin
2 years John Deere Tech school
235 satisfied customers
The mower deck from my John Deere 445..disconnected..lift..drive shaft
I need to remove the mower deck from my John Deere 445. I have removed the front attachment and disconnected the two rear lift points. I cannot get the drive shaft to separate. Any ideas?… read more
Rex L.
Vocational, Technical or Trade Scho
82 satisfied customers
55 Challenger: tractor..a hydraulic hose blow and most all the oil
I have a Cat 55 Challenger ag tractor. I had a hydraulic hose blow and most all the oil was discharged. I added hydrulic oil and now the cat wont turn to the right. Can it be that the line was air loc… read more
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,336 satisfied customers
t100: slipping..hydraulic) or do I have to replace the clutch pack
The PTO is slipping on my TL100 tractor. Is there an adjustment ( hydraulic) or do I have to replace the clutch pack?… read more
dd85
Service Manager
20 years Service Manager at Dealersh
227 satisfied customers
It streaks in the center of the swath i am very disapointed
My 2011 Newholland h7220 discbine has never mowed just right it streaks in the center of the swath i am very disapointed in the machine. what could the problem be… read more
dd85
Service Manager
20 years Service Manager at Dealersh
227 satisfied customers
b1800: It came with a front end loader, snow plow and brushhog.
About 10 years ago I purchased a new B7800 Kubota for yard use. It came with a front end loader, snow plow and brushhog. It has now only 250 hours on it. Two years ago I purchased a RCK60 belly mower … read more
Curtis B.
service manager
Associate Degree
2,404 satisfied customers
79315 with a clutch that wont disengage..bearing noise, no slippage
I have a MF 165 SN 9A-79315 with a clutch that won't disengage. It was working fine last time it was used ~ 1 month ago. No throwout bearing noise, no slippage, adjusted properly. Everything feels OK.… read more
Bobby Long
208 satisfied customers
Looking at a used John Deere 6200. It has 7000 hours. Engine
Looking at a used John Deere 6200. It has 7000 hours. Engine sounds good, turbo works, 3 point works, only things that seem to have issue is a chatter in the top gear and the PTO does not work. Unders… read more
Kevin
2 years John Deere Tech school
235 satisfied customers
hello,, i have a john deere 6300 tractor, i let it sit for
hello,, i have a john deere 6300 tractor, i let it sit for about 30 days and when i went to use it, it would not move in any gear, i was able to find and test the hydraulic clutch pressure port on the… read more
ebnel
Current Certified Master technician
High School or GED
251 satisfied customers
I have a John Deere 4055 tractor that the PTO will not disengage
I have a John Deere 4055 tractor that the PTO will not disengage. it is a power shift model 1989… read more
ebnel
Current Certified Master technician
High School or GED
251 satisfied customers
Ford: hydraulics..the tractor has auxillary ports but i
where do i hook up the auxillary hydraulics on a ford 3000 tractor ? I need to know which ports to hook to to hook up a rear remote for a mower. Iknow the tractor has auxillary ports but i dont know w… read more
Dan
Road sevice Mechanic
Vocational, Technical or Trade Scho
354 satisfied customers
I have a John Deere model 770 tractor and the seat kill switch
I have a John Deere model 770 tractor and the seat kill switch was activated and now it won't start. I have reset everything t neutral, but nothing. Is there a reset switch?… read more
Jeremy
Field Tech.
High School or GED
62 satisfied customers
5000 ford: rev the motor up to 18 or 1900 rpms..slip..just wont start
My 5000 ford pto works fine when the tractor is cold, but after its hot and you disengage it won't come back on at an idle. You have to rev the motor up to 18 or 1900 rpms before it will take off. It … read more
Don
Mechanic
Vocational, Technical or Trade Scho
553 satisfied customers
disengage..cab..switch which engages when pto lever is in on position
I have 1993 MF 3670 FWA Tractor which has 5984 hrs, with both 540 & 1000 PTO. The problem is that the PTO won't disengage when in the off position. Have checked switch in cab, but still runs even when… read more
Benjy
Bachelor's Degree
273 satisfied customers
WE have a John Deere 2020 diesel tractor with a weak PTO
WE have a John Deere 2020 diesel tractor with a weak PTO. Yesterday I tried to use it to ted my hay field and as soon as I drop the tedder to the ground it stops spinning. What do you think? -Luann Vo… read more
dieseltech
Owner
Vocational, Technical or Trade Scho
14 satisfied customers
blower..leaks..I drove 1 mile to move snow with the loader
I have a tc45d w/640 hrs and the oil cooler cracked. I replaced the cooler, started the the tractor, let warm up for 10 minutes, raised the loader, raised the 3 pt snow blower, and tried the snowblowe… read more
Dustin
Wheel Vehicle Mechanic
GED
2 satisfied customers
Started John deere 4630 and moved a bale of hay and everything
Started John deere 4630 and moved a bale of hay and everything worked fine. Shut it off and unhooked bale fork and went to start it again and had no power steering, no transmission movement(powershift… read more
mitchell
mechanic
High School or GED
26 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
JustAnswer in the News:
Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.
What Customers are Saying:
I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.
Elm City, NC
used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.
Richmond, TX
9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.
Marysville, CA
Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.
Walnut Creek, CA
As a single woman, I really appreciate an excellent and affordable opinion.
Charleston, WV
Thank you Geordie, I will not hesitate to contact justanswer in the future!
Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.
Castleberry, FL
Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.
Freshfield, Liverpool, UK
< Previous | Next >
Meet the Experts:
Chris (aka - Moose)
Technician
133 satisfied customers
24 years of experience diagnosing & repairing
Tim
Foreman
338 satisfied customers
23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry
Cat Man
Caterpillar Engine Expert
3,777 satisfied customers
23 Years Caterpillar Engine experience.
Wayne
Journeyman
3,308 satisfied customers
34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.
Curtis B.
service manager
2,404 satisfied customers
30 years exp. with diesel engines, heavy equipment and forklifts, including lp forklifts
DR.Cummins
FIELD SERVICE TECHNICIAN
2,392 satisfied customers
16 Years working on Cummins Diesel engines,
Don
Mechanic
553 satisfied customers
35 years experience journeyman mechanic transport truck and trailer including off road equipment
< Previous | Next >
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.
