Heavy Equipment

Heavy equipment repair questions? Ask an Expert now.

Ask an Expert,
Get an Answer ASAP!

Related Heavy Equipment Questions
I have a Cat 247b Multi terrain skid steer and cant get it
I have a Cat 247b Multi terrain skid steer and can't get it started It stopped on a slope. I thought it ran out of fuel, the fuel gauge showed over 1/4 of a tank. I added more fuel and some power serv… read more
Steve
Steve
Self Employed
High School or GED
30 satisfied customers
Hello, I have a 2000 Kenworth W900 with a vin of 869387. Engine
Hello, I have a 2000 Kenworth W900 with a vin of 869387. Engine is a CAT C-12 with serial number of a 2KS52430. The issue I'm having is, when 100% throttle is applied the boost pressure come up to 22 … read more
Cat Man
Cat Man
Caterpillar Engine Expert
Vocational, Technical or Trade Scho
3,761 satisfied customers
2.9 litre john deere diesel (3 cyl) 1995..oil pan..blow..slipping
My friend has a 2.9 litre john deere diesel (3 cyl) 1995 .Under load the temp gauge pegs out but with a infrared gun it shows 78 cel or 174 farenheit at the thermostat and at the inlet (suction side o… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,101 satisfied customers
degrees..off to cool..when we restart, temperature goes right back
Hi, We run a D8N with 3406 engine. Temperature rises to 100 degrees after 30mins of use. After we turn machine off to cool..when we restart, temperature goes right back up to 100. What could be the ca… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,101 satisfied customers
gauge..idles..10in. at 1500 rpm when i let up on the pedal..needle
My n14 with 730000 miles started to show a restriction on my vaccum gauge. it now idles at 12-15 in. on thegauge it will run smooth at 10in. at 1500 rpm when i let up on the pedal or the c-brake comes… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,371 satisfied customers
I have an old Massey 65 gas tractor. WHen it gets hot it seems
I have an old Massey 65 gas tractor. WHen it gets hot it seems as if it is starved for air or gas. If I top off the tank (full) it will run again but start acting up after some time. Is there any sugg… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
696 satisfied customers
2003 Fleetwood: cold weather..motor home..engine will not stay running
I am having a problem with cold weather starts on my 3126B. It's in a 2003 Fleetwood Motorhome. When the temp is below approx 45-50F the engine will not stay running. The wait to start light stays on … read more
Cat Man
Cat Man
Caterpillar Engine Expert
Vocational, Technical or Trade Scho
3,761 satisfied customers
I have a 1996 379 Pete with a cummins n14. A little background
I have a 1996 379 Pete with a cummins n14. A little background info. An older friend of mine bought this truck with a bad motor. He wound up having to change the block. He went back with all cummins p… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,371 satisfied customers
ACTS LIKE IT IS SUCKING AIR THEN..PLASTIC..INTERMITTENT..SAME THING
I HAVE A 3126 CAT S/NCKM33106 THAT WILL START THEN RUN APPROXIMATELY 2 TO 4 MINUTES THEN ACTS LIKE IT IS SUCKING AIR THEN DIES. I HAVE REPLACED THE ELBOW AT THE REAR OF THE HEAD ASWELL AS ALL PLASTIC … read more
Cat Man
Cat Man
Caterpillar Engine Expert
Vocational, Technical or Trade Scho
3,761 satisfied customers
Hi I have 2006 Volvo vnl 670, cummins isx 450hp. Every time
Hi I have 2006 Volvo vnl 670, cummins isx 450hp. Every time I fill fuel tanks system shows me 200 gal avaliable, but when I drive truck uses - only 110-135 gal (computer and fuel gauge show empty tank… read more
JCTech
JCTech
Technical Specialist
Vocational, Technical or Trade Scho
352 satisfied customers
I have a Massey Ferguson 135 with Perkins 3 cylinder gas engine.
I have a Massey Ferguson 135 with Perkins 3 cylinder gas engine. I need a gas tank can someone tell me what the part number is XXXXX will a tank out of a 35 with Continental engine fit this tractor? A… read more
dd85
dd85
Service Manager
20 years Service Manager at Dealersh
223 satisfied customers
c15: what tool am i going to need to run an overhead..engines
what tool am i going to need to run an overhead on the c15 c16 cat engines. the order to run them as 1 and 6 and so on then turn 180degees and then run 3 an 5 and so on. what feelers and sequence? and… read more
Buddy
Buddy
Diesel Technician
High School or GED
703 satisfied customers
cummins..specification..) of the rocker that pushes the injector
i believe the engine in my 1976 truck is either an nhc250 or a nt855 cummins. id like to know valve clearance specification and a description of how to set the clearance(or whatever it needs) of the r… read more
DR.Cummins
DR.Cummins
FIELD SERVICE TECHNICIAN
High School or GED
2,371 satisfied customers
What is the best way to get rust out of a fuel tank..filters
What is the best way to get rust out of a fuel tank. The truck will run for about 2 hours before the filters stop up with rust from the tank.… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,101 satisfied customers
top end set on a catepillar 3406e e.g., tooling required
Can you tell me what is required to do a top end set on a Catepillar 3406E e.g., tooling required? Is there a source of information for the top end settings themselves?… read more
Buddy
Buddy
Diesel Technician
High School or GED
703 satisfied customers
I have a N-14 cummins with three bad fuel injectors. I want
I have a N-14 cummins with three bad fuel injectors. I want to do the work myself but I don't know if there is a certain torque that I have to comply with or not. Is there one?… read more
Joe
Joe
Service Technician
Associate Degree
820 satisfied customers
Duramax..4 exhaust all the way back no muffler..tranny..gasket
2004 duramax lly pacific performance chip run it on level 3 have fresh air intake 4'' exhaust all the way back no muffler no cat. Amzoil in front and rear dirrerential tranny and engine truck runs fin… read more
KevinB
KevinB
Field Technician
Associate Degree
228 satisfied customers
refill..primer bulb is not filling up like it used to ....only 1/4
I own a troy built 2 cycle weed wacker with the different attatchments. Last time I used it, I ran out of gas while using it and when I went to refill and start again, it would not start. Also, the pr… read more
Rudolph Diesel
Rudolph Diesel
Service manager/ Master mechanic
Vocational, Technical or Trade Scho
1,905 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Chris (aka - Moose)

Chris (aka - Moose)

Technician

112 satisfied customers

16 years of experience

Tim

Tim

Foreman

338 satisfied customers

23 Years Heavy Equipment and Truck Repairs Shop and Field in the Minning and Construction Industry

J.R.

J.R.

Technician

148 satisfied customers

13 years as warranty technician for Detroit Diesel

Cat Man

Cat Man

Caterpillar Engine Expert

3,761 satisfied customers

23 Years Caterpillar Engine experience.

Wayne

Wayne

Journeyman

3,101 satisfied customers

34 years experiance as engine rebuild and problems.Thermo-King repair and trouble shooting.

DR.Cummins

DR.Cummins

FIELD SERVICE TECHNICIAN

2,371 satisfied customers

16 Years working on Cummins Diesel engines,

Curtis B.

Curtis B.

service manager

2,283 satisfied customers

30 years exp. with diesel engines, heavy equipment and forklifts, including lp forklifts

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x