GMC

GMC troubleshooting questions? Ask a mechanic for answers

Connect one-on-one with {0} who will answer your question

Related GMC Questions
Have a 2015 Suburban aprox 105K miles that is repeatedly(for
Have a 2015 Suburban aprox 105K miles that is repeatedly(for last 10K mile intermittently) registering codes p0172 and p0175. Have cleaned MAF and replaced air filter. Have run fuel additives and 3-4 … read more
Richard Greer
Richard Greer
Online Automotive Repair Consultant
Vocational, Technical or Trade School
1,184 satisfied customers
2002 GMC Envoy 4.2 L Hard starting when cold. Drove from Las
2002 GMC Envoy 4.2 L Hard starting when cold. Drove from Las Vegas to Knoxville - no problems. One week later it was miss firing and starting hard - replaced spark plugs, ignition coils, fuel filter, … read more
Daniel Chaidez
Daniel Chaidez
Technician
Diploma
1,810 satisfied customers
I have a 2001 C3500 HD that is running very rough,
I have a 2001 C3500 HD that is running very rough, backfires, and no power. Won't go over 2500 rpms. Could it be the throttle position sensor? I've changed every sensor but the TP sensor. … read more
Amedee
Amedee
GMC Technician
Vocational, Technical or Trade Scho
31,181 satisfied customers
Ahna, my issue is regarding a 2000 yukom denali that wont
ahna, my issue is regarding a 2000 yukom denali that wont stay runnng. replaced the fuel pump, lines, and fuel filter and just put on new o rings. will crank when you put gas in the carburator but shu… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,589 satisfied customers
Gmc Yukon Denali: My 2004 Yukon Denali act if it's trying to
My 2004 Yukon Denali act if it's trying to shut off while driving sometimes. I have replaced the throttle body and the wiring harness but the idle still sticks periodically. When I come to a stop it s… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
I have a 2000 gmc sonoma with a 2.2 . Ive changed the fuel
I have a 2000 gmc sonoma with a 2.2 . Ive changed the fuel pump,fuel filter, ICM,coil packs,plug wires,temp censor. Stalls while driving gets worse when its hot side like today. Any ideas.… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
GMC Yukon Donalli XL 1500 all-wheel-drive: 2004 GMC Yukon Donalli
2004 GMC Yukon Donalli 5.3 engine all-wheel-drive -diagnostic tool says PO 650 code -car has trouble starting and sometimes does not start also will hesitate sometimes when driving… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
GMC Sierra: I have an 04 GMC Sierra 1500 5.3 L. I have been
I have an 04 GMC Sierra 1500 5.3 L. I have been experiencing some sputtering at idle and low speed for the last couple weeks. Today I was driving down the interstate and the truck started sputtering/ … read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
GMC yukon: GM! I have a 2000 GMC YUKON XL, it will not stay
GM! I have a 2000 GMC YUKON XL, it will not stay running, it will start but will cut off, what does this sound like it could be? please help me… read more
Eric
Eric
Retired
N/A
37,351 satisfied customers
Im working on a 1991 Gmc trk and it shuts off right after
I'm working on a 1991 Gmc trk and it shuts off right after start up. It will restart and it bogs out and sputters occasionally when accelerating.… read more
GMWrencher
GMWrencher
Associate Degree
415 satisfied customers
Here is a speciel one. Installed a 2001 6.0 GMC Denali XL
Here is a speciel one. Installed a 2001 6.0 GMC Denali XL 4x4 engine and 480LE trans in 56 Nomad Wagon. Car fires and runs fine at idle. Any accelleration it falls on its face. Running really rich due… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,615 satisfied customers
gmc sirra: 96 gmc 1500 half ton pick up 5.0 4x4 will not start
96 gmc 1500 half ton pick up 5.0 4x4 will not start pour alittle gas in throttle body truck starts and runs fine shut off will not start again… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,589 satisfied customers
GMC Sonoma 4x4: I have a 1999 gmc sonoma zr2 with the 4.3L
I have a 1999 gmc sonoma zr2 with the 4.3L vortec. If i turn the truck off and let it sit for about 5-10 minutes i have a real hard time starting it. Cranks for a good 10-15 seconds before it fires up… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC Jimmy 4x4 (Mid Size): I HAVE A 2000 GMC JIMMY AND IT RUNS
I HAVE A 2000 GMC JIMMY AND IT RUNS ROUGH WHEN THE AC OR HEATER IS ON, IT IS ALSO WORSE WHEN IT GETS TO NORMAL OPERATING TEMP. HAS NO CODES, AND HAS GOOD FUEL PRESSURE AND VOLUME. IT SHOWS A MISFIRE O… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
GMC GMC Suburban - K1500: Cam,About my 1997 GMC K1500 Suburban,
Cam, About my 1997 GMC K1500 Suburban, 7.5L 4WD... You helped me fix the misfire issue about 9 months ago. Recently it progressively became more difficult to start until finally it would not start at … read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
GMC s10: 1988 chevy s10 2.8l. i recently had a question answwered
1988 chevy s10 2.8l. i recently had a question answwered about the timing. i now have the timing correct. when i crank the engine over it will not start. does not even try to fire off. if i spray star… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC calvalier: cam i have one srark plug hole that keep flooding
cam i have one srark plug hole that keep flooding number 4 plug hole keep getting gas buildup i'm thinking bad number 4 injector keep flooding system causing no start cituation can you give details on… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
GMC Yukon XL 2500 SLT: 2002 GMC Yukon XL 2500 w/ 8.1L engine
2002 GMC Yukon XL 2500 w/ 8.1L engine cuts out. Did a Schrader valve check and the pressure was at 50+ and then rapidly dropped off. Had the Crank sensor and front pump about 40K miles ago. Replaced t… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,912 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Gm Tech (Cam)

Gm Tech (Cam)

GMC Mechanic

1,912 satisfied customers

GM Grand Master Technician 2007. 14 year experience.

Gary

Gary

ASE Certified Technician

1,589 satisfied customers

GCM master tech over 25 years

Dave Nova

Dave Nova

GMC Technician

929 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

GMC Technician

766 satisfied customers

16 years of experience

JFN1

JFN1

ASE Certified Technician

272 satisfied customers

GM Master Technician

Don - Mo Lurch

Don - Mo Lurch

ASE Certified Technician

248 satisfied customers

GM, GMC, Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics

Mike S.

Mike S.

ASE Certified Technician

241 satisfied customers

GMC N.A.I.S.E. Certified Auto-Mechanic

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x