GMC

GMC Troubleshooting Questions? Ask a Mechanic for Answers

Ask an Expert,
Get an Answer ASAP!

GMC

I have an 06 gmc w/6.6 diesel and would like some

Customer Question
hello, I have an 06...
hello, I have an 06 gmc w/6.6 diesel and would like some instruction on the water pump r+r? thanks
Submitted: 26 days ago.Category: GMC
Show More
Show Less
Ask Your Own GMC Question
Answered in 7 minutes by:
11/17/2017
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 26 days ago
david craig
david craig, Owner/[email protected] 3D Atuomotive
Category: GMC
Satisfied Customers: 4,176
Experience: owner/mechanic at 3D Automotive
Verified

Hi my name is ***** ***** I'll be more than happy to assist you. Please allow me a few minutes to review your information. Thank you

Ask Your Own GMC Question
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 26 days ago

you need the r&r?

Ask Your Own GMC Question
Customer reply replied 26 days ago
David, please
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 26 days ago

ok please standby. thanks

Ask Your Own GMC Question
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 26 days ago

thanks for your patience

Ask Your Own GMC Question
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 26 days ago

sierra correct?

Ask Your Own GMC Question
Customer reply replied 25 days ago
have you done one of these?
Customer reply replied 25 days ago
it probably doesn't matter but it is an 06 chevy silverado, but back to my previous post, is this only book knowledge you are able to give me?
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 25 days ago

standby a few please

Ask Your Own GMC Question
Customer reply replied 25 days ago
no problem, I'm not doing it til this weekend, take your time
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 25 days ago

better than any book or service manual

https://www.youtube.com/watch?v=FyrzcMWGzjQ

Ask Your Own GMC Question
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 23 days ago

hows it going?

Ask Your Own GMC Question
Customer reply replied 23 days ago
I had seen that video prior to you sending the link and was surprised (and still am) that you would do such a thing with all the shade tree action going on (hammer and chisel wrenching?), and it would of had me removing the inner fender well? I went to this site to get a professional experienced opinion and I feel let down
as for the job, it's done thanks for asking
for some reason it won't let me rate...will try later
GMC Mechanic: david craig, Owner/[email protected] 3D Atuomotive replied 23 days ago

no rating necessary. the service manual is very vague on this procedure. good day.

Ask Your Own GMC Question
Ask Gm Tech (Cam) Your Own Question
Gm Tech (Cam)
Gm Tech (Cam)
Gm Tech (Cam), GMC Mechanic
Category: GMC
Satisfied Customers: 1,696
1,696 Satisfied Customers
Experience: GM Grand Master Technician 2007. 14 year experience.

Gm Tech (Cam) is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Gm Tech (Cam)

Gm Tech (Cam)

GMC Mechanic

1,696 satisfied customers

GM Grand Master Technician 2007. 14 year experience.

Gary

Gary

ASE Certified Technician

1,552 satisfied customers

GCM master tech over 25 years

Dave Nova

Dave Nova

GMC Technician

929 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

GMC Technician

576 satisfied customers

16 years of experience

Ron Z.

Ron Z.

- GMC Tech -

259 satisfied customers

18+yrs experience. State Inspector & GMC Diagnostics/Repair

George H.

George H.

ASE MasterTechnician

226 satisfied customers

15+ Years ASE Master Technician with Level 1 Certification

Don - Mo Lurch

Don - Mo Lurch

ASE Certified Technician

218 satisfied customers

GM, GMC, Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics

< Previous | Next >

Related GMC Questions
Running hot. Where is the thermostat. 2002 gmc envoy. No im
Put a water pump amd a thermostat on and its still running hot … read more
heavy_chevy_396
heavy_chevy_396
Vocational, Technical or Trade Scho
2,518 satisfied customers
Idle engine. 285000 VVM envoy 2003 XL. Also battery not
This just happened todayhvnt had a chance to do anything as yet… read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
576 satisfied customers
I replace my water pump now my car is overheating and I'm
I replace my water pump now my car is overheating and I'm not getting any heat inside the car. 2011 Yukon Denali… read more
roy
roy
Associate Degree
3 satisfied customers
It drops temp down then jumps up high the go back to normal.
It drops temp down then jumps up high the go back to normal … read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
576 satisfied customers
My check engine light flashing car losing speed. It stayed
it stayed on at first replaced water pump an heater hoses. … read more
baddad1
baddad1
technician
High School or GED
5 satisfied customers
I have a 2011 diesel 6.6 it's wasting coolant and the oil
I have a 2011 diesel 6.6 it's wasting coolant and the oil seems with water, also the pression coolant reservoir is black and oily. can you tel me if the problem is in the heads or in the engine block?… read more
Eric
Eric
Retired
N/A
14,436 satisfied customers
2004 gmc yukon no heat in front vents/defrost. blend door
2004 gmc yukon no heat in front vents/defrost. blend door actuator has been changed along with the blower motor resistor. coolant level is full and hoses to heater core are hot to the touch. im lost … read more
Eric
Eric
Auto Technician
589 satisfied customers
2006 GMC savana 3500 6.6 low coolant light res was replaced
2006 GMC savana 3500 6.6 low coolant light res was replaced varified sensor open and closes replaces connector (broken wire) check resisdence on ground good and green wire to pcm replaced pcm and flas… read more
Jerry Newton
Jerry Newton
Vocational, Technical or Trade Scho
2,066 satisfied customers
Have a 2006 H3. Had a water pump and clutch/belt break
Have a 2006 H3. Had a water pump and clutch/belt break recently and was replaced. Then on a trip it started overheating. Had radiator cap, thermostat, and sensor replaced but continued running hot. Me… read more
heavy_chevy_396
heavy_chevy_396
Vocational, Technical or Trade Scho
2,518 satisfied customers
I'm replacing my coolant hoses. How do remove the surge tank
I'm replacing my coolant hoses. How do remove the surge tank to access the hose connected to the bottom of it? … read more
tim37857
tim37857
Mechanic
High School or GED
71 satisfied customers
The temperature gage says it's overheating but my mechanic
The temperature gage says it's overheating but my mechanic connected it to very sophisticated machines that indicated that it wasn't overheating, but the gage just said it was … read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
576 satisfied customers
I have GMC Acadia 2008 struggling to solve heating issue and
Hi I have GMC Acadia 2008 struggling to solve heating issue and going mad with local mechanics … read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
Overheating, ac turned off, power reduced. changed
overheating, ac turned off, power reduced. changed thermostat & problem continues … read more
heavy_chevy_396
heavy_chevy_396
Vocational, Technical or Trade Scho
2,518 satisfied customers
I have a 1999 GMC K2500 Suburban 4wd V8 7.4l. I see a little
i have a 1999 GMC K2500 Suburban 4wd V8 7.4l. I see a little coolant on the top of the engine at the intake manifold, (to the left of oil filler tube as well as just below the oil filler tube by the w… read more
Gunvir Singh
Gunvir Singh
1,799 satisfied customers
Again with my 2004 GMC Yukon Denali--I think I may have
Again with my 2004 GMC Yukon Denali--I think I may have 'ingested' a vacuum line cap through the opening where my coolant temperature sensor plugs into the engine (right behind the positive jump termi… read more
Eric
Eric
Retired
N/A
14,436 satisfied customers
Changed water pump and thermostat now the heat is not
changed water pump and thermostat now the heat is not working. tried one procedure where you pull the surge line but am not getting any coolant from it and the radiator is full. … read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,552 satisfied customers
Cam, Low coolant warning came up and the level was very low.
Hey Cam,Low coolant warning came up and the level was very low. I think there's s leak somewhere. What's the best way to find it?… read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
I have a 2003 gmc 2500hd 6 liter vortec. I have a coolant
I have a 2003 gmc 2500hd 6 liter vortec. I have a coolant leak where the line from the radiator connects to the top of the engine block. Located on drivers side near the alternator. Looking for a repl… read more
BOBBYSS
BOBBYSS
TECHNICIAN/ADVISOR
Associate Degree
8,343 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x