GMC

GMC troubleshooting questions? Ask a mechanic for answers

Connect one-on-one with {0} who will answer your question

Related GMC Questions
2004 GMC Sierra 1500, have problem for over a year, changed
2004 GMC Sierra 1500, have problem for over a year, changed switch in dash, In*****, going down the road , hit a bump and transfer case goes into neutral, I have to pull over and shut down truck, othe… read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
55,625 satisfied customers
My 2003 G M C wont start, then at times will start ,run for
my 2003 G M C wont start, then at times will start ,run for a short period then stop.replaced the battery with a new one,with about 12.72 volts, spins over well, no fuel, replaced fuel pump about 3 mo… read more
Roy
Roy
shop foreman
Associate Degree
4,581 satisfied customers
I have a GMC Sierra 3500 hd Duramax Allison trans exhaust
I have a GMC Sierra 3500 hd Duramax Allison trans exhaust service will not turn off I filled the tank with blue dep and the the count down continues ,how can I reset ? … read more
Robert Blackwell
Robert Blackwell
Shop Owner
Vocational, Technical or Trade School
139 satisfied customers
3500 2001. Its a tad complicated...you or him? 2001 gmc
its a tad complicated...you or him? 2001 gmc sierra 3500 dually RWD ... power loss...Guys - '01 3500 Sierra Dually RWD 6.6L Duramax, w/ Allison. Cruising flat highways and on ramp speed up are no issues. However, up hill (whether towing or not) and kicking down the tranny to lower gear the following happens: dash lights, radio, seemingly the ignition circuit and a loss of power occurs after about 10-20 seconds after starting the hill. Only solution is to remove foot off accelerator and everything comes back on and carries on. To take the hill I must stay around 50 MPH, to avoid tranny shifting? This is a ground issue, isnt it? Is it possible that the tranny and the dash (and/or ignition circuit) are all grounded to the same hard point, that is faulty, perhaps?!? any idea what may be causing this kind of power loss? and gas pedal or tranny/ dash shutdown combination?… read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
6,112 satisfied customers
I have a 2011 gmc 2500hd with 6.6 duramax im having problem
I have a 2011 gmc 2500hd with 6.6 duramax im having problem with my truck dieing when I hit a bump and check engine light flashing on then immediately back off code p2510 is showing when this occurred… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
6,895 satisfied customers
I put a new cold air intake on my 2015 duramax now it won't
I put a new cold air intake on my 2015 duramax now it won't start. I changed the MAS thinking that was the problem but still won't start … read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,591 satisfied customers
WONT START AFTER GLOW PLUGS REPLACED, CRANKS OVER FIRES AND
WONT START AFTER GLOW PLUGS REPLACED JA: Have you checked the battery, particularly the terminal connections? Are they corroded? Customer: CRANKS OVER FIRES AND DIES JA: What is the model/year of your… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
965 satisfied customers
I own a 1999 GMC Sierra 4x4 pickup truck and was wondering
I own a 1999 GMC Sierra 4x4 pickup truck and was wondering what I could do to smooth out the ride… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,106 satisfied customers
GMC Sierra 1500: I was driving hit a big dip in the foad. It
I was driving hit a big dip in the foad. It shut off the gas. Im pulled over now in the rain. It had to be a fuwl shutoff switch… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,589 satisfied customers
GMC 2500 Series sierra: 05 sierra duramax. All functions are
05 sierra duramax. All functions are not working but headlights windshield washer. Truck runs and drives. Bumped the TCM on the battery replaced TCM ecm. Scanner says turn key on. Tcm and ecm are prog… read more
Expert
Expert
GMC: I am back with a new problem, same vehicle. My 2005 GMC
I am back with a new problem, same vehicle. My 2005 GMC Sierra 3500 diesel will not start. First starting problem I've had with this truck. After a sitting for a day with the temperatures dipping down… read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
55,625 satisfied customers
GMC sierra 1500: Have a 2002 gmc sierra. When hitting a bump
Have a 2002 gmc sierra. When hitting a bump or dip in the road I here a metal on metal grinding underneath truck in rear. Check my oil level and found no metal shaving, gears have no wear look good… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,106 satisfied customers
gmc K2500 Sierra 4x4: I have an 03 duramax that i mudded in
I have an 03 duramax that i mudded in & it shut down after it made a squealing noise. Now it wont start. I hit it with ether but it dies when I Stop.… read more
Mike Kelly
Mike Kelly
Auto Mechanic
Vocational, Technical or Trade Scho
2,460 satisfied customers
GMC Sierra 3500 HD SLT: I bought a used 2004 sierra 3500 SLT
I bought a used 2004 sierra 3500 SLT Duramax with 200k km on it. It's in great shape but sadly, I never engaged the 4wd at any speed other than a walking pace. On a recent trip I shift from 2wd to 4hi… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,837 satisfied customers
GMC sierra2500: i just bought a 2007 gmc sierra 3/4 ton,4x4,quad
i just bought a 2007 gmc sierra 3/4 ton,4x4,quad cab long wheelbase HD DURAMAX diesel. it has 130,000 miles on it.when driving on the road on pavement it's fine until it hits a bump in the road,then t… read more
lt1camaro03112
lt1camaro03112
Automotive Technician
115 satisfied customers
GMC Sierra Denali: My 2008 GMC Sierra Denali will not start
My 2008 GMC Sierra Denali will not start when tempertatures get down around the single digits and less. It wont even try to crank over it just clicks. Is there some sort of safety feature that blocks … read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,106 satisfied customers
GMC 2500 Series: I have a 02 GMC Duramax with an edge chip.
I have a 02 GMC Duramax with an edge chip. It has this problem of shutting down when I'm going down the road. Usually when slowing down. The truck just dies and the gauge cluster goes crazy. The volt … read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,837 satisfied customers
GM sierra 1500 4x4: 99 gmc sierra 1500 4.8L driving down the
99 gmc sierra 1500 4.8L driving down the road truck shut off..started right back up but wont stay running... changed throttle position censor, fuel pump, fuel filter, fuel pressure regulator and still… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,642 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Gm Tech (Cam)

Gm Tech (Cam)

GMC Mechanic

1,837 satisfied customers

GM Grand Master Technician 2007. 14 year experience.

Gary

Gary

ASE Certified Technician

1,589 satisfied customers

GCM master tech over 25 years

Dave Nova

Dave Nova

GMC Technician

929 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

GMC Technician

55,625 satisfied customers

16 years of experience

Ron Z.

Ron Z.

- GMC Tech -

285 satisfied customers

18+yrs experience. State Inspector & GMC Diagnostics/Repair

JFN1

JFN1

ASE Certified Technician

272 satisfied customers

GM Master Technician

George H.

George H.

ASE MasterTechnician

230 satisfied customers

15+ Years ASE Master Technician with Level 1 Certification

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x