GMC

GMC troubleshooting questions? Ask a mechanic for answers

Connect one-on-one with {0} who will answer your question

Related GMC Questions
2005 Yukon XL with 140,000 miles. Vibration at 72-78 mph.
2005 Yukon XL with 140,000 miles. Vibration at 72-78 mph. Had tires rebalanced (but not road force balanced yet), new u-joints, drive shaft removed and straightened. Nothing fixes it. Have always used… read more
Peter Bagley
Peter Bagley
master technition
Vocational, Technical or Trade School
1,466 satisfied customers
There is an oil drip coming from under a heat shield on the
There is an oil drip coming from under a heat shield on the lower driver side of the engine … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
6,901 satisfied customers
1997 suburban and i have a knocking coming from my loose tie
1997 suburban and i have a knocking coming from my loose tie rod piece (both ends). I need to know if its as easy as taking off the inside bolt and outside bolt or if there is something more involved.… read more
Greg Jensen
Greg Jensen
Associate degree
12 satisfied customers
GMC Yukon XL 1500 4x4: I am replacing the engine in a 2001
I am replacing the engine in a 2001 Yukon XL 4x4. I plan on leaving the transmission in the vehicle and just removing the engine. It looks like I may have to drop the front differential to get the 5.3… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,589 satisfied customers
Gmc Yukon XL 2500 SLT: I have a 2005 Yukon XL 2500. There's
I have a 2005 Yukon XL 2500. There's a something that sounds like an unbalanced tire coming from both sides of the front end. tires were just balanced and rotated again I know ball joints are going to… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GM Suburban: I have a 2011 Suburban drivers side floor board
I have a 2011 Suburban drivers side floor board is wet. Sun roof vents are clear. A/C drain has been cleaned. I have not driven or has it rained but floor is still wet. What might be the problem?… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,642 satisfied customers
Can an improperly installed tie rod on a 2004 GMC Sierra Denali
Can an improperly installed tie rod on a 2004 GMC Sierra Denali Quadrasteer eventually cause problems with a viscous coupling or transfer case. Keep in mind the complexity of a QuadraSTEER. How many t… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,837 satisfied customers
GMC yukon denali: I am replacing the oil pan seal on a 2007
I am replacing the oil pan seal on a 2007 gmc yukon xl denali (6.2, AWD) and the oil pan appears to be stuck due to clearance of the power steering lines. Everything is removed, but the pan won't come… read more
GM Bob
GM Bob
Automobile Technician
High School or GED
1,101 satisfied customers
GMC 2002: 02 Gmc Yukon keeps blowing rear seal on Transfer
02 Gmc Yukon keeps blowing rear seal on Transfer Case 3 in 1 month, I also had it rebuilt and it still does it. my truck has a 10 inch lift and 20/38 tires… read more
tripletauto
tripletauto
Shop Foreman
Associate Degree
238 satisfied customers
GMC Yukon SLE: 2002 GMC Yukon 4x4 5.3L (z code - flexfuel). I
2002 GMC Yukon 4x4 5.3L (z code - flexfuel). I have some weird clunk when turning into a parking space. Appears to come from front driver side. Also slightly weird rattle on washboard road at lower sp… read more
Mike Kelly
Mike Kelly
Auto Mechanic
Vocational, Technical or Trade Scho
2,460 satisfied customers
GMC Yukon Denali: I have a 2007 Yukon Denali and I need instructions
I have a 2007 Yukon Denali and I need instructions to replace the driver side exterior door handle (OEM chrome plastic).… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC 1500 seara classic: hello i am trying to remove the
hello i am trying to remove the rear drivers side wheel bearing i have removed the break assembly have removed the emergency break shoe and the four 18 mm bolts from the ronud bracket that is bolted t… read more
Canadafix
Canadafix
Auto shop owner
Vocational, Technical or Trade Scho
1,507 satisfied customers
I am replacing the output seals in a front diff. in an 02
I am replacing the output seals in a front diff. in an '02 GMC Yukon. Does the diff. have to be removed and split?… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC PONTIAC: My Pontiac Torrent DRIVERS SIDE FRONT WHEEL VIBRATES
My Pontiac Torrent DRIVER'S SIDE FRONT WHEEL VIBRATES OR SHAKES WHEN-EVER I APPLY THE BRAKES.… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC YUKON XL DENALI: GOOD AFTERNOON: I OWN A 2007 YUKON
GOOD AFTERNOON: I OWN A 2007 YUKON XL DENALI WITH A SLOW OIL LEAK. THE DEALER SAID THE OIL PAN GASKET NEEDED TO BE REPLACED. IS REPLACING THE OIL PAN GASKET A PRETTY STRAIGHT FORWARD PROCEDURE? I BOUG… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC k-1500: Hi! Got a question for you. Im changing a front
Hi! Got a question for you. Im changing a front output shaft seal on the front diff of a 2006 GMC k-1500. The problem is that i have to keep changing it cause it keeps starting to leak. this is about … read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC Sierra 1500: I have a 1999 GMC Sierra K1500. I am getting
I have a 1999 GMC Sierra K1500. I am getting a noise from the front differential. I took to the instant oil change, they said the fluid was low and dirty. They topped it off and the noise temporarily … read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC Envoy XL Denali: 2005 GMC Envoy left front axle seal leaking.
2005 GMC Envoy left front axle seal leaking. Can seal be replaced without taking front differential apart?… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,837 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Gm Tech (Cam)

Gm Tech (Cam)

GMC Mechanic

1,837 satisfied customers

GM Grand Master Technician 2007. 14 year experience.

Gary

Gary

ASE Certified Technician

1,589 satisfied customers

GCM master tech over 25 years

Dave Nova

Dave Nova

GMC Technician

929 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

GMC Technician

675 satisfied customers

16 years of experience

Ron Z.

Ron Z.

- GMC Tech -

285 satisfied customers

18+yrs experience. State Inspector & GMC Diagnostics/Repair

JFN1

JFN1

ASE Certified Technician

272 satisfied customers

GM Master Technician

George H.

George H.

ASE MasterTechnician

230 satisfied customers

15+ Years ASE Master Technician with Level 1 Certification

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x