GMC

GMC Troubleshooting Questions? Ask a Mechanic for Answers

Ask an Expert,
Get an Answer ASAP!

GMC

I have a 2000 gmc sierra 1500 2wd. Transmission went belly

Customer Question
up I replaced it with...
I have a 2000 gmc sierra 1500 2wd. Transmission went belly up I replaced it with a used transmission from junk yard. It matched up perfectly and shifts great but it throwing all kinds of transmission codes. Does ECM need reprograming or transmission wont work.
Submitted: 2 years ago.Category: GMC
Show More
Show Less
Ask Your Own GMC Question
Customer reply replied 2 years ago
its a 2001
Answered in 20 minutes by:
8/12/2015
GMC Mechanic: Gary, ASE Certified Technician replied 2 years ago
Gary
Gary, ASE Certified Technician
Category: GMC
Satisfied Customers: 17,276
Experience: GCM master tech over 25 years
Verified

I am sorry for the long wait

can you tell me the code numbers ?

how does it shift ?

Ask Your Own GMC Question
Customer reply replied 2 years ago
A little hard from 1st to 2nd but not bad. It will be tomarrow before I can get actual code numbers.
GMC Mechanic: Gary, ASE Certified Technician replied 2 years ago

if we know the code numbers we will know exactly which direction to take

does it shift 3rd and into 4th ?

Ask Your Own GMC Question
GMC Mechanic: Gary, ASE Certified Technician replied 2 years ago

ok

let me know the code numbers setting tomorrow and then we will know exactly which way to go with this issue

Ask Your Own GMC Question
Customer reply replied 2 years ago
thanks talk to u tomarrow
GMC Mechanic: Gary, ASE Certified Technician replied 2 years ago

sounds good

Ask Your Own GMC Question
Customer reply replied 2 years ago
po713,po740,po748,po753,po758,po785,po1860
GMC Mechanic: Gary, ASE Certified Technician replied 2 years ago

are you sure the fuse called IGN0 in the fuse in the fuse box is good ?

if that fuse is good does it show 12 volts on both sides of the fuse testing it in place through the little openings in the tops of the fuse ?

Ask Your Own GMC Question
Customer reply replied 2 years ago
Checked all fuses nothing blown. Sunday I'm going to put it back up on stands and inspect wire harness. Do you have any more ideas.
GMC Mechanic: Gary, ASE Certified Technician replied 2 years ago

are you sure the big round connector is plugged in at the passenger side front of the transmission ?

can you see with the key ON if that fuse shows 12 volts ?

if it does then with the key ON see if the pink wire at the transmission big connector shows 12 volts

Ask Your Own GMC Question
Ask Gm Tech (Cam) Your Own Question
Gm Tech (Cam)
Gm Tech (Cam)
Gm Tech (Cam), GMC Mechanic
Category: GMC
Satisfied Customers: 1,696
1,696 Satisfied Customers
Experience: GM Grand Master Technician 2007. 14 year experience.

Gm Tech (Cam) is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Gm Tech (Cam)

Gm Tech (Cam)

GMC Mechanic

1,696 satisfied customers

GM Grand Master Technician 2007. 14 year experience.

Gary

Gary

ASE Certified Technician

17,276 satisfied customers

GCM master tech over 25 years

Dave Nova

Dave Nova

GMC Technician

929 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

GMC Technician

563 satisfied customers

16 years of experience

Ron Z.

Ron Z.

- GMC Tech -

255 satisfied customers

18+yrs experience. State Inspector & GMC Diagnostics/Repair

George H.

George H.

ASE MasterTechnician

225 satisfied customers

15+ Years ASE Master Technician with Level 1 Certification

Don - Mo Lurch

Don - Mo Lurch

ASE Certified Technician

216 satisfied customers

GM, GMC, Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics

< Previous | Next >

Related GMC Questions
2012 3500 delayed voltage output when pressing the pedal.
2012 3500 delayed voltage output when pressing the pedal … read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
563 satisfied customers
I've got an 06 Envoy with the I6. Started having a slow
I've got an 06 Envoy with the I6. Started having a slow cranking issue on the SECOND crank of the day. Will crank fine, normal speed, first crank of the day. I'll drive 15 minutes to work, come out a … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
3,938 satisfied customers
I am trying to remove the engine cover on a 2017 gmc sierra
I am trying to remove the engine cover on a 2017 gmc sierra denali 6.2L ecotec 4wd. There is a bolt or clip holding the back next to the firewall Steve… read more
GM Bob
GM Bob
Automobile Technician
High School or GED
989 satisfied customers
Heavy misfire 2000 gmc 3500 sierra 1st 10 miles this am Aok
heavy misfire 2000 gmc 3500 sierra 1st 10 miles this am Aok then misfire and flashing engine light power progressively going down … read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
05 Z71 code said front airbag sensor right so i changed it
05 Z71 code said front airbag sensor right so i changed it had battery disconnected and the cables clamped together during process hooked everything back up light came back on now code says airbag sen… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
3,938 satisfied customers
2002 GMC SIERRA STARTS GOOD THEN IDLE DROPS SO LOW THAT IT
2002 GMC SIERRA STARTS GOOD THEN IDLE DROPS SO LOW THAT IT USUALLY DIES; WHEN IT DOES DTAY RUNNING, AFTER 15 SECONDS OR SO IT RUNS FINE. … read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
The left turn signal works off and on. When it works both
The left turn signal works off and on. When it works both lights come on. When it doesn't work the blinking is faster and only the front light works. Replacing the rear bulb did not help. … read more
GM Bob
GM Bob
Automobile Technician
High School or GED
989 satisfied customers
No crank no lights in the speedometer and I chech with a
no crank no lights in the speedometer and I chech with a tester I found 8.4 volts in the radiator support help … read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
563 satisfied customers
I have an 06 gmc w/6.6 diesel and would like some
hello, I have an 06 gmc w/6.6 diesel and would like some instruction on the water pump r+r? thanks… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
3,938 satisfied customers
2007 hd2500 driver side heated seated back not working
2007 hd2500 driver side heated seated back not working bottom works any suggestions … read more
fordguy4u
fordguy4u
Automotive Tech
Vocational, Technical or Trade Scho
70 satisfied customers
We changed the pil. 2005 Yukon Denali xl 1500. We changed
We changed the oil pump because the oil pressure alarm … read more
Gary
Gary
ASE Certified Technician
17,276 satisfied customers
My Denali is 2007. I spent alot of money fix the rpm goes
I spent alot of money fix the rpm goes hi suddenly then comes back … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
3,938 satisfied customers
I have a 2003 Yukon. My right turn signal fuse keeps on
Good morning Kevin. I have a 2003 Yukon. My right turn signal fuse keeps on blowing. Have changed the front right turn signal bulb, the rear turn signal bulb, and checked the wiring around the bulbs f… read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
Can't get my lift gate to open. 05 envoy. And tried to
Can't get my lift gate to open JA: What is the model/year of your GM? Customer: 05 envoy JA: Are you fixing your Envoy yourself? What have you tried so far? Customer: Yes and tried to manually unlock … read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
563 satisfied customers
I have a 03 GMC Sierra with factory Bose the plug in the
I have a 03 GMC Sierra with factory Bose the plug in the truck is Cut I need the color codes for the aftermarket plug … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
25 satisfied customers
2008 duramax start truck veins are at 57 and will move up to
2008 duramax start truck veins are at 57 and will move up to 100 cannot get to move below 57 without removing cap on right side of turbo and manually moving the plunger replaced the vgt solenoid and t… read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
563 satisfied customers
1997 GMC Suburban. Crank, but no start. Battery replaced.
1997 GMC Suburban. Crank, but no start. Battery replaced. Distributor cap replaced. Good spark, but no fuel on spark plug. Dropped gas tank and no power to fuel pump. No voltage across pins 87 and 30 … read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
No power to LS door. No horn,chimes or wipers Pluse motor on
No power to LS door. No horn,chimes or wipers Pluse motor on wipers went out,they wouldnt shut off. Replaced with a in line fused toggle switch as a temp (it was raining that day) and ordered pulse mo… read more
Eric
Eric
Retired
N/A
14,436 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x