GMC

GMC troubleshooting questions? Ask a mechanic for answers

Ask an Expert,
Get an Answer ASAP!

Related GMC Questions
2012 GMC 2500HD Duramax diesel engine. Codes P046C, EGR
2012 GMC 2500HD Duramax diesel engine. Codes P046C, EGR position sensor performance and P0403, EGR motor control circuit are present. What should be done next to repair this issue?… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
29,894 satisfied customers
2007 torrent 60,000miles only. plug blew out of No 1
2007 torrent 60,000miles only. plug blew out of No 1 cylinder.disconnected all electrics, backtapped put in helicoil new plug ok. fired up raw gas coming out tailpipe. codes 0202 and 0206. injector pr… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
29,894 satisfied customers
I have a 1997 GMC Safari AWD van, recently I changed the
Hi, I have a 1997 GMC Safari AWD van, recently I changed the catalytic converter and reset the computer to get it inspected. I was told I needed to drive the van about 100 miles before the computer wo… read more
Eric Gardner
Eric Gardner
Fleet Manager
Bachelor's Degree
237 satisfied customers
2007 chevy Silverado 1500 with 5.3L, came in noise. had
2007 chevy Silverado 1500 with 5.3L, came in for lifter noise. had po304 code misfire cyl # ***** replaced lifters all them new puch rods, head head serviced, after repair code still appears and check… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,823 satisfied customers
My 93 cutlass ciera s is throwing trouble code 28 and I 't
my 93 cutlass ciera s is throwing trouble code 28 and I don't know where to start to look as I cannot find any information on this… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,589 satisfied customers
99 Yukon SLT: No continuity, driver's side heated seat
99 Yukon SLT: No continuity, driver's side heated seat element. The fine blue sig-zag wire element itself is okay, but the wire between heating sections is burned in two. The heating elements are sewn… read more
JFN1
JFN1
ASE Certified Technician
Vocational, Technical or Trade Scho
272 satisfied customers
GMC Envoy SLT: 2006 GMC Envoy cylinder 2 misfire. I have traced
2006 GMC Envoy cylinder 2 misfire. I have traced this down and cannot find the cause. I originally had an open injector code on cylinder 2 along with the misfire code on cylinder 2. (0302, 0202). I re… read more
Dan
Dan
Technician
Vocational, Technical or Trade Scho
26,224 satisfied customers
GMC C3500 HD Chas/Cab: I have a GMC 3500 cargo van (2004) with
I have a GMC 3500 cargo van (2004) with 6 liter. I keep having misfire on cylinder 8, code says fuel injector wiring. Have had at shop 3 times. They ran a new wire to #8 injector. Problem comes and go… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
29,894 satisfied customers
GMC Hummer H2: My 2004 Hummer H2 just failed smog because the
My 2004 Hummer H2 just failed smog because the CAN OBD2 port isn't working. Sounds like a silly reason to fail it but so be it. WHAT ARE THE LIKELY CAUSES? HOW DO I TROUBLESHOOT IT? I HAVE HEARD OF ME… read more
Michael Moore
Michael Moore
Team leader, bumper to bumper tech.
Associate Degree
2,870 satisfied customers
GMC K3500 Sierra 4x4: I have a 97 GMC K3500 with a 454. The
I have a 97 GMC K3500 with a 454. The 4WD is intermittent. I replaced the front actuator and the problem persists. I cannot find a condition that exists that would cause the 4WD to be intermittent. Wh… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,589 satisfied customers
GMC: hello i have a 02 sonoma pick up v6 automatic, 2wd, 4.3
hello i have a 02 sonoma pick up v6 automatic, 2wd, 4.3 liter. its blowing the fuse that feds power on the obd2 connector. thanks.… read more
Dan
Dan
Technician
Vocational, Technical or Trade Scho
26,224 satisfied customers
GMC GMC 2500 Hd: Hello, I have an 04 Duramax LLy that I am
Hello, I have an 04 Duramax LLy that I am getting an error code P0202 and P2149. What does that mean? If I understand what I have found on line; they are codes basically saying that the electrical con… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
1,589 satisfied customers
GM yukon: My 1999 Yukon 350 engine has a troubleshooting code
My 1999 Yukon 350 engine has a troubleshooting code of po305. I am told that this is a misfire in cylinder #5............any thoughts?.....The vehicle was tuned up with new wires and plugs and cap/rot… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
1,823 satisfied customers
GMC G2500 Van Vandura: I have 95 GMC Vandura 2500 Rally. I
I have 95 GMC Vandura 2500 Rally. I recently replaced a defective fuel pump. After doing so my "service engine light" came on with the first 3 codes being 12 the next 3, 15. I have replaced the fuel f… read more
Hal
Hal
owner/service tech
Vocational, Technical or Trade Scho
925 satisfied customers
GMC Sonoma Pickup: Air intake, Distributor cap, fuel. Whats
Air intake, Distributor cap, fuel. Whats my problem? My 1996 GMC Sonoma wouldn't start. I brought it to my mechanic, he said that the MAF valve was bad. So he replaced it. He also mentioned that the c… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,489 satisfied customers
GMC Yukon: 2007 gmc yukon 5.3l engine miss firing on #5 cyclinder
2007 gmc yukon 5.3l engine miss firing on #5 cyclinder i have done a tune up,changed coil pack and injector checked the fire and injector with testers they were fine has 165psi on all cyclinders spray… read more
Canadafix
Canadafix
Auto shop owner
Vocational, Technical or Trade Scho
1,507 satisfied customers
GMC s-15: have new injector in , getting fuel to injector but
have new injector in , getting fuel to injector but no further than that,eveything is hooked up right ,butcan not figure out why injector isn't working ?… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
29,894 satisfied customers
GM Sierra I have a 96 gmc pickup and the check engine light
I have a 96 gmc pickup and the check engine light doesnt work. I have replaced the entire cluster board and replaced the bulb. It doesnt even come on with the key on, truck not running. What is the ne… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,323 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Gm Tech (Cam)

Gm Tech (Cam)

GMC Mechanic

1,823 satisfied customers

GM Grand Master Technician 2007. 14 year experience.

Gary

Gary

ASE Certified Technician

1,589 satisfied customers

GCM master tech over 25 years

Dave Nova

Dave Nova

GMC Technician

929 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

GMC Technician

675 satisfied customers

16 years of experience

Ron Z.

Ron Z.

- GMC Tech -

285 satisfied customers

18+yrs experience. State Inspector & GMC Diagnostics/Repair

JFN1

JFN1

ASE Certified Technician

272 satisfied customers

GM Master Technician

George H.

George H.

ASE MasterTechnician

230 satisfied customers

15+ Years ASE Master Technician with Level 1 Certification

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x