GMC

GMC troubleshooting questions? Ask a mechanic for answers

Connect one-on-one with {0} who will answer your question

Related GMC Questions
1994 gmail z71 4x4 5.7 v8 starts good idles good and runs
1994 gmail z71 4x4 5.7 v8 starts good idles good and runs good at first but if you put any kind of load on it or if you are going up hill it tries to die and when you give it gas it backfires. If it d… read more
JimwF
JimwF
Automotive Technologies Instructor
Some College
534 satisfied customers
GMC Sierra 5.3 Sl 2002, truck starts, idles fine for 5-8
GMC Sierra 5.3 Sl 2002, truck starts, idles fine for 5-8 seconds than idles rough, and turns off. i was able to keep it idling longer by pressing gas pedal. I press gas and it continues idling rough, … read more
Mike V.
Mike V.
technician
Subaru and Nissan factory training.
32,829 satisfied customers
1998 GMC Van. Had fuel pump replaced as van would run a mile
1998 GMC Van. Had fuel pump replaced as van would run a mile or so then stop. After fuel pump replaced, drove car about 200 miles. Then van would stop. Took it to a mechanic. He replaced the theft sto… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
13,038 satisfied customers
1998 GMC Sierra 1500 4x4 5.7L automatic. L0171 lean bank And
1998 GMC Sierra 1500 4x4 5.7L automatic. L0171 lean bank And L0174 lean bank codes as well as L0404 EGR Failure. No apparent vacuum leaks. Intake Manifold gasket replaced in the past. 160,000 miles of… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
23,051 satisfied customers
Gmc Yukon Denali: My 2004 Yukon Denali act if it's trying to
My 2004 Yukon Denali act if it's trying to shut off while driving sometimes. I have replaced the throttle body and the wiring harness but the idle still sticks periodically. When I come to a stop it s… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
2,126 satisfied customers
GMC Envoy SLT: 2006 envoy slt throwing code p0171. adding 29%
2006 envoy slt throwing code p0171. adding 29% fuel and idling bad on cold start up. after badly running for the first few minutes the motor will snap to running perfect and not have any issues after.… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,999 satisfied customers
Hey. As it says I have a 2000 GMC Savana 3500 5.7L V8. From
Hey. As it says I have a 2000 GMC Savana 3500 5.7L V8. From time to time it runs very rough where it shakes the whole van and has no power. Here is what I have done so far: Replaced spark plugs, wires… read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
904 satisfied customers
Good day, Got a 2002 GMC Savana 2500 Cargo Van 5.7L V8. Service
Good day, Got a 2002 GMC Savana 2500 Cargo Van 5.7L V8. Service Engine light is on. Scanned it and got the following codes: P0102 (Mass Air Flow Circuit A Low); P0443 (Evaporative Emmission System Pur… read more
Chris (aka-Moose)
Chris (aka-Moose)
GMC Technician
Vocational, Technical or Trade School
904 satisfied customers
GMC Yukon SLT: 1999 GMC Yukon 2WD 5.7l - warm engine, full
1999 GMC Yukon 2WD 5.7l - warm engine, full throttle acceleration from rolling start, good to 4k+ rpm, shifts up fine, makes 70mph +/-, then starts shaking and sputtering, back off throttle to idle an… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
36,558 satisfied customers
I have a 05 duramax that wont shift into the higher gears if
I have a 05 duramax that wont shift into the higher gears if I accelerate to quickly. The RPMs will increase, but it wont make the upshift, keeping me at 80/100 km.… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
2,126 satisfied customers
GMC Sierra 1500 Classic SLT: i installed a k&n cold air intake
i installed a k&n cold air intake on my 09 gmc 5.3 now i get codes saying i'm to lean. is there to fool the MAF sensor or is there another one i can install.… read more
Gary
Gary
ASE Certified Technician
18,052 satisfied customers
GM sierra: I have 6 codes on my 6.6 duramax 2004 GMC 1-ton
I have 6 codes on my 6.6 duramax 2004 GMC 1-ton DTC P0101 "" P0234 "" P0380 "" Po621 U1152 U1024 engine emmits grey-black smoke excessively I had injector recall work done 29,000 miles ago… read more
Canuck Tech
Canuck Tech
Associate
501 satisfied customers
gmc sierra: I have a 2000 gmc 1500 5.3 167,000 miles. I have
I have a 2000 gmc 1500 5.3 167,000 miles. I have a problem with it stumbling mostly after a restart: Ex: runs fine when first started in morning, but if you go for a short drive shut if off then start… read more
Canuck Tech
Canuck Tech
Associate
501 satisfied customers
GMC Jimmy 4x4 (Mid Size): I have a 1999 GMC Jimmy 4.3 that
I have a 1999 GMC Jimmy 4.3 that has recently begun having a seriously rough idle during the cold mornings (I'm in Massachusetts). We replaced the following prior to this happening (a while before it … read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
GMC Sierra 1500 Classic SLT: I have a 2005 gmc sierra and I
I have a 2005 gmc sierra and I cant control the temp on the drivers side. It constantly blows hot ass air while the passenger side is cold. This doesnt happen all the time but more than desired. Can t… read more
proautotech
proautotech
Shop Foreman
1,144 satisfied customers
GM Savana 1500: my 1997 gmc savana 1500 with 5.7 vortec engine
my 1997 gmc savana 1500 with 5.7 vortec engine stalls,while driving,just cuts off,no check engine light,i replaced fuel filter and i use chevron premium fuel only.and usually starts right up,and ,when… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,999 satisfied customers
GMC: 2006 1500 sierra throwing codes co245 and po172 and 175
2006 1500 sierra throwing codes co245 and po172 and 175 and fuel economy is terrible do i need to change the wheel speed sensor?… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,999 satisfied customers
GMC savana 3500: i have a 2005 gmc savana box van with the
i have a 2005 gmc savana box van with the 6.0 and automatic, it was throwing codes for heated o2 senser resistance and it intermitently has idling problems yet all 4 o2 sensers have been replaced, Any… read more
Dave Nova
Dave Nova
GMC Technician
Associate Degree
929 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Gm Tech (Cam)

Gm Tech (Cam)

GMC Mechanic

2,126 satisfied customers

GM Grand Master Technician 2007. 14 year experience.

Gary

Gary

ASE Certified Technician

18,052 satisfied customers

GCM master tech over 25 years

Dave Nova

Dave Nova

GMC Technician

929 satisfied customers

ASE Master Certification. GM World Class Certification

Chris (aka-Moose)

Chris (aka-Moose)

GMC Technician

904 satisfied customers

24 years of experience diagnosing & repairing

JFN1

JFN1

ASE Certified Technician

272 satisfied customers

GM Master Technician

Mike S.

Mike S.

ASE Certified Technician

256 satisfied customers

GMC N.A.I.S.E. Certified Auto-Mechanic

George H.

George H.

ASE MasterTechnician

233 satisfied customers

15+ Years ASE Master Technician with Level 1 Certification

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x