Connect one-on-one with a GMC mechanic who will answer your question
Expert avatar
Gm Tech (Cam), GMC Mechanic
2,007 satisfied customers
GM Grand Master Technician 2007. 14 year experience.
Pearl avatarSteve Pearl, Assistant
GMC Mechanic is Online Now

Have GMC troubleshooting questions?

Verified GMC mechanics are online around the clock and ready to answer your question online or by phone. 
Related GMC questions
I have 1998 gmc Savannah sac cut box truc 5.7 Truck starts
I have 1998 gmc Savannah sac cut box truc 5.7 Truck starts fine was skipping little on low idle Through a crank code so went to change. Stuck new one in didn't start. Stuck old one back in started fin… read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
15,313 satisfied customers
Engine idles well when in park but misses and runs
Engine idles well when in park but misses and runs irradically when you put it in Drive. … read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
2,007 satisfied customers
Have a thump noise in the rear when you make a complete stop
have a thump noise in the rear when you make a complete stop on a 2011 GMC 1500 … read more
Edgardo Soto
Edgardo Soto
56 satisfied customers
2003 gmc envoy brake lights dont work. Fuse under hood is
okay 2003 gmc envoy brake lights dont work. Fuse under hood is fine, new switch on pedal, fuse under left passenger seat keeps blowing, i replace both rear light boards, and its still blowing fuse und… read more
DavidG
DavidG
ASE Certified Master Auto Technician
117 satisfied customers
My driver side front headlight continues to get moisture in
My driver side front headlight continues to get moisture in it. Today I took a blow dryer and dried it out but I just went outside and moisture is back in it again! I have everything sealed right. Wha… read more
Keiphun Sowell
Keiphun Sowell
AutoDiesel Technology
417 satisfied customers
I need to know what wire color codes are for my radio wiring
I need to know what wire color codes are for my radio wiring system on a 2006 gmc serria sle … read more
Don - Mo Lurch
Don - Mo Lurch
ASE Certified Technician
Vocational, Technical or Trade Scho
261 satisfied customers
Replaced lifters and just looking up torque specs and angle
Replaced lifters and just looking up torque specs and angle degrees … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
20,931 satisfied customers
Ls1 gmc 1500 with 250000 miles. Runs good until a/c is
Ls1 gmc 1500 with 250000 miles. Runs good until a/c is turned on. Idles rough and starts throwing different codes and gas leaks from under intake … read more
Marc
Marc
Mechanic
Associate Degree
1,158 satisfied customers
2003 GMC Yukon Denali with check engine light on. I have a
2003 GMC Yukon Denali with check engine light on. I have a code reader and have the following codes. I am wondering what parts I should purchase and replace.P0068 Manifold absolute pressure MAF sensor… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
2,007 satisfied customers
Will not start. Cleaned them all. 2011 gmc terrain. I
will not start JA: Have you checked the battery, particularly the terminal connections? Are they corroded? Customer: cleaned them all JA: What is the model/year of your GMC? Customer: 2011 gmc terrain… read more
Gm Tech (Cam)
Gm Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
2,007 satisfied customers
What could be wrong with my 2002 GMC envoy it would not
What could be wrong with my 2002 GMC envoy it would not start from the Ignition but I can jump it from the starter but I do not have in its signal luck … read more
Expert
Expert
6,955 satisfied customers
2014 GMC Acadia 3.6 Denali. Engine misfire of cylinder 3
2014 GMC Acadia 3.6 Denali. Engine misfire of cylinder 3 with low RPM's and low power pull. Vehicle jerks for a few seconds before switching to a higher gear. Fuel pressure is between 55-61 while driv… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
10,565 satisfied customers
I have a 1985 gmc sierra classic with a 305 i put a new
I have a 1985 gmc sierra classic with a 305 i put a new distributor its a hei coil on top and i need to know how to set the timing it doesnt have a vaccum advance it has 4 wires going to the ecm do i … read more
Bradley Jordan
Bradley Jordan
Retired
diploma
377 satisfied customers
Brake pedal goes to the floor no sign of leaks and fluid is
brake pedal goes to the floor no sign of leaks and fluid is full … read more
Clifton B.
Clifton B.
nissan master auto tech
Associate Degree
5,127 satisfied customers
I have a 2007 gmc serria and the crankshaft sencer was
I have a 2007 gmc serria and the crankshaft sencer was replaced and the code came back. Whats next? … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,808 satisfied customers
Neither of my windows will go down no motor noise so probaly
neither of my windows will go down no motor noise so probaly fude … read more
J Hall
J Hall
retired
none
542 satisfied customers
2003 GMC Sierra 2500 HD, 4wd C0201, open and short master
2003 GMC Sierra 2500 HD, 4wdC0201 , open and short master cylinder pressure sensor U1300, Class to shorted to ground / voltageCommon cause?… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
20,931 satisfied customers
Sound of no compression. 2005 GMC Canyon 2.8l 4 cyl. I Live
i Live in rural Alaska. I am working on it myself. … read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
15,313 satisfied customers

Common GMC questions resolved on JustAnswer


To get the best results from your question, you'll need to make sure you have the important information ready for the Expert. It's a good idea to make note of any details, so you don’t forget anything important in the moment.


The information that you need to gather should include:


  • The make, model, and year of your vehicle
  • The owner’s manual for your vehicle
  • A detailed description of the symptoms, including sounds, smells, leaks, or other visible signs of damage
  • The situation when the symptoms occur
  • How often or consistently they occur
  • Any recent related repairs

With this information, an automotive expert should be able to identify any GMC problems you have, and help you decide how to address them.