GM

GM repair problems? Ask a GM repair expert now.

Connect one-on-one with {0} who will answer your question

Related GM Questions
2003 h2 hummer w whipple chsrger,110000 miles uses 1qt oil
2003 h2 hummer w whipple chsrger,110000 miles uses 1qt oil /3000, whenever quickly let off throttle, shows po101 or po300 . Changed Maf twice, clean air filter,. Seems to clear code after 4 ,5 restart… read more
Larry Schmidt
Larry Schmidt
21 satisfied customers
I have an 2007.5 lmm duramax, it blew a code for a throttle
I have an 2007.5 lmm duramax, it blew a code for a throttle positioning sensor which on my truck was the entire pedal, meanwhile it is on low engine power mode. I replace the pedal and I'm assuming th… read more
Chris (aka- Moose)
Chris (aka- Moose)
GMC Technician
Vocational, Technical or Trade School
308 satisfied customers
Pearl, JA: Sometimes things that you think will be really
I have a 2007 Yukon XL with the 5.3L Flex Fuel engine with AFM. It's 10 years old this May, and has 205,000 miles. This engine has always been an oil burner, and I've solved ignition problems before by changing fouled plugs (usually #6). This time is different. The problem started abruptly at highway speed and three hours into a 4-hour drive. The Check Engine light came on. The DIC now complains about traction control. And the scan tool shows a #4 misfire code.I've think I'm only getting an occasional spark on #4. In my troubleshooting, I discovered and replaced a fouled #4 plug that was very wet with fuel. I've replaced the plug wires, the #4 ignition coil pack, and even the right-bank wiring harness that feeds the coil packs. I also inspected/replaced all four O2 sensors (the right, pre-converter one was sooty). I've concluded that the injector and valves seem to be operating, since I'm getting smoky exhaust and the smell of incomplete fuel burn. I've put an (antique) inductive timing light on the spark plug wires, and can see that #4, while it does produce an occasional strobe it flashes a helluva lot less than the other wires.Does anybody have any suggestions on how I can further troubleshoot what I think is an ignition problem? Could the computer malfunction in such a way that it stops sending ignition pulses to only one cylinder? Could my symptoms be caused by an AFM malfunction, a faulty valve seal or spring? A rounded out cam? Another compression problem like a broken ring or cracked head? … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
21,163 satisfied customers
Hello Dave, I am replacing the tps on my 08 silverado. Once
Hello Dave, I am replacing the tps on my 08 silverado. Once I replace, should I just disconnect the battery for the sensor to calibrate or do I need a scan tool?… read more
Eric
Eric
Retired
N/A
40,490 satisfied customers
GM sierra: I have a 2009 GMCsierra with a 6.2L, I'm having
I have a 2009 GMCsierra with a 6.2L, I'm having an issue with my stabilitrak, reduced engine power, and traction control. I have read that is is common occurance with GM vehicles of this year and that… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,563 satisfied customers
GM Avalanche: I have a 2004 Chevy Avalanche with the dreded
I have a 2004 Chevy Avalanche with the dreded reduced engine power. I've replaced the acc position sensor, map sensor, throttle body, throttle body harness, tac module, and 16 pin harness to tac modul… read more
Jim
Jim
Vocational, Technical or Trade Scho
1,848 satisfied customers
GM Acadia Error: "Stabilitrak system off. Service brake system"
I get this error message: "Stabilitrak system off..Service brake system " also, the red emergency brake light comes..and yellow traction light comes on. What does this mean? Is it dangerous to drive? … read more
mcleodagency
mcleodagency
Associate Degree
276 satisfied customers
GM Yukon: We recently purchased a 2004 Yukon SLT and are having
We recently purchased a 2004 Yukon SLT and are having problems with the AC. I could be driving along with the AC on and then all of a sudden the AC on the drivers side only will turn extremely hot. If… read more
Dave Nova
Dave Nova
Auto Dealership Owner
Associate Degree
18,417 satisfied customers
Reduced Engine Power or limp mode..30 seconds..restarting
I have a 2003 1500HD (191k miles) going into "Reduced Engine Power" or limp mode. I can always restore it by turning off the engine for 30 seconds and restarting. I have read alot about this issue wit… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
31,642 satisfied customers
2006 envoy denali: rate of 1 quart every 1500 miles..start until
I own 2006 envoy denali with 72,000 miles. It is using oil at the rate of 1 quart every 1500 miles. The problem did not start until around 65,000 miles. I have changed the oil every 3000 miles since i… read more
GMC Tech
GMC Tech
SERVICE TECHNICIAN
Associate Degree
369 satisfied customers
Sierra: drove..the dash light came on and said engine oil low..leaks
I have a gmc siarra 2007 z71 v-8 started usig lot of oil not sure why changed it put synthetic in it and drove it but after 800 miles the dash light came on and said engine oil low checked it didnt ev… read more
John
John
MASTER AUTOMOTIVE TECHNICIAN
2 YEARS COLLEGE
9,106 satisfied customers
GMC Envoy: light comes..service engine soon..I need to accelerate
I am going crazy with my GMC Envoy!!! I've had it for 3 yrs now and whenever its cold out,the reduced engine power light comes on (&the service engine soon also);Letting it run for 15 mins or so befor… read more
Triston
Triston
High School or GED
1,619 satisfied customers
2008 GMC Sierra 1500: liter engine..surges..a hard wind is blowing
I have a 2008 GMC Sierra 1500 with 6 liter engine. When you are going between 55 to 70 the truck surges. It feel like a hard wind is blowing against you. If you accelerate or slow down it quits. Deale… read more
Amedee
Amedee
GMC Technician
Vocational, Technical or Trade Scho
541 satisfied customers
2007 Yukon Denali XL..6.2L Noticed blue smoke on start up
2007 Yukon Denali XL..6.2L Noticed blue smoke on start up a couple months ago. got worse and then went away overnight. Oil consumption..low oil light followed an oil change and about 1000 miles..chang… read more
Dave Nova
Dave Nova
Auto Dealership Owner
Associate Degree
18,417 satisfied customers
2002 Chevy Trailblazer: 000 miles..idles..vibration..steering wheel
I have a 2002 Chevy Trailblazer with 123,000 miles and 6 cylinders. The motor runs really smooth with no problems at all as well as no check engine lights on or trouble codes found. The problem is whe… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
31,642 satisfied customers
2006 corvette: vin..traveling up an incline at a low speed..rear axle
I own a 2006 Corvette VIn:1G1YY36u165131059 For the last 4-5 months, when accelerating or I am traveling up an incline at a low speed, on occasion there is a noticeable lag between my acceleration of … read more
Anthony
Anthony
GMC Technician
Vocational, Technical or Trade Scho
489 satisfied customers
2003 GMC: passenger..van..intake manifold..the wrong spark plugs
Our church owns a 2003 GMC passenger van with 40,000mi. The intake manifold was bad and I understand that it can be due to the wrong spark plugs, having been having been upgraded or changed several ti… read more
mcgruder73
mcgruder73
Auto Technician
Associate Degree
Sierra: a question regarding error code multiple cylinder misfire
Had a question regarding error code "multiple cylinder misfire" on my 2005 4.3 GMC Sierra. It has 50,000 and I've been having this message for 2 or 3 weeks. I've changed plugs, wires, cap, and button … read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

31,642 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

1,563 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

308 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

204 satisfied customers

ASE Master Tech 20+ Years

Amedee

Amedee

GMC Technician

541 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x