GM

GM repair problems? Ask a GM repair expert now.

Connect one-on-one with {0} who will answer your question

Related GM Questions
My rely for fuel pump is where it's suposto be any ideas,
My rely for fuel pump is where it's suposto be any ideas … read more
Juan Crespo
Juan Crespo
Sr. Technician
Bachelor's Degree
1,262 satisfied customers
Pearl, JA: Sometimes things that you think will be really
I have a 2007 Yukon XL with the 5.3L Flex Fuel engine with AFM. It's 10 years old this May, and has 205,000 miles. This engine has always been an oil burner, and I've solved ignition problems before by changing fouled plugs (usually #6). This time is different. The problem started abruptly at highway speed and three hours into a 4-hour drive. The Check Engine light came on. The DIC now complains about traction control. And the scan tool shows a #4 misfire code.I've think I'm only getting an occasional spark on #4. In my troubleshooting, I discovered and replaced a fouled #4 plug that was very wet with fuel. I've replaced the plug wires, the #4 ignition coil pack, and even the right-bank wiring harness that feeds the coil packs. I also inspected/replaced all four O2 sensors (the right, pre-converter one was sooty). I've concluded that the injector and valves seem to be operating, since I'm getting smoky exhaust and the smell of incomplete fuel burn. I've put an (antique) inductive timing light on the spark plug wires, and can see that #4, while it does produce an occasional strobe it flashes a helluva lot less than the other wires.Does anybody have any suggestions on how I can further troubleshoot what I think is an ignition problem? Could the computer malfunction in such a way that it stops sending ignition pulses to only one cylinder? Could my symptoms be caused by an AFM malfunction, a faulty valve seal or spring? A rounded out cam? Another compression problem like a broken ring or cracked head? … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
19,905 satisfied customers
Concerning active fuel management lifters, You have stated
Hello Gary, Concerning active fuel management lifters, You have stated that installing them backwards can cause a misfire on start up. Can you please give more details on this, any pics, experiences o… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade School
2,589 satisfied customers
GM Sierra: 2003 GMC Sierra 2500 SLE. Driving along and the
2003 GMC Sierra 2500 SLE. Driving along and the oil pressure gauge will Jim from 80 to 0. And then low oil pressure indicator on the dash flashes. Check engine light came on. So we pulled it off the h… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,563 satisfied customers
GM ESCALADE: 2007 Escalade burning oil. litre per 2000 km. No
2007 Escalade burning oil. litre per 2000 km. No oil leaks. Is there a way to know whether it's valve stem seals or rings without tearing the engine apart? Jonathon… read more
Randy
Randy
619 satisfied customers
GM envoy denali: I have a 2007 Denali bought from dealership
I have a 2007 Denali bought from dealership in 2009 with 28k miles. I am vigilant with maintenance and oil changes. Truck oil pressure went down said turn off engine. Towed to dealership they are sayi… read more
Jerry Newton
Jerry Newton
Vocational, Technical or Trade Scho
5,411 satisfied customers
GM sierra: I wanted to know if a 2009 truck with a 5.3l with
I wanted to know if a 2009 truck with a 5.3l with active fuel management will not have a dic panel on the dash. Thank you Frank… read more
Daniel
Daniel
Lead mech
Some college
5,053 satisfied customers
GM Sierra 5.3: 2009 GMC Sierra 5.3- I recently took my truck
2009 GMC Sierra 5.3- I recently took my truck to the shop to have the engine rebuilt. At 120K miles the engine light came on. the GMC dealer diagnosed it as bad lifters and/or cam. So decided to have … read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,678 satisfied customers
GM 2500 HD: We have a 2008 Chevy 2500 HD. Every 400 miles or
We have a 2008 Chevy 2500 HD. Every 400 miles or so we experience reduced engine power. We have replaced the GM throttle motor. Appears to have new APPS. It has a new pig tail to the throttle motor. T… read more
Hal
Hal
owner/service tech
Vocational, Technical or Trade Scho
925 satisfied customers
gmc sierra 1500: 10 min..while, it makes a ticking noise..hood..temps
I have a gmc sierra 1500 that after driving for 10 min in the morning or when its been sitting for a while, it makes a ticking noise. Noise is coming from under the hood. But if i am starting up the v… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
2008 chevy suburban: started the no 1 cyl goes dead..injector..coil
I have a 2008 Chevy surburbon after it is started the no 1 cyl goes dead ,i checked spak plug,injector and coil. But it appears as if the intake valve stops opening what can cause this?… read more
Michael Moore
Michael Moore
Team leader, bumper to bumper tech.
Associate Degree
2,871 satisfied customers
GM sierra My 2009 GMC Sierra has a fluctuating oil pressure
My 2009 GMC Sierra has a fluctuating oil pressure down 20 at idle, increases as truck increases speed. Also whole sitting at idle there's a "thud" in the engine almost like a cylinder is miss firing. … read more
Jerry Newton
Jerry Newton
Vocational, Technical or Trade Scho
5,411 satisfied customers
my 2005 chevy1500 5.3engine..squilling and slight ticking..belts
my 2005 chevy1500 5.3engine is making a squilling and slight ticking inside the motor i pulled the belts to make sure the engine has 97400.o miles… read more
Michael Moore
Michael Moore
Team leader, bumper to bumper tech.
Associate Degree
2,871 satisfied customers
2006 envoy denali: rate of 1 quart every 1500 miles..start until
I own 2006 envoy denali with 72,000 miles. It is using oil at the rate of 1 quart every 1500 miles. The problem did not start until around 65,000 miles. I have changed the oil every 3000 miles since i… read more
GMC Tech
GMC Tech
SERVICE TECHNICIAN
Associate Degree
369 satisfied customers
GM 5.3L 2007 cast iron block #6 cylinder (lifter noise,) also,
GM 5.3L 2007 cast iron block #6 cylinder (lifter noise,) also, the truck vibrates at 70 MPH when in V4 mode. At 40 MPH the vibration (is very noticable,) but less frequent because the engine does not … read more
John
John
MASTER AUTOMOTIVE TECHNICIAN
2 YEARS COLLEGE
9,106 satisfied customers
I have a 2009 GMC Sierra 1500 XCab 4 speed auto with active
I have a 2009 GMC Sierra 1500 XCab 4 speed auto with active fuel management. With a back ground so I fully understand the principles of the internal combustion, engine etc. I would like to know the sp… read more
Dave Nova
Dave Nova
Auto Dealership Owner
Associate Degree
18,417 satisfied customers
gm: 3 of 6 cylinders dropping out for fuel savings and is it smart
I have a gm 3.9ffa how does it work internaly regarding 3 of 6 cylinders dropping out for fuel savings and is it smart to run e85 fuel… read more
goodwrench9124
goodwrench9124
Lead Tech/ Shop Leader
Vocational, Technical or Trade Scho
3,392 satisfied customers
2007 GMC Yukon: 5.3l..qts..trouble code for low oil
Hi, I have a 2007 GMC Yukon with a 5.3l that has excessive oil consumption. In 3000 miles it will use 1.5 qts. Then will turn on trouble code for low oil. At 5000 miles I will have had to add 2.5 qts.… read more
GM_MASTER_DENNY
GM_MASTER_DENNY
Shop Foreman
High School or GED
177 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

5,872 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

1,563 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

279 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

187 satisfied customers

ASE Master Tech 20+ Years

Amedee

Amedee

GMC Technician

504 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x